Answered: A) Determine maximum spring compression…

Name: A)Determine maximum spring compression when a block of 5 kg is releas
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: A)Determine maximum spring compression when a block of 5 kg is releasedfrom rest at A as shown in Fig. (4). Assume u = 0.2 for BC and k = 0.8 N/m forspring.AR 0.7 mo00000000B1 mFig. 4

Science

Physics

A) Determine maximum spring compression when a block of 5 kg is released from rest at A as shown in Fig. (4). Assume u = 0.2 for BC and k = 0.8 N/m for spring. %3D R=0.7 m lellll В 1 m

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter8: Conservation Of Energy

Section: Chapter Questions

Problem 42PQ: A 1.50-kg box rests atop a massless vertical spring with k = 4250 N/m that has been compressed by...

See similar textbooks

Similar questions

An archer pulls her bowstring back 0.400 m by exerting a force that increases uniformly from zero to 230 N. (a) What is the equivalent spring constant of the bow? (b) How much work does the archer do in pulling the bow? Figure P5.64
Use the data in Table P16.59 for a block of mass m = 0.250 kg and assume friction is negligible. a. Write an expression for the force FH exerted by the spring on the block. b. Sketch FH versus t.
A cafeteria tray dispenser supports a stack of trays on a shelf that hangs from four identical spiral springs under tension, one near each corner of the shelf. Each tray is rectangular, 45.3 cm by 35.6 cm. 0.450 cm thick, and with mass 580 g. (a) Demonstrate that the top tray in the stack can always be at the same height above the floor, however many trays are in the dispenser, (b) Find the spring constant each spring should have for the dispenser to function in this convenient way. (c) Is any piece of data unnecessary for this determination?
Review. A 2.00-kg I Jock hangs from a rubber cord, being supported .so (hat the cord is not stretched. The unstretched length of the cord is 0.500 m, and its mass is 5.00 g. The spring constant for the cord is 100 N/m. The block is released and stops momentarily at the lowest point, (a) Determine the tension in the cord when the block is at this lowest point, (b) What is the length of the cord in this "stretched" position? (c) II the block in held in this lowest position. find the speed of a transverse wave in the cord.
One type of toy car contains a spring that is compressed as the wheels are rolled backward along a surface. The spring remains compressed until the wheels are freed and the car is allowed to roll forward. Jose learns that if he rolls the car backward for a greater distance (up to a certain point), the car will go faster when he releases it. The spring compresses 1.00 cm for every 10.0 cm the car is rolled backward. a. Assuming the spring constant is 150.0 N/m, what is the elastic potential energy stored in the spring when Jose rolls the car backward 20.0 cm? b. What is the elastic potential energy stored in the spring when he rolls the car backward 30.0 cm? c. Explain the correlation between the results for parts (a) and (b) and Joses observations of different speeds.
An automobile having a mass of 1.00 103 kg is driven into a brick wall in a safety test. The bumper behaves like a spring with constant 5.00 105 N/m and is compressed 3.16 cm as the car is brought to rest. What was the speed of the car before impact, assuming no energy is lost in the collision with the wall?
Review. A 0.250-kg block resting on a frictionless, horizontal surface is attached to a spring whose force constant is 83.8 N/m as in Figure P15.15. A horizontal force F causes the spring to stretch a distance of 5.46 cm from its equilibrium position. (a) Find the magnitude of F. (b) What is the total energy stored in the system when the spring is stretched? (c) Find the magnitude of the acceleration of the block just after the applied force is removed. (d) Find the speed of the block when it first reaches the equilibrium position. (e) If the surface is not frictionless but the block still reaches the equilibrium position, would your answer to part (d) be larger or smaller? (f) What other information would you need to know to find the actual answer to part (d) in this case? (g) What is the largest value of the coefficient of friction that would allow the block to reach the equilibrium position? Figure P15.15
A spring 1.50 m long with force constant 475 N/m is hung from the ceiling of an elevator, and a block of mass 10.0 kg is attached to the bottom of the spring. (a) By how much is the spring stretched when the block is slowly lowered to its equilibrium point? (b) If the elevator subsequently accelerates upward at 2.00 m/s2, what is the position of the block, taking the equilibrium position found in part (a) as y = 0 and upwards as the positive y-direction. (c) If the elevator cable snaps during the acceleration, describe the subsequent motion of the block relative to the freely falling elevator. What is the amplitude of its motion?
A horizontal block-spring system with the block on a frictionless surface has total mechanical energy E = 47.0 J and a maximum displacement from equilibrium of 0.240 m. (a) What is the spring constant? (b) What is the kinetic energy of the system at the equilibrium point? (c) If the maximum speed of the block is 3.45 m/s, what is its mass? (d) What is the speed of the block when its displacement is 0.160 m? (e) Find the kinetic energy of the block at x = 0.160 m. (f) Find the potential energy stored in the spring when x = 0.160 m. (g) Suppose the same system is released from rest at x = 0.240 m on a rough surface so that it loses 14.0 J by the time it reaches its first turning point (after passing equilibrium at x = 0). What is its position at that instant?
An automobile having a mass of 1.00 103 kg is driven into a brick wall in a safety test. The bumper behaves like a spring with constant 5.00 105 N/m and is compressed 3.16 cm as the car is brought to rest. What was the speed of the car before impact, assuming no energy is lost in the collision with the wall?
When an 80.0-kg man stands on a pogo stick, the spring is compressed 0.120 m. (a) What is the force constant of the spring? (b) Will the spring be compressed more when he hops down the road?
A 0.250-kg block along a horizontal track has a speed of 1.50 m/s immediately before colliding with a light spring of force constant 4.60 N/m located at the end of the track. (a) What is the springs maximum compression if the track is frictionless? (b) If the track is not frictionless, would the springs maximum compression be greater than, less than, or equal to the value obtained in part (a)?