A man pushes a box of weight W1E with a constant horizontal force N1H: The floor surface is rough and has a frictional force fis acting on the box. If the box moves with a constant velocity, then which statement is always true about the magnitudes of the forces? N1H = N1S %3D N1H = f1s N1H > fis N1H > W1E %3D

A man pushes a box of weight W1E with a constant horizontal force N1H: The floor surface is rough and has a frictional force fis acting on the box. If the box moves with a constant velocity, then which statement is always true about the magnitudes of the forces? N1H = N1S %3D N1H = f1s N1H > fis N1H > W1E %3D

Name: A man pushes a box of weight W1E with a constant horizontal force N1H
Uploaded: 2024-03-20T06:57:57.000Z
Channel: Bartleby
Description: A man pushes a box of weight W1E with a constant horizontal force N1H: The floor surface is rough and hasa frictional force fis acting on the box. If the box moves with a constant velocity, then which statement isalways true about the magnitudes of

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter4: Forces In One Dimension

Section: Chapter Questions

Problem 52A

See similar textbooks

Similar questions

A crate of weight Fg is pushed by a force P on a horizontal floor as shown in Figure P4.83. The coefficient of static friction is s, and P is directed at angle below the horizontal. (a) Show that the minimum value of P that will move the crate is given by P=sFgsec1stan (b) Find the condition on in terms of , for which motion of the crate is impossible for any value of P. Figure P4.83
A 6.0-kg object undergoes an acceleration of 2.0 m/s2. (a) What is the magnitude of the resultant force acting on it? (b) If this same force is applied to a 4.0-kg object, what acceleration is produced?
A car is stuck in the mud. A tow truck pulls on the car with the arrangement shown in Fig. P4.32. The tow cable is under a tension of 2 500 N and pulls downward and to the left on the pin at its upper end. The light pin is held in equilibrium by forces exerted by the two bars A and B. Each bar is a strut; that is, each is a bar whose weight is small compared to the forces it exerts and which exerts forces only through hinge pins at its ends. Each strut exerts a force directed parallel to its length. Determine the force of tension or compression in each strut. Proceed as follows. Make a guess as to which way (pushing or pulling) each force acts on the top pin. Draw a free-body diagram of the pin. Use the condition for equilibrium of the pin to translate the free-body diagram into equations. From the equations calculate the forces exerted by struts A and B. If you obtain a positive answer, you correctly guessed the direction of the force. A negative answer means that the direction should be reversed, but the absolute value correctly gives the magnitude of the force. If a strut pulls on a pin, it is in tension. If it pushes, the strut is in compression. Identify whether each strut is in tension or in compression.
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
(a) Find the tension in each cable supporting the 6.00 102-N cat burglar in Figure P4.35. (b) Suppose the horizontal cable were reattached higher up on the wall. Would the tension in the other cables increase, decrease, or stay the same? Why? Figure P4.35
For the woman being pulled forward on the toboggan in Figure 4.33, is the magnitude of the normal force exerted by the ground on the toboggan (a) equal to the total weight of the woman plus the toboggan, (b) greater than the total weight, (c) less than the total weight, or (d) possibly greater than or less than the total weight, depending on the size of the weight relative to the tension in the rope?
(a) Find the tension in each cable supporting the 6.00 102-N cat burglar in Figure P4.35. (b) Suppose the horizontal cable were reattached higher up on the wall. Would the tension in the other cables increase, decrease, or stay the same? Why? Figure P4.35
A worker pulls a crate of mass, m, via a uniform, massless cable that is attached to the crate at an angle, θ, above the horizontal. The resultant tension in the cable is T. What is the normal force acting on the crate? a. mg b. mg + Tsinθ c. mg - Tcosθ d. mg - Tsinθ e. Tsinθ
A block of weight 75N is on a inclined surface with angle of 18⁰ with the horizontal. what is its maximum static frictional force that prevents it from sliding.a. fs max = 35.234 Nb. fs max = 74.432 Nc. fs max⁡ = 23.176 Nd. fs max⁡ = 45.276 N
A box rests on a frozen pond, which serves as a frictionless horizontal surface. If a fisherman applies a horizontal force with magnitude 48.0 N to the box and produces an acceleration of magnitude 2.20 m/s2, what is the mass of the box?
Two blocks each of mass m = 3.50 kg are fastened to thetop of an elevator as in Figure P4.56. (a) If the elevator has anupward acceleration a = 1.60 m/s2, find the tensions T1 andT2 in the upper and lower strings. (b) If the strings can withstanda maximum tension of 85.0 N, what maximum accelerationcan the elevator have before the upper string breaks?
What static frictional force is exerted on a couch by the floor if the couch weighs 500 N, the static frictional coefficient between it and the floor of 0.5, and you are pushing on it with a 100 N horizontal force? A)100 N B)250 N C)0 N d)600 N