Answered: a. Below are melting points of several…

Science

Chemistry

a. Below are melting points of several carboxylic acids. Explain the trend H3C HO -10°C H3C +31.5°C H3C Он +44.0°C

Organic And Biological Chemistry

7th Edition

ISBN:9781305081079

Author:STOKER, H. Stephen (howard Stephen)

Publisher:STOKER, H. Stephen (howard Stephen)

Chapter6: Amines And Amides

Section: Chapter Questions

Problem 6.38EP

See similar textbooks

Related questions

Q: It a sample of benzoic acid (m.p. 121-122 degree C) was contaminated with a small amount of phenol…

A: All the necessary explanation has been given in the following step.

Q: Which of the following will have the lowest boiling point? I. CH3(CH2)3 CH3 II.…

A: The compound that will have the lowest boiling point is to be…

Q: compared in terms of their boiling point at 1 atm. Which comparison is INCORRECT? Select one: a.…

A: Boiling point of substance is depend on intermolecular forces between molecules and structure. As…

Q: Fill out this table. Once that is done, predict the order of the boiling points from lowest to the…

Q: Each one of the alcohols has one hydroxyl group (OH) for hydrogen bond, however (d) has higher…

A: The boiling point of the organic compound depends on the intermolecular forces, branching, and also…

Q: Acetone 31CH322CO4 is widely used as an industrial solvent.(a) Draw the Lewis structure for the…

A: We will answer first three subparts at a time since you have not mentioned the exact subparts that…

Q: Assuming that they have comparable molecular weight, arrange the following in terms of increasing…

A: Arrange the following in terms of increasing boiling point: I. Alcohol II. Primary Amine III.…

Q: Consider nonane, 2-hexanone and 2-methoxypropane What are the strongest type of IMA in…

A: The strength of different type intermolecular forces: Intermolecular H-bonding> Dipole -dipole…

Q: Which of the following substances should be the most soluble in ethanol (CH3CH2OH)? a. Mg3(PO4)2 b.…

Q: Arrange the following compounds in order of increasing their boiling points (weakest to strongest).…

A: Given here some compounds and we are asked to arrange the givencompounds in order of their boiling…

Q: 16) Which one of the following exhibits dipole-dipole attraction between molecules? options:…

A: The carbon-hydrogen bonds are essentially non-polar, but the carbon-chlorine bond is polar. This…

Q: Evaporation and Intermolecular Attractive Forces Complete the following data table. AT (°C) 10.47…

Q: In which of the following solvent the substance CH3NH2 will be most soluble? CH3COCH3 A. CH3CH2OH В.…

A: Solubility of methyl amine.

Q: 13.11 Which member of each pair is more soluble in water? Why? (a) CH;CH,OCH,CH3(1) or CH;CH,OCH3(g)…

A: The solubility depends on the concept that "like dissolves like". This means that polar molecules…

Q: Which of the following substances would not exhibit any hydrogen bonding interactions in a pure…

A: Intermolecular forces are the forces of attraction between the different molecules. There are five…

Q: >. Based on your knowledge on TMFs, explain the difference between the boiling shown below: Η Η ΤΙ…

Q: Which of the following statements about molecules A-D is false? HO. OH HO. ОН НО OH HO OH Br Br Br…

A: Enantiomers They are stereoisomers that are non-imposable mirror images. They have identical…

Q: molar heat of vaporization of some unknown compound X at its normal boiling point 1.7 K is 3.2…

A: The question is based on the concept of chemical thermodynamics. We have been given by molar…

Q: 1 о Draw the intermolecular forces that present between the molecules A and B. A В О CH3CHс-о- сн23…

A: The intermolecular force is a weak attraction force between the two or more molecule of a substance.…

Q: • Which of the following compound will likely be in its solid form at -115 deg. Celsius. * mp (°C)…

A: Melting point of a substance is the temperature at which it changes its state from solid to liquid.

