Transmission line question A lossy capacitor Cx, rated for operation at 5 kV, 50 Hz is represented by an equivalent circuit with anideal capacitor C₁ in parallel with a resistor Rp. The value C₁ is found to be 0.102 µF and the value ofRp 1.25 Mn. Then the power loss and tan 8 of the lossy capacitor operating at the rated voltage,respectively, are-=

Given: An equivalent circuit with an ideal capacitor in parallel with a resistor, Cp=0.102 μFRp=1.25…

A lossy capacitor Cx, rated for operation at 5 kV, 50 Hz is represented by an equivalent circuit with an ideal capacitor C, in parallel with a resistor Rp. The value C, is found to be 0.102 μF and the value of Rp 1.25 Mn. Then the power loss and tand of the lossy capacitor operating at the rated voltage, respectively, are ||||

A lossy capacitor Cx, rated for operation at 5 kV, 50 Hz is represented by an equivalent circuit with an ideal capacitor C, in parallel with a resistor Rp. The value C, is found to be 0.102 μF and the value of Rp 1.25 Mn. Then the power loss and tand of the lossy capacitor operating at the rated voltage, respectively, are ||||

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.52P

See similar textbooks

Similar questions

a)We have a two-wire overhead transmission line, powered by a constant voltage source of 700 V. The values for the inductance of the conductors are 2.348x10-3 H/km and the capacitance values are 6.325x10-9 F/km. Assuming an ideal (no loss) line and its length at 130 km, determine the natural impedance of the line. b) What is the transient phenomenon in a transmission line? As an example of its causes.
Calculate the velocity factor of a coaxial cable used as atransmission line, with the characteristic impedance of 30 ohms,capacitance of 20pF/m and a 80uH/m inductance.
5/The Voltage Regulation of a Transmission Line (in the simulator) depends on which parameter/s? A. Both the Transmission Line Resistance and Inductance B. The Transmission Line Shunt Capacitance only C. The Transmission Line Inductance only D. The Transmission Line Resistance only
Problem: 3-Phase Belted Conductors Assume a 2 mile long, three- conductor belted cable is connected to a 24.9 KV, three-phase, 60 Hz bus. The charging current per conductor is found to be j8.31 A. A test result shows that the capacitance between all conductors bunched together with sheath is 0.8 u F/mi. tau What must be the measured capacitance between two conductors bunched together with the sheath and the third conductor ?
1. Discuss the influence of the bypass, coupling, internal, and stray capacitances on the frequency response.
Suppose that a network can be divided into two subnets connected by only two conductors, as shown below. Two points on these conductors are labeled a and b. The power factor seen to the right of a and b is defined as cos (ϕ) if ϕ is the angle formed by the phasor V and I. (Given the parity of the cosine, it does not matter if it is the angle by which V is advanced with relative to I or for the one that is delayed.) (Image 1) Now consider the following circuit, in which six points have been marked. (Image 2) a) Determine the power factor seen to the right of a3 and b3analyze your result. Does it make physical sense? What is happening to the currents in the inductor and in the capacitor? b) Determine the power factor seen to the right first of a2 and b2 and then of a1 and b1. Re-analyze your results. c) Calculate the capacitance that must be connected between a1 and b1 so that the power factor seen to the right of these points is 0.95 in lag. Assume the source frequency is 60 Hz.
Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC= 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals. [0·0091 μF/km]
Discuss why a. Complex power in an AC circuit is more than the DC resistance. b. Receiving end voltage of an unloaded long line may be more than sending end voltage. c. Inductance of the three phase of a transmission line are generally not equal. d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mii need 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.