• A closed gaseous system undergoes a reversible process in which 153 kJ of heat are rejected and the volume changes from 0.55 m³ to 0.14 m³. The pressure is constant at 150 kPa. Determine the work nonflow.

• A closed gaseous system undergoes a reversible process in which 153 kJ of heat are rejected and the volume changes from 0.55 m³ to 0.14 m³. The pressure is constant at 150 kPa. Determine the work nonflow.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter15: Thermodynamics

Section: Chapter Questions

Problem 11CQ: We ordinarily say that U=0 for an isothermal process. Does this assume no phase change takes place?...

See similar textbooks

Related questions

Q: A sample of blood plasma occupies 0.599 L at 0°C and 1.03 bar, and is compressed isothermally by…

A: Given Vi=0.559 L external pressure (Pext)=95.2 bar Compression =0.57% Required work done

Q: In the absence of any friction and other irreversibilities, can a heat engine have an efficiency of…

A: Operation of a heat engine is depends on the fact that the temperature of sink should be low and…

Q: Calculate the heat transfer, in Btu/lbm, for the reversible process 1-3 shown in Fig. P8–45E.

Q: 220 kJ of heat is transferred from a reservoir at 450 C to a reservoir at 700 C. Show that whether…

A: Given that 220 kJ of heat is transferred from a reservoir at 450 C to a reservoir at 700 C. Then We…

Q: You sampled 20 m^3 of air on a hot summer day when the temperature was 35 degrees C, and the…

A: Solution: 760mm of Hg is equal to 1 atmospheric pressure. Calculate the volume of air at STP.…

Q: 76. Heat Q fl ows spontaneously from a reservoir at 394 K into a reservoir at 298 K. Because of the…

A: The expression for calculate unavailable work is W=T-QTh+QTcQ=WT-1Th+1Tc

Q: From what height should be dumped a body with mass of 3 kg, so that the amount of heat given off,…

Q: The energy output of a heat pump is greater than the energy used to operate the pump. Why doesn’t…

Q: In a constant-volume process, 214 J of energy is transferred by heat to 1.10 mol of an ideal…

A: (a) According to the thermodynamics law, the work done on the gas is, W=∫PdV At constant volume…

Q: if 1 mol of gas are expanded isothermally and reversibly from 150 KPa to 100 KPa at 25 C°. calculate…

Q: GIve one ecample of each type of ideal process in thermodynamics.

A: Solution

Q: Justify the second Law of thermodynamics

A: Explanation: The limitation of the first law of thermodynamics is that it does not say anything…

Q: Distinguish between quasi-static and non-quasi-static processes?

A: The quasi static process is a thermodynamic process, and it occurs slowly enough for the system to…

Q: 1 mole of an ideal gas with a volume of 10^-2m^-3 and a temperature of 290K compressed its volume to…

Q: Consider the steady adiabatic flow of an incompressible fluid. Can the temperature of the fluid…

Q: energy of cycle comprising four process in which the heat transfers are: 60 kJ/kg, -28 kJ/kg, -35…

A: First law states that the algebraic sum of work and heat tranfers in a cyclic process will be equal.…

Q: Differentiate between Quasi-static and Non-quasi-static Processes?

Q: Suppose the volume of an ideal gas is doubled while the pressure is reduced by half. Does the…

A: Initially, equation of state is,

Q: 77. ssm Find the change in entropy of the H,O molecules when (a) three kilograms of ice melts into…

A: Gien data The temperature of the water is T1 =273 K The temperature of the steam is T2 =373 K The…

Q: consider a cyclic heat engine consisting of one mole of a monoatomic ideal gas (y=5/3)

A: Given;- consider a cyclic heat engine consisting of one mole of a monoatomic ideal gas (y=5/3)…

Q: Unreasonable Results - What is wrong with the claim that a cyclical heat engine does 4.00 kJ of work…

A: The net transfer of heat to the environment is, ∆Q=Qin+Qout=24.0 kJ-16.0 kJ=8.0 kJ

Q: It takes 275 J of work to compress quasi-statically 0.60 mol of an ideal gas to one-seventh its…

A: Given:- The work to compress quasi-statically W = 275 J The mol of gas n = 0.60 An ideal gas to…

Q: Two identical gases undergo an expansion, one isothermal and the other adiabatic. Both start at the…

A: The work done is greater in case of adiabatic process.