Q: Which one of the following substances would be the most soluble in CCl4? a. C10H22 b. NH3 c.…

A: Option A is correct answer. A. C10H22.

Q: Rank A–C in order of increasing melting point ? (see attached )

A: The temperature at which solid substance changes to liquid form is called melting point. Melting…

Q: Which of the following compounds will be most soluble in toluene(C7H8)? A) ethylene glycol…

A: The general solubility rule is " like dissolves in like " It means a polar substance is soluble in…

Q: Which of the following has the highest boiling point? ethane, CH3CH3 formaldehyde, HCHO dimethyl…

Q: Which carboxylic acid should be able to form long straight chains of hydrogen-bonded molecules (for…

A: The geometry of the molecule depends on the hybridization of the carbon atom present in the…

Q: CH;OH CH;CH,OH HO, HO. %3D II IV V

A: Hexane is a nonpolar solvent. The General thumb-rule for the solubility is polar likes polar and…

Q: Select the compound with the highest boiling point. I CH3CH2CH2CH,NH2 II CH3CH;NHCH;CH3 III…

A: The intermolecular bonding increases and will require more energy to break the bonds. Mostly in…

Q: 3. Arrange the following in increasing water solubility a. CH3 OH H3C CH3 HO CH3 Br b.

Q: Rank A-C in order of increasing melting point. OH A

A: In C there is no dipolar interaction as electronegativity between C-C is same and C-H is not so…

Q: 16) Circle the compound with the lowest boiling point. NH CH,

A: Boiling point of a compound varies directly with the molecular mass.

Q: 1.) Are there any IMF’s between cyclohexane molecules and vegetable oil? What kind(s)? Given this,…

A: Since you have asked a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 6 When in the liquid state, which of the following compounds is most likely soluble in liquid CHCN?…

A: The given compound in the liquid state is . It belongs to the class of nitriles. The compounds which…

Q: Which of the following compounds will be most soluble in chloroform (CHCl3)?A) methanol (CH3OH)B)…

A: Chloroform is a polar solvent. It dissolves polar compounds. Among the given compounds, except…

Q: ZConsider the three molecules shown below. Which non- H-c-H covalent interactions H H-C-H H…

A: 7. Given molecules,

Q: Essential oils are concentrated liquid containing metabolites extracted from plant sources and are…

A: A question based on properties of liquid that is to be accomplished.

Q: which compound has the higher boiling point (i) (CH3)3C-C(CH3)3 or (ii) (CH3)2CH-CH2CH2-CH(CH3)2

Q: Choose from: A = intermolecular H-bonding B = London dispersion forces C = intramolecular…

A: 1. Benzene’s solubility in water is very low (0.08 g/100 mL) but that of toluene is even lower (0.06…

Q: Which of the following alcohols would have the highest boiling point? A B C A) A B) B C) C CH3 + CH3…

A: With increasing extent intermolecular hydrogen bonding boiling point also increases.

Q: Given the shown structural formulas for these four compounds, explain their relative vapor pressures…

A: If the intermolecular forces are stronger, Lesser is the tendency to evaporate, and thus, the vapor…

Q: A В Which of the following alcohols would have the highest boiling point? C H3C CH3 + CH3 -OH OH OH…

Q: Impure Compound X was found to have a melting point range of 106-114 oC. What do each of these…

A: The purpose of melting point experiment is to determine melting points of compound accurately. It is…

Q: Rank the following compounds in order of increasing (lowest to highest) boiling point HO, II III…

A: First question : ( II ) compound is nonpolar and nonpolar compound have weak intermolecular forces…

Q: At 25°C, the vapor pressure of diethyl ether, (CH3CH2)2O, is higher than the vapor pressure of its…

A: Given that, At 25°C, the vapor pressure of diethyl ether, (CH3CH2)2O, is higher than the…

Q: 19. Which of the following compounds has the LOWEST solubility in water at 25 °C? a) CH;CH;CH;OH b)…

