A pump receives water from a tank. If the pump needs 24 n of NPSHA, how high  must the water level be above the pump centerline if the water saturated at 1724  kpa ? The friction loss in the pipe averages 0.3m for each 6m height and the flow  is 23 lps in a 15024 cm id pipe.

Q: 4. In a pumping system handling water, the surface level of water in the open suction tank is 3m…

A: Answer: (a) The total head loss due to friction is 25.14 m. (b) The total dynamic head is 50.14 m.…

Q: The pump-turbine system in Fig. P3.174 draws water fromthe upper reservoir in the daytime to produce…

A: Given data as per question  flow rate = 15000 gal/min friction head loss = 17 ft z1= 159 ft z2 = 25…

Q: Water (10°C) is flowing at a rate of 0.35 m³/s, and it is assumed that h = 2V2/2g from the reservoir…

A:

Q: hen a pump with a suction and discharge pressure of 125 kPa and 409 kPa are used, the flow rate is…

A: Given:P1=125 kPaP2=409 kPaQ=30 L/s =30*10-3 m3/s

Q: Q3) A pipe ofr 10 km length and connects tow reservoirs having a difference of wa level 25 m. If an…

A:

Q: Water (10°C) is flowing at a rate of 0.35 m3/s, and it is assumed that h, = 2V2/2g from the…

A: Given data: The temperature of the water is T = 10 CThe flowing rate of water is Q = 0.35 m3/sThe…

Q: In the given figure the pipe entrance is sharp-edged. There is threaded globe valve. If the flow…

A:

Q: Water is stored in an elevated reservoir. To generate power, water flows from this reservoir down…

A: given data; pressure (P1)=172.4KPa=172.4*103Paheight above from datum(Z1)=89.5mheight below from…

Q: Consider incompressible , frictionless flow of water in a vertical piping. The pressure is 240 kPa,…

A: Given Data: Pressure at 2 m above the ground, P1=240 kPa

Q: he fluid in the lower tank is pumped into the upper tank with the help of a centrifugal pump. The…

A: As it is not mentioned that which 3 parts need to be solved, we have solved first three parts of the…

Q: A pump has a displacement of 65 cm³/rev and is driven by a 37.3 kW electric motor at 1775 rpm. If…

A:

Q: Aa hydraulic turbine receive water from a reservoir at elevated of 50 m above it. What is the…

A:

Q: Water at 20°C is to be pumped through 2000 ft of pipe fromreservoir 1 to 2 at a rate of 3 ft3/s, as…

A: Given data as per the question Flow rate =  3 ft3/s The diameter of pipe = 6 in Efficiency of pump =…

Q: 1. Water is draining from an outlet located h below the free surface. What is the minimum h that…

A: Using Bernoulli equation at section 2 and 3 velocity of jet at section 2 can be determined Use…

Q: A straight 10-cm commercial-steel pipe is 1 km long and is laid on a constant slope of 5°. Water at…

A:

Q: You have a 550 W pump with 70% efficiency available. Is it possible to use this pump to carry 10…

A: Given data as per question power of pump =550 w Efficiency =70% Inside diameter of pipe =4.7 cm…

Q: Pressurized air 2.5 m A pressurized tank is filled with water as shown in figure. The absolute…

A: Here,  Let us take values before outlet be represented by subscript 1 and values after outlet be…

Q: Two chambers, Chamber 1 and Chamber 2 where pressure at chamber 1 p1=70 kPa, at chamber 2 the…

A:

Q: A hydraulic ram pump lifts 0.005 m3/s of water to a tank 20 m above the ram through a 80 m long and…

A: Given data: The height of the supply tank from ram h = 3 mThe length of the delivery pipe is L = 80…

Q: Here, air (105 kPa) at 37 degrees celcius is flowing upward in a 6cm diamater inclined duct, at a…

A:

Q: Q5) A pump of 20 kW power is discharge oil to the over tank as shown in fig. (5). If efficiency of…

A: A manometer is a device that measures the pressure (static pressure) exerted by a still liquid or…

Q: 19. A centrifugal pump delivering 0-04 cumec of water to a height of 20 metres through a 10 cm…

