A particular mixture was seperated into three components usin paper chromatography. the Rf value of dye A is 0.78, the Rf of dye B is 0.43 and the Rf of dye C is 0.19. What component of the mixture A,B,C is most attracted in the stationery phase and why?

A particular mixture was seperated into three components usin paper chromatography. the Rf value of dye A is 0.78, the Rf of dye B is 0.43 and the Rf of dye C is 0.19. What component of the mixture A,B,C is most attracted in the stationery phase and why?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter33: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 33.12QAP

See similar textbooks

Related questions

Q: 8. A mixture of five alkyl iodides is separated by gas chromatography using a column packed with…

A: To find out the resolution of the following peaks. (a) 2 and 3 (b) 4 and 5 (c) 5 and 6

Q: What are the similarities and differences between a chromatogram from an HPLC with a diode array…

A: A chromatogram formed after chromatography technique. A chromatography is a technique to separate…

Q: Suppose the distance a compund moved in a paper chromatography experiment was 30 millameters and the…

A: We have to calculate the Rf value when in paper chromatography, the distance moved by the compound…

Q: Based on the chromatograms, Symmetry C18 (top) is less selective than Symmetry Shield RP18 (bottom)…

A: In general, Symmetry Shield RP18 columns feature Water patented embedded polar group technology that…

Q: A student has a green dye mixture on which she performs a TLC experiment with a silica gel plate and…

A: Rf value is the retention factor which is defined as the ratio of distance travelled by the solute…

Q: In the IR Spectroscopy, describe the sample preparation techniques for: 1) solid, 2) liquid, 3) gas…

A: The cells for the sampling in IR are made up of NaCl or KBr. The glass cells cannot be used for this…

Q: Which of the following is best to use to separate butanol from the volatile mixture? O a. Affinity…

A: chromatography used to separate butanol from the volatile mixture

Q: In Thin Layer Chromatography，why does the least polar of the analytes （biphenyl）have a higher Rf…

Q: 1. Why do we use relative and not absolute retention times to characterize separated components?…

A: Retention time refers to the time that is spent by the solute in the stationary phase. The greater…

Q: Match Column A with Column B. As the molar absorptivity increases, the concentration of caffeine_ A.…

A: Since you have posted questions with multiple sub-parts, we are entitled to answer the first 3 only.…

Q: When naphthalene, butyric acid, and phenyl acetate are separated using dichloromethane as the…

A: The given compounds are naphthalene, butyric acid, and phenyl acetate. The TLC plate separate the…

Q: Is it possible to detect metal complexes of organic acids with thin layer chromatography?

A: Thin layer chromatography, abbreviated as TLC, is used to identify the element or compound present…

Q: Thin Layer Chromatography why the non-polar compounds move up the plate most rapidly (higher Rf…

A: TLC is most useful technique to know the extent of the reaction .And the no of compound present in…

Q: In a thin layer chromatography experiment, a plate of length 8.67 cm was used and a horizontal line…

A: Retention factor (Rf) is defined as the ratio of the distance travelled by the compound (dc) to the…

Q: do you think that a dye with a high retention factor is more soluble or less souluble in the solvent…

A: Retention factor is defined as the ratio of the distance travelled by the solute solution to the…

Q: Can the following two molecules be seperated by column chromatography or recrystalization? Explain

A: Recrystallization is used to determine the structure based on the melting point of the crystals.…

Q: Analysis of an unknown plant extract yield two peaks X and Y in a chromatogram, 15.65 and 17.03 min…

Q: Match column A with Column B. Given: Samples were spotted on the TLC plate and after performing the…

A: This question is related to Thin Layer Chromatography. Thin-layer chromatography (TLC) is a…

Q: 7. Later, we will cover mass spectrometry, and will likely also mention a combined analytical…

A: Interpretation- To explain that how gas chromatography - mass chromatography is better at solving…

Q: Explain briefly the differences in Rf values of the pigments that you have separated from spinach…

A: Due to technical error ,unable to provide you the solution. Please resubmit the question once again

Q: A 50 ml aqueous sample containing 0.015 M amine (Ka = 3.16 x 10-9) was adjusted to pH 9.0 and then…

A: Liquid - liquid extraction

Q: HPLC VFA analysis - why do I get so different peaks for very similar samples?

A: Volatile fatty acids are formed during microbial fermentation of organic matter and are present in a…

Q: Liquid column chromatography on alumina would separate p-nitrotoluene and p-nitroaniline O A. with…

Q: For Fluorenonce and benzoic acid 1. Which compound would you expect to be the top spot on the TLC…

A: The polar compounds are known for the presence of polar functional groups such as alcohol (-OH) or…

Q: a pigment in the thin layer chromatography traveled beyond or farther than the solvent front.…

A: As a pigment in the thin layer chromatography traveled beyond or farther the solvent front therefore…

Q: Would you expect that changing the solvent will change the Rf value of the specific solute? Why? 6.…

A: 5) on changing the solvent, the Rf value will change because the polarity of the solvent will change…

Q: What information is displayed in a reconstructed total ion chromatogram, selected ion monitoring,…

Q: Why does silanization reduce tailing of chromatographic peaks?

A: Given observation, Silanization reduces tailing of chromatographic peaks.

Q: If the stationary phase and the compound being tested are both polar, will the retention factor (Rf)…

A: Given that both the stationary phase and the compound being tested are polar.

