A wet gas is produced through a two-stage separator system. Separator conditions are 580 psia and 95°F. The stock tank is at 80°F. Gas-oil ratios for separator and stock tank are 98835 sef/STB and 408 scf/STB. The stock-tank liquid has a gravity of 59.3°API. The compositions of the surface production are given in the table below. (a) Calculate the composition of the reservoir gas. (b) Calculate wet gas formation volume factor at reservoir conditions of 2250 psig and 200 °F. (c) Calculate wet gas isothermal compressibility factor at reservoir conditions of 2250 psig and 200 °F. Component Composition Composition Composition

A wet gas is produced through a two-stage separator system. Separator conditions are 580 psia and 95°F. The stock tank is at 80°F. Gas-oil ratios for separator and stock tank are 98835 sef/STB and 408 scf/STB. The stock-tank liquid has a gravity of 59.3°API. The compositions of the surface production are given in the table below. (a) Calculate the composition of the reservoir gas. (b) Calculate wet gas formation volume factor at reservoir conditions of 2250 psig and 200 °F. (c) Calculate wet gas isothermal compressibility factor at reservoir conditions of 2250 psig and 200 °F. Component Composition Composition Composition

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Cereal is being dried in a vertical drier by air flowing countercurrent to the cereal. To prevent breakage of the cereal flakes, some of the exit air from the drier is recycled back to mix with the the moist fresh air. For each 1000 kg/hr of wet cereal fed to the drier, calculate the input of moist fresh air in kg/hr and recycle rate in kg/hr. The available data on stream compositions is (fractions): For water: Fresh air: 0.0132 Wet cereal: 0.200 Exit air: 0.263 Dried Cereal: 0.050 Air entering Dryer: 0.066
A hydrocarbon stream composed of 40 mol% n-butane and 60 mol% n-octane is fed at 100 kmol/h to a flash vessel operating at 5 bar and 145°C. The liquid outlet stream of the flash vessel is then sent to a distillation column with a partial condenser to further separate the components. 90% of the butane in the feed to the column is recovered in the overhead vapor product (distillate), along with small amounts of octane. The bottoms product contains octane which accounts for 75% of the octane in the fresh hydrocarbon feed (to the flash vessel). The condenser and reboiler operating temperatures are 136.7°C and 165.7°C, respectively. Determine the compositions of the liquid outlet stream of the condenser and the vapor outlet stream of the reboiler.
L-lysine is produced by Corynebacterium glutamicum in a bioreactor using glucose as the carbon source and ammonia as the nitrogen source. All streams of this process are aqueous. In the inflow, 8 grams of glucose per 100 grams of flow fluid flowing at a rate of 500 kg / hour is included. The glucose flow rate in the exit steam is 1 kg / hour. The reaction takes place at 25 °c.What is the mole percentage of glucose that was consumed during cell growth inside the bioreactor? -Does the growth of Corynebacterium glutamicum cells inside this bioreactor release or absorbheat? Should heat be supplied to the bioreactor, or removed from, to maintain the operation temperature? I want the solution of both options.
Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator. The evaporator is operated in a vacuum at an evaporation temperature of 80 ° C, and 90% quality steam is supplied at 169.06 kPa. The desired concentration of the final product is 40% total solids. The rate of concentrated product leaving the evaporator is 2000 kg / hour. The specific heat of fruit juice is 4.05 kJ / (kg ° C), and the concentrated product is 3,175 kJ / (kg ° C). Count a. The required steam rate is = Answerkg / hour. b. Steam economy when the condensate temperature is released at 90 ° C. = Answer(kg of water evaporated / kg of steam)
Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to atmosphere. The following properties of benzene are given: 1) Boiling temperature is 353K at 1 atm. 2) MW of benzene is 78.108 kg/kmol. 3) hfg is 393 kJ/kg at 353K. 4) Density is 879 kg/m^3 5) Diffusivity rate (D) is 0.88x10^-5 m^2/s at 298K. Determine the following: A) The mass evaporation rate of benzene knowing that Psat is 0.145 atm and Yf at infinity is zero B) How long does it take to evaporate 0.5 cm^3 of benzene
23 ft^3 of air was drawn from a ventilation duct and measured by means of a dry gas meter. the meter's temperature averaged 60 F and the meter gage pressure was -1.9" H2O. Barometric pressure during the sampling was 752 mm Hg. Calculate the volume in standard cubic feet and in standard cubic meter (25C, atm) this is an ideal gas problem
An open vessel containing liquid water stands in a sealed room measuring 5.0m wide x 4.0m long x 3m high. The temperature of the room is 320K and, over time, some of the liquid water evaporates. Eventually, the liquid water level in the vessel stops changing. a) How many grams of water will be in the humid air within the sealed room? b)A contact lens cleaning system on the market uses an aqueous hydrogen peroxide solution to disinfect the contact lenses. In a few hours, the hydrogen peroxide decomposes to liquid water and oxygen gas in a catalyzed reaction. The vessel in which the reaction occurs has a hole in the top. Use chemical potential to explain how the equilibrium concentration of hydrogen peroxide would be affected if the hole was not present.
A single effect evaporator is used to concentrate 10 000 kg / hr of tomato juice from 5% total solids to 30% total solids. The juice enters the evaporator at 15 ° C. The evaporator is operated on Steam (80% quality) at 143.27 kPa. The vacuum in the evaporator allows the juice to boil at 75 ° C. The specific heat of the dilute material is 4.1 kJ / (kg ° C) and the concentrate product is 3.1 kJ / (kg ° C). Count it (a) Steam demand rate = Answer kg / hour. b. Steam economy when condensate temperature is released at 75 ° C. = Answer (kg of water evaporated / kg of steam)
Exhaust steam from a steam power plant in Batangas is at 7 kPa(29°C) at the rate of 75 kg/s enters a single pass condenser containing 5,780 pcs copper tubes with a total surface area of 2950 m2. The steam has a moisture content of 10% (hf = 163.4 kJ/kg & hfg = 2572.5 kJ/kg) and the condensate leaves saturated liquid at steam temperature. The cooling water flow rate is 4.413 m3/s entering at 20°C. Size of tubes, 25 mm O.D. by 3 mm thick wall. Find the overall heat transfer coefficient.
A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is 86.1 kPa, and the temperature is 290 K. Assume octane behaves ideally, what is the total volume of this mixture. Show unit analysis and conversion on solution. Round off to four decimal places.
A binary mixture with components A and B is to be separated in a distillation column to obtain 95 mol%. A as the top product. The binary mixture has a con stant relative volatility AB = 2. The column feed is a a - saturated liquid containing 50 mol % of A. Under the usual simplifying assumptions such as constant molal overflow, negligible heat loss, ideal trays, the mini mum reflux ratio for this separation is (rounded off to one decimal place)
In a solid - liquid extraction process operated according to the principle of continuous reverse current, the oil of a nutrient will be extracted with pure hexane. A mixture containing 7000 kg of inert solid, 1500 kg of oil and 500 kg of hexane enters the process per hour. The upper stream leaving the total stage contains 65% hexane and 35% oil by weight. A total of 85% of the oil in the inlet current will be recovered. The underflow is constant at N=2.0 kg inert solid/kg solution; a. Find the amount and composition of the output current