A tangential force of 0.004 KN affected the upper surface of a rectangle 5 mm high, 3 cm long and 5 cm wide, on its top surface. Not the shear modulus of elasticity of the body material is 3.33 * 1010 N / m2 Find (1) shearing stress (2) shearing strain (3) the resulting displacement in the direction of the force?

A tangential force of 0.004 KN affected the upper surface of a rectangle 5 mm high, 3 cm long and 5 cm wide, on its top surface. Not the shear modulus of elasticity of the body material is 3.33 * 1010 N / m2 Find (1) shearing stress (2) shearing strain (3) the resulting displacement in the direction of the force?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 73AP: Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m...

See similar textbooks

Similar questions

An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
Can compress stress be applied to a rubber band?
Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod stretches by 0.15mm under some stress, how much does the steel rod stretch under the same stress?
Check Your Understanding Find the compressive stress and strain at the base of Nelson’s column.
Can Young’s modulus have a negative value? What about the bulk modulus?
Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m long and has cross-sectional area 9.1mm2 . If a 10,000N tensile force is applied at each end of the combination, find: (a) stress in each rod; (b) strain in each rod; and, (c) elongation of each rod.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?
A cube made of an unknown material has a dimension of 6 cm on all edges. If the upper face is displaced laterally by 0.1 mm by a force of 2 x 106 dynes acting parallel to the surface, calculate the shear modulus of the material.
A 115 m long steel cable with a cross-sectional area of 1.13 x 10-4 m2 issubjected to a tensile force of 565 N. Find the following:a) the stressb) the strainc) the change in length of the cable
The upper surface of a cube of gelatin, 5.0 cm on a side, is displaced by 0.64 cm by a tangential force. If the shear modulus of the gelatin is 940 Pa, what is the magnitude of the tangential force?
A steel wire of diameter 1 mm can support a tension of 0.2 kN. Determine thediameter of a steel cable to support a tension of 20 kN? A cube made of an unknown material has a dimension of 6 cm on all edges. If theupper face is displaced laterally by 0.1 mm by a force of 2 x 106 dynes acting parallelto the surface, calculate the shear modulus of the material.
The wing of an aircraft is loaded by a torsional moment MT, creating a shear flow. What unit does the shear flow q have?