(a) Determine the work spent on the system if the compression is reversible as well as the exit temperature. (b) Argue using the T-s diagram why this work spent on the system is minimal. (c) Determine the work spent on the compressor as well as the entropy generation of the process if the exit temperature of the compressor is 1100 °C.

(a) Determine the work spent on the system if the compression is reversible as well as the exit temperature. (b) Argue using the T-s diagram why this work spent on the system is minimal. (c) Determine the work spent on the compressor as well as the entropy generation of the process if the exit temperature of the compressor is 1100 °C.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

During an isothermal process, at 900F, the pressure on 9 lb of air drops from 85 psia to10 psig. For an internally reversible process,3.1 Determine the work nonflow3.2 Solve for the value of Q3.3 Determine ΔH
34 - Helium enters a continuous flow compressor at 326 K and leaves at 441 K. If the mass flow rate is 1.5 kg/s, which of the following is the required power? (Cp = 5.1926 kJ/kgK) a) 988.7 kW B) 895.7 kW NS) 617.9 kW D) 927.9 kW TO) 836.0 kW
HANDWRITTEN AND THE FINAL ANSWER SHOULD BE IN ENGLISH SYSTEM A process innovated by Engr. Santioque is considered to be in a constant pressure. If there is ten kilograms of air has a decrease of internal energy of 55 BTU while its Fahrenheit temperature is reduced to one fifth of the initial temperature during a reversible non flow process. Determine (a) the initial and final temperatures, (b) heat, (c) work, and (d) the change in entropy.
Select the correct expression for steady flow work of a reversible compressor_________ A. B. C. D.
A gaseous substance whose properties are unknown, except specified, undergoes an internally reversible process during which v=(-0.1p+300)ft3 where p is in psfa. The pressure changes from 1000 psfa to 100 psfa. The process is a steady flow where the change in kinetic energy is 25 Btu, the change in potential energy is negligible, and ∆? = −300 ???, compute for the heat transferred and work done or by the system in kilojoules.
THERMODYNAMICS A 1.5-kW power output is produced by a small, high-speed turbine that runs on compressed air. The entrance state is 400 kPa and 52 degrees celcius, whereas the exit state is 150 kPa and -43 degrees celcius. Determine the needed mass flow rate of air through the turbine assuming low velocities and an adiabatic process.
Question 3 Under ideal conditions, if the inlet velocity is zero, the velocity of steam in m/s at the outlet outlet of a nozzle for a enthalpy drop of 427 kJ/kg from the inlet reservoir condition up to the exit is..........
During an isothermal process at 88°F, the pressure on 8 lbm of air drops from 80 psia to 5 psig. For an internally reversible process, determine a) work non flow b) work steady if change kinetic and potential energy is zero c) Q d) change in enthalpy and e) change in entropy
11Air gas expands isentropically through a converging nozzle from a large tank at 160 lbf/in2, 600°R, and discharges into a region at 50 lbf/in2. The exit flow area is 1 in2. For air, use Cp = 0.24 Btu/lb.R. a. Determine the pressure at the exit in lbf/in2 b. Determine the mass flow rate through the nozzle, in lb/s
Steam enters an adiabatic turbine at the rate of 50 kg/sec. If the steam properties at the inlet are the following: enthalpy = 3520 KJ/kg and velocity = 10 m/sec, at the outlet which is 5 m below the turbine inlet, enthalpy = 2250 kJ/kg and velocity = 275 m/sec, the change in potential energy in kW is nearly equal to?
Air is compressed steadily by a reversible compressor from an inlet state of 100 kPa and 300 K to an exit pressure of 900 kPa. Determine the compressor work per unit mass for isentropic compression with k = 1.4,
10 kg/s of steam (H2O) enters a turbine at 10 m/s and a specific enthalpy of 3500 kJ/kg and leaves at an outlet 10m below the inlet with a specific enthalpy of 2500 kJ/kg and a velocity of 20 m/s. Assume steady-state steady-flow. If the heat lost from the turbine is 20% that of the turbine work, determine a.) the turbine horsepower. If the turbine is coupled to a generator with a 90% electrical efficiency, and the turbine horsepower has an 80% mechanical efficiency, b.) how much income will a power plant generate in one year if the electrical energy is sold at PhP 3.51 per kW-hr? (Hint: Mechanical efficiency = actual turbine work / ideal turbine work. Electrical efficiency of a generator = electrical output / actual turbine work.)