A student dissolves 11.9 g of sodium chloride (NaCl)in 250. g of water in a well-insulated open cup. He then observes the temperature of the water fall from23.0 °C to 22.0 °C over the course of 6.9 minutes.Use this data, and any information you need from the ALEKS Data resource, to answer the questions below about this reaction:+NaCI (s)Na" (ag) + CI (ад)You can make any reasonable assumptions about the physical properties of the solution. Be sure answers you calculate using measured data are rounded to thecorrect number of significant digits.OlNote for advanced students: it's possible the student did not do the experiment carefully, and the values you calculate may not be the same as the known andpublished values for this reaction.exothermicx10Is this reaction exothermic, endothermic, or neither?endothermicneitherIf you said the reaction was exothermic or endothermic, calculate the amount ofheat that was released or absorbed by the reaction in this case.kJkJCalculate the reaction enthalpy AHper mole of NaCl.rxnmolO O O

Answered: Image /qna-images/answer/6b289402-dddb-42c0-b921-c1c19d704af4.jpg

Answered: A student dissolves 11.9 g of sodium…

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter12: Thermodynamic Processes And Thermochemistry

Section: Chapter Questions

Problem 43P

See similar textbooks

Similar questions

The formation of aluminum oxide from its elements is highly exothermic. If 2.70 g Al metal is burned in pure O2 to give A12O3, calculate how much thermal energy is evolved in the process (at constant pressure).
The enthalpy of vaporization for water is 40.65 kJ mol-1. As a design engineer for a project in a desert climate, you are exploring the option of using evaporative cooling. (a) If the air has an average volumetric heat capacity of 0.00130 J cm-3 K-1, what is the minimum mass of water that would need to evaporate in order to cool a 5 m? 5 m room with a 3 m ceiling by 5°F using this method? (b) Is this a spontaneous or nonspontaneous process?
A pot of cold water is heated on a stove, and when the water boils, a fresh egg is placed in the water to cook. Describe the events that are occurring in terms of the zeroth law of thermodynamics.
9.53 Using these reactions, find the standard enthalpy change for the formation of 1 mol of PhO(s) from lead metal and oxygen gas. PbO(s)+C(graphite)Pb(s)+CO(g) H = 106.8 kJ 2C(graphite)+O2(g)2CO(g) H= -221.0 kJ If 250 g of lead reacts with oxygen to form lead(II) oxide, what quantity of thermal energy (in kJ) is ahsorhed or evolved?
You did an experiment in which you found that 59.8 J was required to raise the temperature of 25.0 g of ethylene glycol (a compound used as antifreeze in automobile engines) by 1.00 K. Calculate the specific heat capacity of ethylene glycol from these data.
Sodium reacts violently with water according to the equation Na(s) + H2O() NaOH(aq) + H2(g) Without doing calculations, predict the signs of rH and rS for the reaction. Verify your prediction with a calculation.
When 1.000 g of gaseous butane, C4H10, is burned at 25C and 1.00 atm pressure, H2O(l) and CO2(g) are formed with the evolution of 49.50 kJ of heat. a Calculate the molar enthalpy of formation of butane. (Use enthalpy of formation data for H2O and CO2.) b Gf of butane is 17.2 kJ/mol. What is G for the combustion of 1 mol butane? c From a and b, calculate S for the combustion of 1 mol butane.
As the gas trapped in a cylinder with a movable piston cools, 1.34 kJ of work is done on the gas by the surroundings. If the gas is at a constant pressure of 1.33 105 Pa, what is the change of volume (in L) of the gas?
When 1.000 g of ethylene glycol, C2H6O2, is burned at 25C and 1.00 atmosphere pressure, H2O(l) and CO2(g) are formed with the evolution of 19.18 kJ of heat. a Calculate the molar enthalpy of formation of ethylene glycol. (It will be necessary to use data from Appendix C.) b Gf of ethylene glycol is 322.5 kJ/mol. What is G for the combustion of 1 mol ethylene glycol? c What is S for the combustion of 1 mol ethylene glycol?
Coal is used as a fuel in some electric-generating plants. Coal is a complex material, but for simplicity we may consider it to be a form of carbon. The energy that can be derived from a fuel is sometimes compared with the enthalpy of the combustion reaction: C(s)+O2(g)CO2(g) Calculate the standard enthalpy change for this reaction at 25C. Actually, only a fraction of the heat from this reaction is available to produce electric energy. In electric generating plants, this reaction is used to generate heat for a steam engine, which turns the generator. Basically the steam engine is a type of heat engine in which steam enters the engine at high temperature (Th), work is done, and the steam then exits at a lower temperature (Tl). The maximum fraction, f, of heat available to produce useful energy depends on the difference between these temperatures (expressed in kelvins), f = (Th Tl)/Th. What is the maximum heat energy available for useful work from the combustion of 1.00 mol of C(s) to CO2(g)? (Assume the value of H calculated at 25C for the heat obtained in the generator.) It is possible to consider more efficient ways to obtain useful energy from a fuel. For example, methane can be burned in a fuel cell to generate electricity directly. The maximum useful energy obtained in these cases is the maximum work, which equals the free-energy change. Calculate the standard free-energy change for the combustion of 1.00 mol of C(s) to CO2(g). Compare this value with the maximum obtained with the heat engine described here.
Write the balanced chemical equation for the combustion of methane, CH4(g), to give carbon dioxide and water vapor. Explain why it is difficult to predict whether S is positive or negative for this chemical reaction.
The combustion of methane can be represented as follows: a. Use the information given above to determine the value of H for the combustion of methane to form CO2(g) and 2H2O(l). b. What is Hf for an element in its standard state? Why is this? Use the figure above to support your answer. c. How does H for the reaction CO2(g) + 2H2O (1) CH4(g) + O2(g) compare to that of the combustion of methane? Why is this?

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781337399074

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS