Air flows through pipe section 1 toward pipe section 2 at a rate of 350 L/s. The air density and water is 1.20 kg/m3 and 1000 kg/m3, respectively. The specific weight of oil and mercury is 8449.7 N/m^3 and 132.52 kN/m^3, respectively. If h2 25 cm and h3 = 40 cm, then determine the height of water (h1).

Air flows through pipe section 1 toward pipe section 2 at a rate of 350 L/s. The air density and water is 1.20 kg/m3 and 1000 kg/m3, respectively. The specific weight of oil and mercury is 8449.7 N/m^3 and 132.52 kN/m^3, respectively. If h2 25 cm and h3 = 40 cm, then determine the height of water (h1).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A certain garden hose is advertised to be able to deliver 550 gallons of water per hour. If the hose if 50 feet long and has an inside diameter of 5/8 inch, estimate the water pressure necessary to deliver this much water, assuming laminar flow and viscosity at 1.002 x 10-3 kg/(m-s). a. 10,664 Pa b. 0.42785 atm c. 0.8218 atm d. 42.49 torr
SAE 50W oil at 20°C flows from one tank to another through a tube 220 cm long and 5 cm in diameter. Estimate the flow rate in m3/hr if z1 = 2 m and z2 = 0.8 m. For SAE 50W oil, take ρ = 902 kg/m3 and μ = 0.86 kg/m-s. Take π = 22/7. The flow rate is m3/hr.
The narrow section of a nozzle is 8 cm in diameter. While the fluid passes through the nozzle at a volume flow of 12 m3 / hour, the pressure difference was measured as 0.05 mSS. In this case, what is the flow rate coefficient (K) of the nozzle? (ρ=1000 kg/m3, g=9.81 m/s2)
Water at 20 ° C is delivered from one reservoir to anotherthrough a long 8-cm-diameter pipe. The lower reservoirhas a surface elevation z 2 =80 m. The friction loss in thepipe is correlated by the formula h loss ≈17.5( V 2 /2 g ), whereV is the average velocity in the pipe. If the steady fl ow ratethrough the pipe is 500 gallons per minute, estimate thesurface elevation of the higher reservoir.
The following data were obtained for the flow of 20°C water at20 m3/h through a badly corroded 5-cm-diameter pipe thatslopes downward at an angle of 8°: p1 = 420 kPa, z1 = 12 m,p2 = 250 kPa, z2 = 3 m. Estimate (a) the roughness ratio ofthe pipe and (b) the percentage change in a head loss if thepipe were smooth and the flow rate the same.
Oil of viscosity 10E-3 Pa-s and specific gravity 0.90, flows through 60 m of 100mm diameter pipe and the pressure drop 13.8 kPa. What will be the pressure drop for a second oil of viscosity 30E-3 Pa.s and the specific gravity 0.95 flowing at the same rate through the pipe? Assume the pipe wall to be smooth.A. 19.4 kPaB. 98.7 kPaC. 142.2 kPaD. 192.5 kPa
If the difference between the total pressure and static pressure in an air duct is measured by a pitot tube to be 6.5 cm H2O, what is the flow velocity in m/s? Density of water is 998 kg/m3, and g = 9.81 m/s2. 3 signififcant figures answer
A 30º reducing elbow is shown. The fluid is water. Evaluate the components of force that must be provided by the adjacent pipes to keep the elbow from moving. Assume steady, incompressible, uniform flow. ρwater= 999kg/m3, Q= 0.11 m3/s.1 atm = 101 kPa;
A liquid with a specific gravity of 4.7 and a viscosity of 1.3 cp flows through a smooth pipe of unknown diameter, resulting in a pressure drop of 0.183 lbf/in² for 1.73 mi. What is the pipe diameter in inches if the mass flowrate is 5,900 lb/hr?A. 3.64 inB. 0.44 inC. 5.74 inD. 0.005 in
Water at 20°C flows in a long horizontal commercial-steel 6-cm-diameter pipe that contains a classical Herschel venturi with a 4-cm throat. The venturi is connected to a mercury manometer whose reading is h = 40 cm. For water at 20°C, take ρ = 998 kg/m3 and μ = 0.001kg/m⋅s. For commercial steel, ε ≈ 0.046 mm. Take π = 22/7. Take Cd ≈ 0.985. Estimate the flow rate in m3/h. Round the answer to the nearest whole number.
The pressure in a section of a horizontal pipe of diameter d1 = 2.0 cm is p1 = 142 kPa. The water flows through the pipe at a volumetric flow rate V = 2.8 L/s. If the pressure at a certain point is reduced to p2 = 42.6 kPa, due to a throttling of a pipe section, what should the diameter d2 of the throttling section be? Consider the density of water ρ = 1.0 g/cm3. Choose the correct option:
A viscous fluid of density 900 kg/m3and viscosity 0.3 Pa.s flows in a horizontal smooth pipe of diameter 0,06 m and length 9,8 m. Flow Reynolds Number is 802. Use pi number , π = 3.14 and gravitational acceleration, g =9.81 m2/s a) What is the magnitude of mean velocity (in m/s)? b) What is the magnitude of friction coefficient ? c) What is the magnitude of pressure gradient to induce flow (in Pa/m )? d) What is the magnitude of shearing stress over the pipe surface in (Pa) ?