A six cylinder engine has a 1 5 3 6 2 4 firing order. Technician A says that after cylinder number 1 begins its intake stroke, the crankshaft will have to travel 240° before cylinder number 3 begins its intake stroke. Technician B says that when cylinders number 3 and 4 are at TDC, cylinders number 5 and 2 are at BDC. Who is right? And explain why. a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

A six cylinder engine has a 1 5 3 6 2 4 firing order. Technician A says that after cylinder number 1 begins its intake stroke, the crankshaft will have to travel 240° before cylinder number 3 begins its intake stroke. Technician B says that when cylinders number 3 and 4 are at TDC, cylinders number 5 and 2 are at BDC. Who is right? And explain why. a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

Automotive Technology

7th Edition

ISBN:9781337794213

Author:ERJAVEC, Jack.

Publisher:ERJAVEC, Jack.

Chapter11: Lower End Theory And Service

Section: Chapter Questions

Problem 6MC: Which of the following are not typically found in the block of a modern engine? a. Pistons b....

See similar textbooks

Similar questions

What provisions are usually included on tractor engines to aid in the correct timing of the camshaft?
A six-cylinder engine has a 1 5 3 6 2 4 firing order. Technician A says that after cylinder number 1 begins its intake stroke, the crankshaft will have to travel 240° before cylinder number 3 begins its intake stoke. Technician B says that when cylinder number 3 and 4 are at TDC, cylinders number 5 and 2 are at BDC. Who is correct and explain why? Technician A Technician B Both A and B Neither A nor B
What kind of crankshaft should you use for a v-type engine with 12-cylinder assembly?
In most of internal combustion engines, crankshaft bearing is Select the correct answer below: A. Ball bearings B. Hydrodynamic journal bearing C. Roller Bearings D. Hydrostatic journal bearing
Tech a says that the push on the piston top during the power stroke is transferred to the crank shaft through the connecting rod. Tech b states that the power is transferred from the piston through the valve train to the camshaft. Who is correct?
What is the main difference between a crankshaft and a cam shaft
4-stroke diesel engine, when running at 2000 rpm has an injection duration of 1.5 ms. What is the corresponding duration of the crank angle in degrees?
Draw the p-V diagram and typical valve timing diagram for a two stroke IC engine.
explain 4 stroke cycle in the correct order that it happend
In a four-cylinder engine with a firing order of 1-3-4-2, what stroke is piston #4 on when #1 is on its compression stroke?
the ... motion of the pistons is converted into the ... motion of the crankshaft
The crank radius of a single-cylinder IC engine is 60 mm and the diameter of the cylinder is 80 mm. What is the swept volume of the cylinder?