A group of students estimated the length of one minute without reference to a watch or clock, and the times (seconds) are listed below. Use a 0.05 significance level to test the claim that these times are from a population with a mean equal to 60 seconds. Does it appear that students are reasonably good at estimating one minute? 76 93 47 77 48 35 71 70 75 58 75 80 99 100 72

A group of students estimated the length of one minute without reference to a watch or clock, and the times (seconds) are listed below. Use a 0.05 significance level to test the claim that these times are from a population with a mean equal to 60 seconds. Does it appear that students are reasonably good at estimating one minute? 76 93 47 77 48 35 71 70 75 58 75 80 99 100 72

Name: A group of students estimated the length of one minute without referen
Uploaded: 2024-03-20T07:07:12.000Z
Channel: Bartleby
Description: A group of students estimated the length of one minute without reference to a watch or clock, and the times (seconds) are listed below. Use a0.05significance level to test the claim that these times are from a population with a mean equal to 60 sec

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter29: Tolerance, Clearance, And Interference

Section: Chapter Questions

Problem 16A: Spacers are manufactured to the mean dimension and tolerance shown in Figure 29-12. An inspector...

See similar textbooks

Similar questions

An engineer has built a simulation model of a small factory, run an experiment with the model using 15 replicates, and determined at 90% confidence that the mean time an entity spends in the system is in the range of 24 min to 28 min. The data are normally distributed. Based on this information, what can the engineer say about entity time-in-system?A -The population mean time-in-system must be in the interval 24 min to 28 min. B- The largest mean time-in-system for any one of the 15 replicates was 28 min. C- If the engineer were to run a 16th replicate, the mean time-in-system would be in the interval 24 min to 28 min. D. The probability that the population mean time-in-system is greater than 28 min can be estimated as 5%.
A newspaper article reported that people spend a mean of 7 hours per day watching TV, with a standard deviation of 1.7 hours. A psychologist would like to conduct interviews with the 15% of the population who spend the most time watching TV. She assumes that the daily time people spend watching TV is normally distributed. At least how many hours of daily TV watching are necessary for a person to be eligible for the interview? Carry your intermediate computations to at least four decimal places. Round your answer to one decimal place.
A newspaper article reported that people spend a mean of six hours per day watching TV, with a standard deviation of 1.8 hours. Psychologist would like to conduct interviews with the 15% of the population who spend the most time watching TV. She assumes that the daily time people spend watching TV is normally distributed. At least how many hours of daily TV watching are necessary for a person to be eligible for the interview? Carry immediate computations to at least four decimal places. Round your answer to one decimal place
A police department released the numbers of calls for the different days of the week during the month of October, as shown in the table to the right. Use a 0.01significance level to test the claim that the different days of the week have the same frequencies of police calls. What is the fundamental error with this analysis? Calculate the test statistic, chi squared.
A researcher conducts an experiment comparing fourtreatment conditions with n = 12 scores in eachcondition.a. If the researcher uses an independent-measuresdesign, how many individuals are needed for thestudy and what are the df values for the F-ratio?b. If the researcher uses a repeated-measures design,how many individuals are needed for the study andwhat are the df values for the F-ratio?
Find the sample size needed to estimate the mean age of movie patrons such that it can be said with 98% confidence that the sample mean is within 2 years of the population mean. Assume that o=19.2 years, based on a previous report. Could the sample be obtained from one movie at one theater? The required sample size is: