A cylindrical tank with a large diameter is filled with water to a depth D = 0.368 m. A hole of cross-sectional area A = 5.73 cm2 in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole? (a) Number Units (b) Number i Units

A cylindrical tank with a large diameter is filled with water to a depth D = 0.368 m. A hole of cross-sectional area A = 5.73 cm2 in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole? (a) Number Units (b) Number i Units

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water enters a shower head through a pipe of internal radius r = 6.4 mm, and leaves through 30 small holes, each of radius r1 = 0.08 mm. When the faucet is opened, the water moves in the tube at a speed of 90 cm/s. What is the volumetric flow of the shower head in liters per second?
Water enters a two-armed lawn sprinkler along the vertical axis at a rate of 75 L/s, and leaves the sprinkler nozzles as 2-cm diameter jets at an angle of ? from the tangential direction, as shown. The length of each sprinkler arm is 0.52 m.For the specified flow rate, investigate the effect of discharge angle ? on the rate of rotation n. by varying ? from 0° to 90° in increments of 10°. Plot the rate of rotation versus ?, and discuss your results.
A cylindrical tank with a large diameter is filled with water to a depth D = 0.402 m. A hole of cross-sectional area A = 5.26 cm2 in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole?
A jet of water issues from a kitchen faucet and falls vertically downward at a flow rate of 34 mL/s. At the faucet,which is 35 cm above the sink bottom, the jet diameter is 1.5 cm. Determine the diameter of the jet where it strikes the sink.
Water falls vertically downward from an open faucet with an initial velocity of 66 cm/s. If the stream diameter at the faucet head is 0.5 cm what is the stream diameter at a distance 5 cm below the faucet exit?
A horizontal water pipe of 15 cm diameter converges to a 7.5 cm diameter. If the pressures at the two sections are 400 kPa, and 150 kPa respectively, calculate the flow rate of water in cubic meters per second
A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which is rotating at 200 rpm. The jet makes an angle 30° with the tangent to the wheel at inlet, and leaves the wheel with a velocity 5 m/s at angle of 140° to the tangent to the wheel at the outlet. The outer and inner radii of the wheel are 70 cm and 35 cm, respectively. A. Determine the Inlet Vane Angle, in degrees.
When a jet of water gushing from a short pipe with a diameter of D= 5 cm, located at a depth of h= 6.6 m from the surface of a fixed level reservoir shown in the figure, hits a horizontal plate that makes an angle of 30o with the jet axis (friction effects are neglected), a)Determine the scalar value and direction of the impact force exerted by the water on the plate (Enter the numerical value of the direction you think is correct in the direction-number image in Figure 3 in the box named "Direction-effect". For example: '1' will be entered for the upward direction). b)Determine the scalar value of the reaction force of the plate and determine its direction (Enter the numerical value of the direction you think is correct in the direction-number image given in Figure 3 in the box named "Direction-reaction". For example: '1' will be entered for the upward direction).
Water flows through a pipe of 0.0025 m^2size with a uniform velocity of 7m/s and flows out from an ariface at bottom at a rate 0.003 m^3/s. what is rate of change of mass of water in the tank?
The horizontal tube is 1 m long and 10 cm in diameter and is filled with a sample material. During a test, the upstream head h, falls from 200 to 180 cm in 4 hr, while h₂ is held constant at 15 cm. The diameter of vertical tube in which h, is measured is 40 cm. What is the indicated average hydraulic conductivity?
A pump is discharging 12 liters/sec of water through 10 cm diameter pipe. When the pressure on the discharge side of the pump is 700 kPa, what pressure can be expected in the discharge pipe at a point 540 m distant from the pump and 45 m higher in elevation. Use n = 0.015.
Roman aqueduct customersobtained extra water by attaching a diffuser to theirpipe exits. Fig. shows a simulation: a smooth inletpipe, with or without a 15° conical diffuser expanding to a5-cm-diameter exit. The pipe entrance is sharp-edged. Calculatethe fl ow rate (a) without and (b) with the diffuser.