A wind tunnel nozzle is designed to yield a parallel uniform flow of air with a Mach number of 3.0. The stagnation pressure of the air supply reservoir is 7000 kPa, and the nozzle exhausts into the atmosphere (100 kPa). Calculate the flow angle at the exit lip of the nozzle. Ma-3.0 100 kPa 7000 kPa angle = ?

A wind tunnel nozzle is designed to yield a parallel uniform flow of air with a Mach number of 3.0. The stagnation pressure of the air supply reservoir is 7000 kPa, and the nozzle exhausts into the atmosphere (100 kPa). Calculate the flow angle at the exit lip of the nozzle. Ma-3.0 100 kPa 7000 kPa angle = ?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A convergent-divergent nozzle with an exit-to-throat area ratio of 1.616has exit and reservoir pressures equal to 0.947 and 1.0 atm, respectively.Assuming isentropic flow through the nozzle, calculate the Mach numberand pressure at the throat.
Air flows into a converging duct, and a normal shock stands at the exit of the duct. Downstream of the shock, the Mach number is 0.54. If p2/p1 = 2, compute the Mach number at the entrance of the duct and the area ratio A1/A2.
For a given Prandtl-Meyer expansion, the upstream Mach number is 3 and the pressure ratio across the wave is p,/p, = 0.4. Calculate the angles of the forward and rearward Mach lines of the expansion fan relative to the free-stream direction.
Air flows in a converging-diverging nozzle with an exit Mach number of 1.8 . The nozzle is supplied from an air reservoir at 8MPa. Assuming one-dimensional flow, the maximum back pressure to choke the nozzle is _______.
An aircraft flies with a Mach number Ma1=0.962 at an altitude of 7062 m where the pressure is 46.2 kPa and the temperature is 246.2 K. Calculate the stagnation properties (static temperature, pressure, density), cross-section areas A1 and A2=? at the inlet and outlet of the diffuser. The diffuser at the engine inlet has an exit Mach number of Ma2=0.3. For a mass flow rate of 36,2 kg/s, determine the static pressure rise across the diffuser and the exit area. Solve the problem by making the necessary assumptions and drawing the schematic figure.
When a pitot-static tube is placed in a supersonic flow, the probe reads P = 190 kPa and P = 150 kPa. If the stagnation temperature is 400 K, estimate the freestream Mach number and velocity.
A converging–diverging nozzle with a 4:1 exit-area ratioand p0 = 500 kPa operates in an underexpanded condition as in Fig. The receiver pressureis pa = 10 kPa, which is less than the exit pressure sothat expansion waves form outside the exit. For the givenconditions, what will the Mach number Ma2 and the angleϕ of the edge of the jet be? Assume k = 1.4 as usual.
A normal shock produced by an explosion propagate at a constant velocity of 450 m/s into still air of 100 kPa and 23 °C. The ratio of stagnation pressure upstream the shock to stagnation pressure of the gas flow behind the wave is
(a) The maximum speed achieved by the X-15A-2 rocket-powered research craft was 6630 ft/s at 99,000 ft. Assuming standard day conditions, whatwas its Mach number?(b) An SR-71 is traveling at Mach 3.2 in standard day 80,000-ft conditions.What is its velocity in nautical miles per hour?
Consider an oblique shock wave with a wave angle of 30◦ in a Mach 4flow. The upstream pressure and temperature are 2.65 × 104 N/m2 and223.3 K, respectively (corresponding to a standard altitude of 10,000 m).Calculate the pressure, temperature, Mach number, total pressure, and totaltemperature behind the wave and the entropy increase across the wave.
An ideal isentropic nozzle is attached to an infinite reservoir that has stagnation conditions 3 MPa and 2250 K, and a constant specific heat of 1.2. If the nozzle's static exit pressure is 38.871 kPa, what is the exit static temperature? Also determine the nozzle's exit Mach number, stagnation pressure, and stagnation temperature.
An aircraft is flying at supersonic speed. At a component of an aircraft where the flow is perpendicular, the density ratio is 5. Solve for: a.Mach Number Downstream b. Pressure Ratio c. Temperature Ratio d. Mach Number upstream