Q: In chromatographic separations the components in a mixture to separate into zones a O all of the…

A: Chromatography is a separation and identification technique of components of a given mixture.

Q: Why is sodium thiosulfate added in NI-DMG

A: Generally in industry nickel is determined by DMG (dimethyl glyoxime) gravimetric analysis. This…

Q: Why does a molecularly imprinted polymer selectively bind a desired analyte?

A: Molecularly imprinted polymer selectively bind a desired analyte has to be explained.

Q: A thin layer chromatography experiment is planned to determine the Rf values of four compounds. List…

A: Silica gel is polar in nature. Polar compounds bind to silica gel in thin layer chromatography to a…

Q: What solvent should be used for the TLC separation of an A/B mixture

A: Given : Compound A had an Rf value of 0.35 in pentane and 0.45 in diethyl ether. Compound B exhibits…

Q: When LC is coupled with mass spectrometry (MS), what are the advantages (compared to LC only) in…

A: LC-MS is an analytical technique that involves physical separation of target compounds (or analytes)…

Q: Using thin-layer chromatography showed that the black dye used in a brand of writing ink contained…

A: The Rf value is defined as the ratio of the distance moved by the solute and the distance moved by…

Q: 4. The paper chromatogram of an unknown mixture is shown below: final solvent level 5.3 cm 6.0 cm B…

Q: Ferritin (molecular mass 450 000), transferrin (molecular mass 80 000), and ferric citrate were…

A: Fraction of elute = 0.65 mL Elution volume of Ferritin peak = 22 x 0.65 mL = 14.3 mL Length of…

Q: The following chromatographic peaks indicate the undesirable interaction and separation that taken…

A: Abnormal chromatographic peaks:

Q: In thin layer chromatography, changing the mobile phase will alter the Rf value of a compound. O…

A: This can be solved as follows

Q: Using thin-layer chromatography showed that the black dye used in a brand of writing ink contained…

Q: culate the selectivity factor (a) for the peak pairs of 1,2 and 3,4 and 5,6 in the chromatogram…

Q: True of false? 1. Raman Spectroscopy can be used in the airport to detect the presence of Alcohol in…

A: To find : True or false. Solution : We will look all the statement one by one.

Q: Explain your reasons for choosing which solvent would be most effective in separating the green from…

A: From the retention value, it is clear that in mobile phase I the Rf values for both green and blue…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Mass spectrometry is an extremely versatile detection system for GC. However, interfacing an HPLC system to a mass spectrometer is a much more difficult task. Describe the major reasons why it is more difficult to combine HPLC with mass spectrometry than it is to combine GC with mass spectrometry.
A particular mixture was seperated into three components usin paper chromatography. the Rf value of dye A is 0.78, the Rf of dye B is 0.43 and the Rf of dye C is 0.19. What component of the mixture A,B,C is most soluble in the mobile phase and why?
Using thin-layer chromatography showed that the black dye used in a brand of writing ink contained blue, red, orange and yellow components. The Rf values of these substances using ethanol as the solvent are 0.63, 0.37, 0.79 and 0.16, respectively. How far apart would the blue and yellow components be after the solvent front had moved 7.5 cm from the origin?
IN GC, What effect does changing from a temperature ramp to an isothermal temperature program have on resolution of peaks at the beginning of the chromatogram versus the end of the chromatogram. Consider molecular weight and boiling point of the analytes.
A thin layer chromatography experiment is planned to determine the Rf values of four compounds. List the following compounds in order of increasing Rf values from shortest to longest. (If B is shortest, then A, C, and D is longest, enter BACD )
Thin Layer Chromatography why the non-polar compounds move up the plate most rapidly (higher Rf value), whereas polar substances travel up the TLC plate slowly or not at all (lower Rf value)? Please help me explain this question! Thank you so much!
Explain in detail the advantages in the use of tandem mass spectrometry by referring to the analysis of aspirin (acetylsalicylic acid) with electrospray mass spectrometry combined with chromatography
1. In the chromatography plate there are three solutes that move forward: 2cm, 2.5cm and 3cm Which will be more polar? 2. What information does the infrared of the spectroscospy offer?
I extracted caffeine by using chloroform and magnesium sulfate to dehydrate the organic phase. I got crude caffeine just by solvent evaporation at room temperature. However, I wanted to conduct Raman spectroscopy measurements but I did not get the characteristic peaks. I think that it has to be whit chloroform presence. So I let the crude caffeine 24h at 65 degrees but still I did not get any peak. What can I use to rinse my crude caffeine extract to remove all chloroform molecules? Or what is wrong with my extraction?
a) How does mass spectrometry identify organic compounds? b) Describe the use and function of Quadrupole Analyzers ? c) One of the ionization sources for atomic mass spectrometry (MS) is Inductively Coupled Plasma (ICP). Explain the need for an interface in the ICPMS instrument and how can it be achieved.
What characteristic makes a photodiode array spectrophotometer suitable for measuring the spectrum of a compound as it emerges from a chromatography column and a dispersive spectrophotometer not suitable? What is the disadvantage of the photodiode array spectrophotometer?
In a thin layer chromatography experiment, a plate of length 8.67 cm was used and a horizontal line was made at 1.11 cm above the bottom of the plate. After running the experiment (developing and drying), a spot was observed at 4.59 cm from the bottom of the plate, and the solvent front was 7.56 cm from the bottom of the plate. What is the Rf value?