A: The power needed to drive the pump is to be calculated. The power needed to drive the pump is also…

Q: In our house water pipe line with diameter of 2.25cm is connected to shower head that has 40 holes.…

A:

Q: A smooth pipe flow has a turbine installed between two different size pipes, where d1 = 2.2 cm and…

A:

Q: The pump-turbine system shown draws water from the upper reservoir in the daytime to produce power…

A:

Q: A horizontal pipe has an abrupt expansion from D1 = 5 cm to D2 = 10 cm. The water velocity in the…

A: The kinetic energy correction factor at both the inlet and the outlet =1.06…

Q: ME Board - October 2002 Water is to be raised to a height of 25 meters at 20 kg/s. Inlet diameter is…

A:

Q: air pressure above the water is . The required NPSH of the pump is 8.2 m. The suction pipe has a…

A:

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of varg = 1.15 m/s.…

A:

Q: Pump Horsepower in Brine System. A pump pumps 0.200 ft3/s of brine solution having a density of 1.15…

A: Given DataQ=200 ft3/sρ=1.15 g/cm3∑F=18 ft lbf/lbm=57.9 ft2/sη=70%H=75ftg=32.15ft/s2

Q: A 50 kw motor is used to drive a fan that has a total head of 130m. If fan efficiency is 75%, what…

A:

Q: A pump draws 30-°C water at 0.5 liters per second from a pressurized tank where the air pressure…

A:

Q: 3. A water from Agno River is pumped at 13.3 L/s using a submerged pump at an efficiency of 78% that…

A: Consider Bernoulli’s equation for steady flow between the points (1) and (2).…

Q: .Water is stored in a reservoir 5 m deep and 100 m in diameter. It is pumped through a 0.3 m…

A: To determine the maximum height to which the water can be raised.

Q: A water pump has one inlet and two outlets as shown in the P = 500 kPa D = 6 cm figure , all at the…

A:

Q: 35. Find the exit pressure for an airplane engine (A, = 2.79 A2, P1 = 102 kPa, T1 = 13 °C, v1 = 119…

A: Here we have the following equationp1A1-p2A2-Fth=m˙v2-v1Now…

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A:

Q: A horizontal pipe carries cooling water at 10°C for a thermal power plant. what is the pressure in…

A:

Q: Water is delivered from a truck (shown in Figure 1b) to a maximum 18m height above the hydrant. It…

A:

Q: re, a flow rate of 2 m3/s is active in a pipe, as seen in the attached figure. What is the expected…

A:

Q: A hydro-electric plant discharge water at the rate of 0.75 m3/s and enters the turbine at 0.35 mps…

A:

Q: A pump increases the pressure of water from 100 kPa to 900 kPa to an elevation of 35 m. The inlet…

A: Given data: Inlet pressure of water, Pin = 100 kPa. Outlet pressure of water, Pout = 900 kPa.…

Q: 2. In the figure shown, a liquid with specific gravity of 0.85 is pumped from reservoir A to tank B…

A:

Q: A horizontal pipe has an abrupt expansion from D1 = 8 cm to D2 = 16 cm. The water velocity in the…

A: Diameter of the inlet pipe D1 = 8 cm = 0.08m Diameter of the outlet pipe D2 = 16 cm = 0.16m Velocity…

Q: Q3. A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges…

A:

Q: Water is drained from a large reservoir using two horizontal pipes connected in series as shown in…

A: Given data: Water tank level = 18 m There is 20 m pipe with diameter 0.1 m There is a 35 m pipe with…

Q: four-stage centrifugal pump has four identical impellers, keyed to the same shaft. The shaft is…

A: Fluid Mechanics: It is a branch of physics in which concerns with mechanics of fluids & forces…

Q: N2O expands isentropically through a duct from p1 =200 kPa and T1 = 250°C to a downstream section…

A: Since you have asked question with multiple parts we will solve first three subparts for you if you…

Q: Q1: Find the pump efficiency if the pressure difference across the pump is 230 kPa. If the outlet…

A: Given:  P2 - P1 = 230 kPa D2 = 7 cm = 0.07 m D1 = 14 cm = 0.14 m m = 50 kg/s Efficiency of motor =…