Answered: A coil of inductance 1 henry and…

A coil of inductance 1 henry and negligible resistance is connected in series with a capacitance of 4x10-6 farad, and an emf of E = 200 volts. When t = 0,Q = 0, and I = 0. Find Q and I at any time t.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 6STP

See similar textbooks

Related questions

Q: An inductor of inductance 6.0H and resistance 640 ohms is connected in series to two resistors which…

A: Given: The value of first resistor is R1=640 Ω The inductor has a value of L=6 H. Out of the…

Q: Your RL circuit has a characteristic time constant of 20.0 ns, and an inductance of 0.150 H. • What…

Q: An emf of 9.7mV is induced in a coil while the current in a nearby coil is decreasing at a rate of…

Q: A 40-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: 4. A coil inductance 1 henry and resistance 10 ohms is connected in series with an e.m.f. of Eo sin…

Q: A 40 V (volt) battery is connected to a simple series circuit in which the inductance is 0.2 H…

Q: A coil has 2.55-ΩΩ resistance and 121-mH inductance. If the current is 3.00 A and is increasing at…

Q: A series circuit has a capacitor of 0.2 · 10-6 F and an inductor of 0.8 H. If the initial charge on…

Q: An ideal air-core solenoid has a length of 6.5 cm, area of 2 c and 3000 turns. Find the…

A: Length , l = 6.5 cm = 6.5 x 10-2 m Area , A = 2 cm2 = 2 x 10-4 m2 Number of turns , N = 3000 turns…

Q: What is the self-inductance of a solenoid 30.0cm long having 100 turns of wire and a cross-sectional…

A: Length of the solenoid L=30 cm =0.3 m Number of turns in the solenoid N =100 turns Area of cross…

Q: Find the inductance of an RL circuit if the resistance is 0.5?and the current increases to ¼ of tis…

A: resistance (R) = 0.5 ohm Time (t) = 1.5 seconds Current = Imax4

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

A: Given The voltage of an LR circuit is V(t) = 10 V. The inductance of the circuit is L = 0.1 H. The…

Q: A conducting coil, with current i(t) = 4.00e-0.0250t sin(120at), with i in amperes and t in seconds,…

Q: Calculate the phase angle (in radians) for a circuit with a maximum voltage of 12 V and ω= 100 Hz.…

A: The expression to calculate the phase angle between the current and the voltage is,

Q: An RL circuit with a 5-0 resistor and a 0.05-H inductor carries a current of 1 A at t = 0, at which…

Q: The solenoid whose inductance is L = 20.0 H is connected in series to a resistor R = 10.0 N and a…

Q: Since inductors can be used as energy storage elements, how much inductance is needed to power up a…

Q: An inductor of renctance 30.0 n, a capacitor of reactance 222 and a resistor of resistance 6.0 2 are…

A: Given : XL = 30 Ω Xc = 22 Ω R = 6 Ω VR = 60 V

Q: Find the equation of the current i(t) as a function of time in a series Resistor-Inductor (RL)…

A: equation is iR+Ldidt=V10i+didt=10e-5t

Q: An RL circuit consists of a resistor with a resistance of 13 Ohms and an inductor with an inductance…

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: A 30-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: series circuit containing an inductor with an inductance of L henries, a resistor with a resistance…

A: Consider the given linear first order equation, substitute the required values, and solve.

Q: In the circuit shown, the switch is con- nected to position a for a long time, then thrown to…

Q: A series RLC circuit, with the components 1.4 kN, 22 mH and 1.8 µF, is connected to an alternating…

Q: Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.

A: From Ampere’s law

Q: h y Calaulate the inductance of the very long conductive wire that carries currer and the conductive…

A: Mutual Inductance is the ratio of the magnetic flux through a body (due to the magnetic field…

Q: We have considered a driven RLC circuit with components in series in class, but what about when they…

A: Reactance of an inductor is given as- XL=ωL=2πfL Reactance of a capacitor is given as- XC=1ωC=12πfC…

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: How many turns should a solenoid of cross-sectional area0.035 m2 and length 0.32 m have if its…

A: The solenoid’s cross-sectional area is, The solenoid’s length is, The inductance of a solenoid is,

Q: A 50.0 mH inductor is connected to an acgenerator with e=30.0 V.What is the amplitude of the…