Q: ideal gas is compressed isothermally from 2.00atm to 90.0atm. At 40°C, three moles reacted with…

A: For isothermal process temperature of the system remains constant. T = constant

Q: An ideal gas ( = 1.4) Volume 2 m3 and if is compressed to 4x106 Pa adiabatic at Volume 0.5 m3.…

A: Given : Adiabatic constant, γ = 1.4P1 = 4×106 N/m2 V1 = 2 m3 V2 = 0.5 m3

Q: Please help me with all the parts of this question, please also double check your answers as…

Q: Differentiate between the reversible and irreversible process in thermodynamics.

A: Reversible processes are slow processes contains a series of stages and in stage the thermodynamic…

Q: What is the change in the internal energy of the system if 400 J of heat is added to the system and…

A: Heat added to system = 400 Joules Work done by the system = 2300 Joules

Q: -What is the change in internal energy of a system which does 3.5 x 10^5 J of work while 3.00×10^6 J…

A: Given data The work done by the system is W = 3.5 x 105 J. The heat transferred to the system is…

Q: An inventor claims to have built an engine that produces 2.00 MW of usable work while taking in 3.00…

A: Solution:Here the actual efficiency will be:Y = WθH =23 = 0.67…

Q: Does the cyclic integral of heat have to be zero (i.e., does a system have to reject as much heat as…

A: No, during the cycle process, a system can reject more or less heat absorbed by the system to…

Q: What is the change in the internal energy of the system if 4000 J of heat is added to the system and…

A: Given Heat added Q=4000J Work done W=2300J

Q: A system gains 1500 J of heat, while the internal energy of the system increases by 4500 J and the…

A: Introduction Given data:- dQ = +1500 J dU = + 4500 J…

Q: Is a process that is internally reversible and adiabatic necessarily isentropic? Explain.

A: The process is called to be isentropic in which the entropy remains unchanged. During internally…

Q: A real process may be nearly adiabatic if it occurs over a very short time. How does the short time…

Q: Consider an isothermal process. If the heat flows 10.0 J from the system, find the change of…

Q: A cyclic thermodynamic process for an ideal gas has gone through four steps. The amount of heat…

A: we know that Q = U + W

Q: Is it impossible to convert the heat from a single source into work without any other effect? How?

A: According to the Kelvin statement in the second law of thermodynamics , it is not possible to…

Question

solve

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In a very mild winter climate, a heat pump has heat transfer from an environment at 5.00C to one at 35.0C. What is the best possible coefficient of performance for these temperatures? Explicitly show how you follow the steps in the Problem-Solving Strategies for Thermodynamics.
We ordinarily say that U=0 for an isothermal process. Does this assume no phase change takes place? Explain your answer.
There is no change in the internal of an ideal gas undergoing an isothermal process since the internal energy depends only on the temperature. Is it therefore correct to say that an isothermal process is the same as an adiabatic process for an ideal gas? Explain your answer. `
What is the change in entropy in an adiabatic process? Does this imply that adiabatic processes are reversible? Can a process be precisely adiabatic for a macroscopic system?
A great deal of effort time, and money has been spent in the quest for the so-called perpetual-motion machine, which is defined as a hypothetical machine that operates or produces useful work indefinitely and/or a hypothetical machine that produces more work or energy than it consumes. Explain, in terms of heat engines and the first law of thermodynamics, why or why not such a machine is likely to be constructed.
The temperature of a rapidly expanding gas decreases. Explain why in terms of the first law of thermodynamics. (Hint: Consider whether the gas does work and whether heat transfer occurs rapidly into the gas through conduction.)
A cylinder containing three moles of nitrogen gas is heated at a constant pressure of 2 atm. The temperature of the gas changes from 300 K to 350 K as a result of the expansion. Find work done (a) on gas, and (b) by the gas by using van der Waals equation of state instead of ideal gas law.
An ideal diatomic gas at 80 K is slowly compressed adiabatically and reversibly to twice its volume. What is its final temperature?
Compare the charge in internal energy of an ideal gas for a quasi-static adiabatic expansion with that for a quasi-static isothermal expansion. What happens to the temperature of an ideal gas in an adiabatic expansion?
Determine the heat transfer, in kJ/kg, for the reversible process 1-3 shown in Fig. P8–44.
Distinguish between quasi-static and non-quasi-static processes?
Heat always flows spontaneously from an object with a higher temperature to an object with a lower temperature. Is this the same thing as saying that heat always flows from an object with a greater internal energy to one with a lower internal energy? Explain.