Answered: a host find out the MAC address of the…

Engineering

Computer Science

a host find out the MAC address of the nearest router (= default gateway)

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter8: Connecting To And Setting Up A Network

Section: Chapter Questions

Problem 2TC

See similar textbooks

Related questions

Q: When a computer attempts to connect to a host with a recognized IP address on another network, what…

A: In order to track the IP addresses or names of the commenters a client uses the help of the UNS…

Q: The Bridge is used to Connect Two Different LANS or Two Segments of the Same LAN depending on IP…

A: The solution to the given problem is below. ***Note: According to Bartleby policy we are not…

Q: lo send an Ethernet frame to a destination server that is two router hops away, your client computer…

A: class C network use a default subnet of 255.255.255.0 and it has 192-223 as their first octet. To…

Q: router redundancy network, the IPv4 address of the _______________ router is configured as the…

A: In a router redundancy network, the IPv4 address of the _______________ router is configured as the…

Q: A router in the same subnet as a designated router will share routing information with which routers…

A: option c - designated router and backup designated router. These routers helps to exchange…

Q: Which term is best described as the practice of adding a device's physical address to a wireless…

A: Question is straight forward. We need to find the right option for the question.

Q: When we run IPCONFIG without any switches, we will see all of the following information, except:…

A: ipconfig displays Internet Protocol version 4 (IPv4) and IPv6 addresses, subnet mask, and default…

Q: Suppose the destination not stored in the MAC table, what wvill happen no option is correct the…

A: The correct option is option c) the switch will send request to all except the port that is came…

Q: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

A: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

Q: Observe the router configuration command given below and identify the following: Router(config)#ip…

A: It is defined as the device that receives and sends data on computer networks. Routers are…

Q: Since a gateway (NAT) router only has one public IP address, but may forward packets from many…

A: We are going to understand how NAT works and how NAT could remember these many IP addresses to…

Q: Bitwise AND operation is needed to obtain the subnet number. Given an IP Address and Subnet Mask, by…

A: Steps to obtain the subnet number: Step 1: Convert the given IP address and subnet mask to binary…

Q: particular node is failing to connect to a certain network devices properly, the IP address…

A: It is defined as the practice of dividing a network into two or smaller networks. It increases…

Q: When a router can’t determine a path to a message‘s destination, where does it send the message? a.…

A: Router: Router refers to a networking device, which is used to transfer data packets between…

Q: A default static route is similar to a default gateway on a host. The default static route specifies…

A: a default static route is similar to a default gateway on a host. The default static routes…

Q: Analyze the below diagram. The client is sending a message to the Whatsapp server. Fill the missing…

A: Destination MAC bbbb:1111:aaaa Source MAC aaaa:1111:aaaa Source IP 20.4.4.1/24 Destination IP…

Q: The company has a policy of using the last usable host address as the gateway address. The…

A: Answer in step2.

Q: Which of the following device is used to connect two systems, especially if the systems use…

A: Please find the answer below

Q: Which of the following allows a router to respond to an ARP request that is intended for a remote…

A: Given that: Which of the following allows a router to respond to an ARP request that is intended for…

Q: The Network Administrator wasn't able to perform ping to the domain controller after setting all the…

A: The Network Administrator wasn't able to perform ping to the domain controller after setting all the…

Q: PC1 PC2 S1 GO/0/0 GO/0/1 S2 .1 Looking for a DHCPV4 server. I cannot forward broadcasts between…

A: Given: To configure interface in VLAN

Q: Your company has 2 routers. One router has 15 NICs and the other has 3. One network is shared…

A: IP Address: 128.0.0.0 Network Address: 128.0.0.0 Usable Host IP Range: 128.0.0.1 - 128.0.0.2…

Q: Regarding to DHCP, which statement is correct? O Only one DCHP server can be installed in each…

A: Regarding to DHCP which of the following Statement is Correct.

Q: In case if a router learned more than one paths that are guide to the destination network from the…

A: Given:

Q: When a host on your network provides a service that needs the server to always utilize a given IP…

A: Introduction: Network: Computers are linked together to share resources (printers and CDs), trade…

Q: A network administrator configures the interface Gi7 on R1 with the command ip address 178.18.28.234…

Q: The company has a policy of using the last usable host address as the gateway address. The…

A: Given question has given a scenario where a company has a policy of using the last usable host…

Q: In a(n) _______ configuration, the administrator types the port numbers, the IP addresses, or other…

A: GIVEN: In a(n) _______ configuration, the administrator types the port numbers, the IP…

Q: a. Write the command to enable IPv6 unicast routing in both routers (lmark) b. Enable OSPFv3 on all…

A: According to Bartelby guidelines we are suppose to answer only 3 sub part of the question at a time.…

Q: Multiple choice in network You have an interface on a router with the IP address of…

A: Given: IP address of 192.168.192.17/29. Required: to find the broadcast address the hosts will use…

Q: What will the router do when it received a packet and encapsulate this packet with new Ethernet…

A: Dear Student, A packet if has to be dropped is dropped before sending it to the egress port or exit…

Q: A router receives a packet from another network for device in the local network that the router…

A: Solution:

Q: Which of the following actions correspond to SDN approach? A router exchanges messages with another…

A: Option A- is incorrect because in SDN routers dont exchange messages with each other directly.…

