A pump draws water from a pit that is 11.5 m deep at a rate of 685 kg/min. The water ejects above the ground surface at a speed of 20.0m/s, making a vertical fountain. 1. What is the power output of the pump 2. How high is the fountain? Ignore air resistance

A pump draws water from a pit that is 11.5 m deep at a rate of 685 kg/min. The water ejects above the ground surface at a speed of 20.0m/s, making a vertical fountain. 1. What is the power output of the pump 2. How high is the fountain? Ignore air resistance

Name: A pump draws water from a pit that is 11.5 m deep at a rate of 685 kg
Uploaded: 2024-03-20T06:57:25.000Z
Channel: Bartleby
Description: A pump draws water from a pit that is 11.5 m deep at a rate of 685 kg/min.The water ejects above the ground surface at a speed of 20.0m/s, making avertical fountain.1. What is the power output of the pump2. How high is the fountain? Ignore air resis

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter3: Energy And Conservation Laws

Section: Chapter Questions

Problem 37P: . A particular hydraulic pile driver uses a ram with a mass of 1040 kg. If the maximum pile energy...

See similar textbooks

Similar questions

. In the annual Empire State Building race, contestants run up 1,575 steps to a height of 1,050 ft. In 2003, Australian Paul Crake completed the race in a record time of 9 min and 33 S, Mr., Crake weighed 143 lb (65 kg) , (a) How much work did Mr., Crake do in reaching the top of the building? (b) What was his average power output (in ft-lb/s and in hp)?
(a) What is the average useful power output of a person who does 6.00106 J of useful work in 8.00 h? (b) Working at this rate, how long will it take this person to lift 2000 kg of bricks 1.50 m to a platform? (Work done to lift his body can be omitted because it is not considered useful output here.)
The person in Figure 7.33 does work on the lawn mower. Under what conditions would the mower gain energy? Under what conditions would it lose energy?
What does work on a shuffleboard puck as it slides to rest? Why is the board dusted, and how does this affect work?
Give an example of something think of as work in everyday circumstances that is not work in the scientific sense. Is energy transferred or changed in form in your example? If so, explain how this without doing work.
. A particular hydraulic pile driver uses a ram with a mass of 1040 kg. If the maximum pile energy is 11,780J, how high must the ram he raised to achieve this value? Assuming it takes 0.62 s for the pile driver’s winch motor to raise the ram at a constant speed to this height, what is the power output by the motor in completing this task? Express your answer in both watts and horsepower.
(a) Find the useful power output of an elevator motor that lifts a 2500-kg load a height of 35.0 m in 12.0 s, if it also increases the speed from rest to 4.00 m/s. Note that the total mass of the counterbalanced system is 10,000 kg—so that only 2500 kg is raised in height, but the full 10,000 kg is accelerated. (b) What does it cost, if electricity is $0.0900 per kW h?
A student has the idea that the total work done on an object is equal to its final kinetic energy. Is this idea true always, sometimes, or never? Ii it is sometimes true, under what circumstances? If it is always or never true, explain why.
Integrated Concepts (a) What force must be supplied by an elevator cable to produce an acceleration of 0.800 m/s2 against a 200-N frictional force, if the mass of the loaded elevator is 1500 kg? (b) How much work is done by the cable in lifting the elevator 20.0 m? (c) What is the final speed of the elevator if it starts from rest? (d) How much work went into thermal energy?
In Chapter 7, the work-kinetic energy theorem, W = K, was introduced. This equation states that work done on a system appears as a change in kinetic energy. It is a special-case equation, valid if there are no changes in any other type of energy such as potential or internal. Give two or three examples in which work is done on a system but the change in energy of the system is not a change in kinetic energy.
Describe a situation in which a force is exerted for a long time but does no work. Explain.
Calculate the power output needed for a 950-kg car to climb a 2.00° slope at a constant 30.0 m/s while encountering wind resistance and friction totaling 600 N. Explicitly show how you follow the steps in the Problem- Solving Strategies for Energy.