A student titrates 0.101mL of citric acid solution using the standardized 0.1M solution (use the exact concentration calculated from the previous titration problem). The sample required 0.819mL of NaOH solution to reach the end point. Given the following chemical equation(unbalanced). NaOH + H3C6H5O7 → Na+ + H2O + C6H5O73- Calculate the mmoles of citric acid in the 0.101mL samp

A student titrates 0.101mL of citric acid solution using the standardized 0.1M solution (use the exact concentration calculated from the previous titration problem). The sample required 0.819mL of NaOH solution to reach the end point. Given the following chemical equation(unbalanced). NaOH + H3C6H5O7 → Na+ + H2O + C6H5O73- Calculate the mmoles of citric acid in the 0.101mL samp

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter3: Statistical Tests With Excel

Section: Chapter Questions

Problem 6P

See similar textbooks

Similar questions

A titrant solution of KMnO was standardized with 0.2000 grams of Na2C2O4 and consumed 27.75 mL to reach end point. Calculate the standardized NORMAL concentration of the titrant.
a 10g soil sample was gently stirred with 250 ml of 1.0 M CH3COO(NH4) solution for 24 h and centrifuged to separate the solution. The solution recovered after centrifugation was titrated with distilled water to a volume of 1 liter and analyzed for cations. Analytical results showed that the solution contained 20 mg/L Ca, 2 mg/L Mg, 1 mg/L K, and 0.5 mg/L Na. Calculate the number of cation exchange equivalents and express it in meq/100 g of soil
A commercial vinegar was analyzed by titration to determine the percent acetic acid. Briefly, 10.00 mL of vinegar sample was diluted to 100. mL solution in a volumetric flask. A 25.00 mL aliquot from the diluted vinegar required 25.55 mL of 0.1005 M sodium hydroxide to reach the phenolphthalein endpoint From this experiment which is the standard solution used in titration? CH3COOH NaOH NaCH3COO C20H14O4
Normality is same as Molarity for sodium hydroxide and normal = molar (for NaOH) Normality of sodium hydroxide = 0.10395N (normal) or Molarity of NaOH = 0.10395M (molar) Volume of NaOH consumed during the titration = 21.87 mL Mol wt of Naproxen = 230.26 g/mol Weight of Naproxen ds (i.e., sample) = 0.534g Calculate the % Purity (dried-basis) of Naproxen ds, given that the LOD results for Naproxen = 1.0% a 97.0 b 98.0 c 98.5 d 99.0 e 99.5 f none of the other answers.
Two trials made in the determination of the Molarity of NaOH solution gave the following results. Trial I: 0.0986M Trial 2: 0.0979M Calculate the: 1. Mean Molarity 2. Precision in ppt 3. Molarity of HCl solution if 23.00 mL of the NaOH solution is required to titrate 30.00 mL of HCl. Please provide a solution to all 3 :)
Add 0.3 M AgNO3 to each of the cold sample solutions until AgCl is observed to coagulate. Determine the approximate amount of needed AgNO3 by calculating the volume that would be required if the unknown were pure NaCl.
42.5 mL of 1.3M KOH are required to neutralize 50.0 mL of H2SO4. This sulfuric acid is further used to standardize NaOH solution. 20mL aliquot of the NaOH solution is obtained and 2 drops of phenolphthalein is added. The initial reading on the buret is 13.2 mL. After the titration, the exact normality of the NaOH solution is found to be 1.254N. (a) What is the molarity of H2SO4? (b) How much of the sulfuric acid is used? (c) What is the final reading on the buret?
Transfer 0.5 mL phenolphthalein to a flask 25 mL KHP. Then transfer 13.2mL NaOH in the KHP that make it be pink. As the picture shows. Now, show a complete calculation for the concentration of the sodium hydroxide solution.
In one trial determination of the concentration of NaOCl in the diluted bleach sample, 10.00 mL of the diluted bleach solution required 29.82 mL of 0.0195 M Na2S2O3 titrant to reach the endpoint. What is the molar concentration of NaOCl in the diluted bleach solution?
The total cation content of natural water is often determined by exchanging the cations for hydrogen ions on a strong acid ion-exchange resin. A 25.00 mL sample of a natural water was diluted to 100.00 ML with distilled water, and 2.06 g of a cation - exchange resin was added. After stirring, the mixture was filtered and the solid remaining on the filter paper was washed with three 15.00 mL portions of water. The filtrate and washings required 16.30 mL of 0.0282 M NaOH to give a bromocresol green end point. a) Calculate the number of millimoles of cation present in exactly 1.00 L of sample. b ) Report the results in terms of milligrams of CaCO3 per liter. Only typed solution.
A 1.458 g primary-standard grade Na2CO3 (MW = 105.99 g/mol) was used to standardize an HCl solution. Solve for the molarity of HCl if 24.81 mL of HCl was used to reach the endpoint.
1. A 1.2-gram sample of lanolin was treated with Wij’s solution and excess potassium iodide solution. The liberated iodine reacted with 30 ml of 0.1 N sodium thiosulfate solution. If the iodine value was determined as 12.69, what is the volume used in blank titration? 2. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value. 3. A 3.50-gram sample of Streptomycin powder was tested for its water content. If the water equivalence factor of the KF reagent was 4.6, what is the percentage water content of the sample if 9.2 ml of the KF reagent was used? 4. A 500mg oil sample is taken from a conical flask and is dissolved in 50mL distilled alcohol. An indicator is added and is then titrated against 0.112N KOH until a slight pink color appears. It took 17.6mL of the titrant to reach the…