Q: How does a host find out the MAC address of the nearest router (= default gateway)? Group of answer…

A: Answer: It sees the router's IP in the computer configuration and then sends an ARP request

Q: Which one of the following mechanism can be used to prevent a sigle point of failure at the default…

A: given... question is Which one of the following mechanism can be used to prevent at point of failure…

Q: q18- When the destination network is not listed in the routing table of a Cisco router, what is…

A: A router is a systems administration gadget that advances information bundles between PC…

Q: 1. Enter privileged EXEC mode. 2. Enter global configuration mode. 3. Apply a hostname BA to…

A: 1.Privileged EXEC mode. From user EXEC mode, enter the enable command. prompt:- Switch# To exit to…

Q: How many hosts can you have with a subnet of 192.168.1.0/28? Group of answer choices 6 16 14 30

A: Given that how many hosts can you have with a subnet of 192.168.1.0/28? Group of answer choices 6…

Q: ubnet mask: 255. 254. 0. 0 describe how to configure the subnet mask so that the computer can…

A: In a NORMAL HOME NETWORK the Subnet Mask is usually “255.255.255.0”. What that means is that the…

Q: (Cisco Packet Tracer) Requirements A. Configure PCs host IP settings B. Configure the basic router…

A: Answer :

Q: Q5: If Host A in the following network used MTU discovery protocol to send packets to Host B, what…

A: A maximum transmission unit (MTU) is the biggest bundle or casing size, indicated in octets…

Q: Write IOS Commands to perform the following in a router, specify the mode of configuration for each…

Q: Router R6 is running OSPF. On R6, I set LoopbackO interface IP address to 6.6.6.6/32 and in R6 OSPF…

Q: A.You are working as a network engineer at Shell Info. The organization uses Cisco's IOS on all of…

A: To remove static route open command line and type this command: route delete 0.0.0.0 mask 0.0.0.0…

Q: ens if a router gets a packet with a destination network address that it d

A: Introduction: The router transmits the packet on a default route, often up the backbone hierarchy to…

Q: Q2 Why does TCP's connection process need at least three separate messages? Select all that apply…

A: the answer is given below :

Q: A computer with an IP address of 10.10.5.1 sends a data packet with a destination IP address of…

A: Subnetting is the practice of stealing bits from an IP address's HOST component in order to divide a…

Q: Which of the following actions correspond to SDN approach? A router exchanges messages with another…

A: SDN approach is stand by software defined network approach.

Q: Routers look at the ________________ when making a routing decision.

A: Routers will help in routing the data packets from sender to receiver through the network

Concept explainers

Linux

An operating system (OS) is the software which manages hardware and resources, like CPU, storage and memory. The OS bridges the applications and hardware and makes the connections between all of your software and the hardware resources.

Question

How does a host find out the MAC address of the nearest router (= default gateway)?
Group of answer options

It sees the router's IP in the computer configuration and then sends an ARP request

It sees the router's MAC address in the computer configuration.

It sends one

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Which two of the following hosts on a corporate intranet are on the same subnet? a.192.168.2.143255.255.255.0b.172.54.98.3255.255.0.0c.192.168.5.57255.255.255.0d.172.54.72.89255.255.0.0
THINKING CRITICALLY Which of the following hosts on a corporate intranet are on the same subnet? a. b. c. d.
How does a host find out the MAC address of the nearest router (= default gateway)?Group of answer options It sees the router's IP in the computer configuration and then sends an ARP request It sees the router's MAC address in the computer configuration. It sends a "router broadcast" online All routers have a predetermined MAC address
q27- When a host on network A sends a message to a host on network B, which address does the router look at? a. Port b. Logical (IP address ) c. Non of the mentioned d. Physical (MAC address) Clear my choice
When a service provided by a host on your network must always come from the same server, that host will need a static IP address. When assigning an IP address manually, which method should be used? how did we get to this point?
Which of the following statements is true about routing functions? A router uses network addresses to forward messages. A router forwards DHCP frames at Layer 2. Both (A) and (B) are correct. None of the above are correct. 2) A WiFi access point is responsible for the following: Flow and error control. Identifying Network protocols. Multiple-access resolution. All of the above.
Please solve fast How many subnets are there? What are these subnets? How many interfaces does the router have? Give their IP addresses. The switch did not need any IP address. Why? Can PC-A get the MAC address of PC-C? If yes, how. Can PC-A get the MAC address of Router at interface g0/0? If yes, how. Indicate the source IP address, the destination IP address, the source MAC address, and the destination MAC address when PC-A sends a packet to PC-B. Indicate the source IP address, the destination IP address, the source MAC address, and the destination MAC address when PC-B sends a packet to a server outside the network with IP Address 125.124.12.135.
Given the topology below, write the commands to advertise the OSPFv3 networks on the Sohar router. Use the following requirements: - Enable IPv6 routing- Process ID 10 - Router IDs (Sohar router = 2.2.2.2) - Advertise Network address for each interface - LAN interface (G0/0) set to passive interface - Assign Link-Local Addresses (fe80::1) to G0/0
write the following iptables on the server to block the following traffic types originated from the attacker to the server: HTTP connection request from the attacker to the server. SSH connection request from the attacker to the server. FTP and Telnet requests ( Use single rule to block these multiple ports).