A constant current flows for 3.75 h through an electrolytic cell containing aqueous AgNO3(aq). During this time, 2.00 g of silver are deposited on the electrode. What is the current flowing through the cell?

Q: Which of the following statements is true? A After drying a sample in the oven, you can place it imm...

A: Since you have posted multiple questions, we are entitled to answer the first only.  

Q: If the populations of two levels of energies E₁ and E, and statistical weights g; and g¡(E¡ < Ej) ar...

A:

Q: Which is NOT true about stock solutions? A Must be rarely touched during experiments B Cannot be con...

A: Given, Four statements regarding stock solution is provided     Required,                   Among fo...

Q: Question 11 In the home-based experiment involving reaction between the iodine solution and ascorbic...

A: In the reaction between iodine solution and ascorbic acid :  Which act as a reducing agent ? 

Q: Seoyeon needs to prepare a 250 mL solution of 0.1000 M Na2CO3. Which glassware should she use to pre...

A: All the instruments mentioned can be used to measure the volume of the solution. Although for titrat...

Q: 1. Describe the operation of spectrophotometer.

A:

Q: At 400 K, an equilibrium mixture of H2, 12, and HI consists of 0.065 mol H2, 0.079 mol 12, and 0.13 ...

A:

Q: ete chemical formula for t

A:

Q: calculate the concentration of the unknown KMnO4 solution in ppm

A:

Q: Based on the given structures, determine which has a higher boiling point and why?

A: Boiling point is directly proportional to molar mass and inversely proportional to branching 

Q: CIS-fatty acid chains are relatively linear and therefore can pack relatively easily with neighborin...

A: The statement given is "CIS-fatty acid chains are relatively linear and therefore can pack relativel...

Q: Consider the reaction below. Given the equilibrium concentration of each species, what is the equili...

A:

Q: In the gas phase reaction 2 A(g) + B(g) = 3 C (g) + 2 D (g), it was found that when 1.00 mol A, 2.00...

A:

Q: Magnesia contains Mg?* and 02-. Which of these ions is larger? Explain.

A: Given that : Out of Mg2+ and O2- ion, we have to identify which one is larger.

Q: How many moles of oxygen are needed to fully react 837.4 grams of C8H18? * Answer: Round off your an...

A: Mass of C8H18 = 837.4 g  Molar mass of C8H18 = 114.23 g/mol  Molar mass of O2 = 16 g/mol  Moles of O...

Q: Which of the following glassware is best used for slow dispensing of 47.00 ml of a solution? (A Grad...

A: Solution is made up of solute and solvent.Solute is present in small amount and solvent is present i...

Q: Which of the following statement/s is/are TRUE? 1. The 9-V battery drives the non-spontaneous reacti...

A: Given, Four statement regarding electrolysis is provided     Required,                  Select the T...

Q: Question 23 The equilibrium constant Kc for the reaction fructose-1,6-diphosphate = glyceraldehyde-3...

A:

Q: The equilibrium constant Kc for the reaction fructose-1,6-diphosphate = glyceraldehyde-3-phosphate +...

A:

Q: Using the data in the table, calculate the standard entropy changes for the following reactions at 2...

A:

Q: light Bra b) Lindlar's

A:

Q: Determine if reaction will occur when each set of two compounds are mixed. If reaction does occur, w...

A:

Q: Identify as many peaks as possible. This is an NMR reading of an unknown solid sample. Provide the n...

A: The two peaks that are showing in the given picture are mainly indicating The -OH (δ 2.5) and -CH2  ...

Q: Which of the following glassware is best used for slow dispensing of 47.00 mL of a solution?

A: Different experiment have different requirement

Q: 4) Predict the products of the ff reagents upon ozonolysis (oxidative-work up): В. A.

A: Ozonolysis is the process by which ozone (O3) reacts with alkenes (olefins) to break the double bond...

Q: You are asked to do quality control and quality assurance during the determination of lead concentra...

A: The limit of quantitation is given by the expression: Limit of quantitation=10 sm     where, s=stand...

Q: How would you prepare 350 mL of a 1:20 glucose solution? Write your answer with two digits past the ...

