A power suppply having 220 V AC input and two fixed outputs as 10 V DC and 20 V DC is requested from you. For this purpose, a transformer with 220 V AC input / 15 V AC output, some capacitors, some silicon diodes, and zener diodes are presented. a) Design your power supply and point out DC voltage outputs b) Explain the operation of the network and all the components used in the design c) Calculate and plot input and output signals of the network Hint: For design, remember clipper, clamper, rectifier,voltage multiplier and zener circuits

A power suppply having 220 V AC input and two fixed outputs as 10 V DC and 20 V DC is requested from you. For this purpose, a transformer with 220 V AC input / 15 V AC output, some capacitors, some silicon diodes, and zener diodes are presented. a) Design your power supply and point out DC voltage outputs b) Explain the operation of the network and all the components used in the design c) Calculate and plot input and output signals of the network Hint: For design, remember clipper, clamper, rectifier,voltage multiplier and zener circuits

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 16RQ: Explain the difference between cumulative- and differential-compounded connections.

See similar textbooks

Similar questions

In an R-L parallel circuit, IT=1.25 amps, R=1.2k, and XL=1k. Find IR
Subject : ELECTRONIC CIRCUIT ANALYSIS AND DEVICES Please give the DC ANALYSIS circuit and AC EQUIVALENT CIRCUIT of this problem before proceeding to find letters a, and b. (Note : Neglect Vbe)
You are designing a power supply for a 100 W high-quality audio amplifier that will drive an 8 Ohm speaker. The datasheet says you need approximately a 75 V Vcc rail to properly supply the transistor power stage. To get the excellent performance you expect, you aim for 1% ripple, and choose a design that minimizes the amount of capacitance required to reduce cost. Assume the diode drop is 0.7 V, and the input AC voltage available from a transformer is 75 sin(377t) V. a)How much capacitance do you need (a real-world value in μF) ? b)What is the ripple voltage at 10 W output power? c)What should be the minimum voltage rating of the capacitor(s)?
Subject : ELECTRONIC CIRCUIT ANALYSIS AND DEVICES Please give the DC ANALYSIS CIRCUIT and AC EQUIVALENT CIRCUIT of this problem before proceeding to find letter c. (Note : Neglect Vbe)
ELECTRONIC CIRCUIT ANALYSIS AND DESIGN Please give the step-by-step solution for this problem. Thank you! Note: Neglect Vbe
For the following scenario derive the required mathematical model in the form of a differential equation:
Create a circuit of the Combinational Networks of the combination of BJT and FET with AC and DC supply. Solve it and show complete solution.
Draw the AC equivalent circuit and find Zi, Zo, Av, Ai (ignore the effect of To). Show all the necessary derivations and label all the parameters properly.
The filter is a device that allows passing the dc component of the load and blocks the ac component of the rectifier output. Thus the output of the filter circuit will be a steady dc voltage. Write any two types of filter circuit in rectifier providing the necessary Sketch, explanation
Draw the DC equivalent circuit and find re, VB, Vc, VE, VEc, VcB. Show all the necessary derivations and label all the parameters properly.
Determine the differential equation that define the loop connected to the voltage source.
Devices that pass the signal from its source to the measurement device without aphysical connection by using transformer, optical or capacitive coupling technique arecalled?Select one a. bridgesb. isolatorsc.filters d.rectifiers