A: a) The equation for the current amplitude is given by,

Q: Calculate the inductance of a solenoid that is 1.5 cm long and 3.0 mm in diameter, with 300 turns of…

A: Given data: Length of the solenoid, l = 1.5cm = 0.015m Diameter of the solenoid, d = 3mm =…

Q: An LR ciruit contains an ideal 60-V battery, a 51-H inductor having no resistance, a 21ohm…

A: Given: Resistance=21 ohm Voltage across the resistor is equal to voltage across the inductor. So…

Q: At time t =0, a 45 V potential difference is suddenly applied to the leads of a coil with inductance…

A: The equation for the current is given by,

Q: Consider an RLC circuit with emf amplitude E, = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

Q: S. iz R2 R1 L 0.5 H and negli gible resistance is connected 50 and R2 An inductor with inductance L…

Q: An emf of 96.0 mV is induced in the windings of a coil when the current in a nearby coil is…

Q: A rectangular loop of N closely packed turns is positionednear a long straight wire .What is the…

A: Basic Details The self-inductance depends on the number of turns, the flux of the loop and the…

Q: The current of a coil of inductance L = 0.1 H varies with time according to I = 4 t2 - 6 t, where I…

Q: Physics The heating coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00…

A: in this question we get inductance , energy and emf.

Q: Find the approximate formula expressing the mutual inductance of two thin coaxial loops of the same…

A: Write the given values of the problem- Radius=a Distance=l

Q: For the given voltage across a 3 H inductor, plot the current and power waveforms assuming an…

A: In this question we are given a 3 H inductor and we have to plot the current and power waveforms.

Q: A 20-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: Aseries circuit contains a resistor with R = 40Ω, an inductor with L = 2 H, a capacitor with 0.0025…

A: Given : Resistor, R = 40 Ω Inductor, L = 2 H Capacitor, C = 0.0025 F Voltage, V(t) =…

Q: What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose…

A: R = 4 mm r = 0.5 mm

Q: An ideal air-core solenoid has a length of 6.5 cm, area of 2 cm2 and 3000 turns. Find the…

A: Given values: Length, l=6.5 cm Area, A=2 cm2 Number of turns, N=3000 turns

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 2 resistor, what value…

A: The time constant for an RL circuit is defined by τ=LR. L is the self-inductance of the inductor and…

Q: A 40 volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

A: E= 40V R= 50 ohms L= 0.1 H

Question

DIFFERENTIAL EQUATION: Electric Circuits.
Solve the following problems. Show your complete solution.
A coil of inductance 1 henry and negligible resistance is connected in series with a
capacitance of 4x10-6 farad, and an emf of E = 200 volts. When t = 0, Q = 0, and I = 0.
%3D
Find Q and I at any time t.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

Introduction

Answer

Answer

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Describe what effect the resistance of the connecting wires has on an oscillating LC circuit.
Suppose you need to construct a resonant frequency of 52.5 Hz. What inductance in henries do you need to combine with a 1.75 nanofarad capacitor? (L=?)
Two resistors of resistance R1and R2 are placed in series across a battery with voltage V, such that a current I=V/(R1+R2) flows around the circuit. If a coil with inductance L is then placed inparallel withR1, what is the new currentIa long time after the coil has been added? Give your final answer.
Consider the four circuits shown. They all have the same resonance frequency f0 and are driven by the same emf. Rank in order, from largest to smallest, the maximum currents (Imax)1 to (Imax)4 . Explain.
In the previous problem, you tried to draw a circuit diagram for a series circuit containing a R = 100-ohm resistance, a coil with L = 0.1 H inductance, and a C = 20-μμF capacitor connected across a 110-V, 60 Hz voltage source. What would be the voltmeter readings across R, L, and C? (Show your work on scratch papers). Show your work in calculating the resonance frequency of a circuit containing an inductance L = 40.0 mH and a capacitance C = 600 pF
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
Discuss possible practical applications of RL circuits.
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+2R2C2 and for the inductor circuit, voutvin=RR2+2L2 (b) Slow that for low frequencies, voutvin , but for high frequencies, vout0 .
In an oscillating RLC circuit, R=5.0 ,. L=5.0mH , and C = 500 F . What is the angular frequency of the oscillations?
What is the self-inductance of a coil whose reactance is 10 at 60 Hz?