Q: Which compound has the highest boiling point? 1. CH3CH2-OH 2. CH3CH2-F 3. CH3CH2CH3

Q: 12. Which of the following stationary phases has the lowest polarity? D Polyethylene glycol 5%phenyl…

A: Separation of a mixture into its pure components is an essential part of organic chemistry. For…

Q: The substances below are compared in terms of their boiling point at 1 atm. Which comparison is…

A: option a: This statement is correct. For hydrides of group 16, the boiling point increases down the…

Q: Consider the following compounds: (1) Propanol, (2) Propanal, (3) Propanone. Arrange in Decreasing…

Q: 3. Dimethyl fumarate can be found in most leather products since it is commonly used as a mould…

A: a. They are cis and trans isomers. This type of isomerization is called geometrical isomerization.…

Q: Which of the compounds below is predicted to be less soluble in water? CH3 or OH E

Question

a. Below are melting points of several carboxylic acids. Explain the trend.
H3C
-10°C
H3C
HO,
+31.5°C
H3C
ÓH
+44.0°C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

General Physical Properties of Organic Compounds

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Which of these compounds is most soluble in water at pH 7.0? (Note that the non-ionized forms are shown, and remember that ionization will impact solubility!) a CH3-CH2-CH2-CH2-CH2OH b CH3-CH2-CH2-CH2-COOH c CH3-CH2-CH2-CH2-CH3 d CH3-CH2-CH2-CH2-CHO
Which of these compounds is most soluble in water at pH 7.0? (Note that the non-ionized forms are shown, and remember that ionization will impact solubility!) a) CH3-CH2-HCO-O-CH3 (an ester) b) CH3-CH2-CH2-CH2-NH2 c) CH3-CH2-CH2-CH2-CH2OH d) CH3-CH2-CH2-CH2-CH3 e) CH3-CH2-CH2-CH2-CHO
Which of these compounds is most soluble in water at pH 7.0? (Note that the non-ionized forms are shown, and remember that ionization will impact solubility!) a CH3-CH2-HCO-O-CH3 (an ester) b CH3-CH2-CH2-CH2-CHO c CH3-CH2-CH2-CH2-CH3 d CH3-CH2-CH2-CH2-NH2
is compound C 1-butanol?I also need help with compound A and B
How to approach this problem?
Although they have similar molecular masses (73 and 72 amu, respectively), the boiling point of butylamineis much higher (78C) than that of pentane (36C).Explain why.
Which of the following compounds will be most soluble in pentane (C5H12)? Explain your choice. A) pentanol (CH3CH2CH2CH2CH2OH) B) benzene (C6H6) C) acetic acid (CH3CO2H) D) ethyl methyl ketone (CH3CH2COCH3)
Which of the following compounds will be most soluble in toluene(C7H8)? A) ethylene glycol (HOCH2CH2OH) B) hexane (CH3CH2CH2CH2CH2CH3) C) acetone (CH3COCH3) D) trimethylamine (N(CH3)3) E) A and D are soluble in toluene.
What preliminary actions should we take to dispose of the following substances and describes how should we dispose of them ? A- Formaldehyde B- Propofol C- Pentobarbital
Give reasons: (i) Bond length of C = O in carboxylic acids is slightly larger than C = O bond length in carbonyl compounds. (ii) There are two –NH2 groups in semicarbazide. However, only one –NH2 group is involved in the formation of semicarbazones. (iii) Benzoic acid is less soluble in water than acetic acid. (iv) Formic acid is a stronger acid than acetic acid.
Dimethyl ether (CH3OCH3) and ethanol (CH3CH2OH) are isomers, butCH3OCH3 has a pKa of 40 and CH3CH2OH has a pKa of 16. Why are thesepKa values so different?
Illustrated below is the hydrolysis of a C-C bond (in the first molecule) hydrolyzed by water (2nd molecule). Which pair of open boxes best identifies the location of the (-H) and (-OH) components of water on the products. Choose one from the following: (a) A (b) B (c) C (d) D