A: 1:20 glucose solution means 1/20 dilution factor., Volume of solution = 350 ml Required weight of Gl...

Q: 1. How many MOLECULES of sulfur dioxide are present in 6.52 grams of this compound? molecules. 2. Ho...

A:

Q: N=D C CH3

A:

Q: The reaction between selenous acid and the iodide ion in acid solution is H2SEO3(aq) + 61 (aq) + 4H*...

A:

Q: Consider the reaction: 2 CO(g) + O2(g) = 2 CO2(g) What will be the shift in equilibrium if some O2 i...

A: Given chemical Reaction equation :- 2 CO(g) + O2(g) ⇌ 2 CO2(g) Reactants =&gt; CO and O2 PProduct =&...

Q: How many grams of Ag2CO3 will precipitate when excess Na2CO3 solution is added to 45.0 mL of 0.538M ...

A:

Q: partial pressures

A:

Q: How do we express the independent variable in Kolrausch plot? Concentration Natural logarithm of con...

A: Kholraush law states that at infinite dilution, each ion (cation and anion) independently migrate an...

Q: 1.Consider the complete combustion of methane gas, CH4(g): Which of the following BEST describes the...

A: Entropy is defined as measure of randomness or disorder of system.

Q: Classify each of the following amines as a primary, secondary, or tertiary amine. a. CH-CH CH,–NH, b...

A:

Q: Experiment No: 10 SPECTROPHOTOMETRIC DETERMINATION OF IRON RESULTS AND INTERPRETATIONS Table 10.1. M...

A: Given:

Q: For the following process, determine the change in entropy for the system (ASsys), the surrounding (...

A:

Q: Why are the last two compounds called meso diastereomers? I understand the meso part, but aren't dia...

A: Enantiomers are the mirror images of each other and mirror images are non-superimposable on each oth...

Q: Consider the following equilibrium at 25°C: 2ICI(g) Which of the following would be true if the temp...

A:

Q: Question 1 Which of the following corresponds to the slope of the van't Hoff equation? In K ΔΗ rxn R...

A:

Q: Which of the following is the best option for transferring 20 mL of a solution? A Use a 5mL serologi...

A: BELOW ATTACHED FILE SHOWING THE DETAILS ANSWER .  ALL THE BEST 

Q: In the gas phase reaction 2 A(g) + B(g) = 3 C (g) + 2 D (g). it was found that when 1.00 mol A, 2.00...

A: Note - Since you have posted a question with multiple sub-parts, we will solve first three sub-part...

Q: When cobalt chloride is added to pure water, the Co2* ions hydrate. The hydrated form then reacts wi...

A: Given reaction is :  Which statement describes the change that the system will undergo if KCl is ad...

Q: The addition of water to ethylene to yield ethanol has the following thermodynamic parameters: JH= -...

A: Solution is given below in next step 

Q: Draw the mechanism of the formation of Veratrole/O-dimethoxybenzene using Friedel-Crafts Acylation. ...

A: Friedel-Crafts acylation is the reaction for acylating benzene or its derivatives using acyl chlorid...

Q: Select from each set the element with highest IE1 (matching sets are color-coded): Set (a): Set (b):...

A: Ionization energy is defined as the amount of energy required ro remove electron from a neutral isol...

Q: Calculate the mean and standard deviation for the following set of analytical results: 34.65, 34.97...

A: Please find your solution below : Mean is calculated by taking the sum of all the values of data and...

Q: How many grams of CuCl2 (MW = 134.45 g/mol) is needed to prepare 100.0 mL of 0.2418 M CuCl2?   3.07...

A:

Q: Which of the following is the best option for transferring 20 mL of a solution? A Use a 10 mL Mohr p...

A: Correct option C 

Electrolysis

Electrolysis is defined as the process of breaking down ionic compounds into their constituent elements by passing a direct electric current through the compound in a fluid state. The cathode reduces cations, while the anode oxidizes anions. An electrolyte, electrodes, and some form of external power source are the main components required for conducting electrolysis. A partition, such as an ion-exchange membrane or a salt bridge, may also be used, but this is optional. These are primarily used to prevent the products from diffusing near the opposing electrode.