Air is approximately 80 mol% Nitrogen (M=28kg/kmol) and 20 mol% Oxygen (M = 32kg/kmol). Consider a rigid container of volume 183.4 liters that contains air at P = 2 atm.Throughout this problem, the temperature of the container is maintained fixed and equal to 25 °C. Use the ideal gas law to answer the following questions (R=0.082 m³.atm/kmol.K): Determine the number of moles of N₂ and of O₂ in the container. N₂ = 4 mol, O₂ = 1 mol N₂ = 8 mol, O₂ = 2 mol N₂ = 12 mol, O₂ = 3 mol N₂ = 16 mol, O₂ = 4 mol

Air is approximately 80 mol% Nitrogen (M=28kg/kmol) and 20 mol% Oxygen (M = 32kg/kmol). Consider a rigid container of volume 183.4 liters that contains air at P = 2 atm.Throughout this problem, the temperature of the container is maintained fixed and equal to 25 °C. Use the ideal gas law to answer the following questions (R=0.082 m³.atm/kmol.K): Determine the number of moles of N₂ and of O₂ in the container. N₂ = 4 mol, O₂ = 1 mol N₂ = 8 mol, O₂ = 2 mol N₂ = 12 mol, O₂ = 3 mol N₂ = 16 mol, O₂ = 4 mol

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter9: Liquids, Solids, And Materials

Section: Chapter Questions

Problem 45QRT: At the critical point for carbon dioxide, the substance is very far from being an ideal gas. Prove...

See similar textbooks

Similar questions

A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.
At the critical point for carbon dioxide, the substance is very far from being an ideal gas. Prove this statement by calculating the density of an ideal gas in g/cm3 at the conditions of the critical point and comparing it with the experimental value. Compute the experimental value from the fact that a mole of CO2 at its critical point occupies 94 cm3.
A 2.0 L soda bottle is pressurized with 4.5 atm of CO2 at 298 K. If the temperature is increased to 317 K, what is the pressure of the CO2?
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In a hospital, pure oxygen may be delivered at 50 psi (gaugepressure) and then mixed with N2O. What volume of oxygen at 20Cand 50 psi (gauge pressure) should be mixed with 1.7 kg of N2O toget a 50%/50% mixture by volume at 20C? (a) 0.21 m3; (b) 0.27 m3;(c) 1.9 m3; (d) 100 m3
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In another test, the valve of a 500 L cylinder full of the gas mixture at 2000 psi (gauge pressure) is opened wide so that the gas rushes out of the cylinder very rapidly. Why might some N2O condense during this process? (a) This is an isochoric process in which the pressure decreases, so the temperature also decreases. (b) Because of the rapid expansion, heat is…
For an ideal gas P= nRT/V, and for a gas whose molecules have volume P=nRT/(V-nb) How would you modify this latter equation for a real gas to correct for the fact that there are attractive forces between molecules.
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
The Ideal Gas Law has more variables than Boyle's Law, and it contains the ideal gas constant, R. The ideal gas law is PV = nRT, where T is the absolute temperature and n is the number of moles of gas present in a system. a. In Boyle's Law, PV = k (a constant). Rearrange the Ideal Gas Law so that the constant R is similarly equal to the variables. b. If PV = k, and PV = nRT as well, express k in terms used in the Ideal Gas Law. c. If you took laboratory syringe setup outside in the summer or put it in the refrigerator, would Boyle's Law be able to adequately describe what would happen to the volume of the system? Why? d. There are other gas laws aside from Boyle's Law, including: Charles' Law (V/T = k), Gay-Lussac's Law (P/T = k), and Avogadro's Law (V/n = k). All these laws feature a "k" value (a constant). What is different about k in these laws compared to the constant R in the Ideal Gas Law?
Nitrogen oxide is a pollutant commonly found in smokestack emissions. One way to remove it is to react it with ammonia. 4 NH3(g) + 6 NO(g) → 5 N2(g) + 6 H2O(l) How many liters of ammonia are required to react with 13.1 L NO? Assume standard temperature and pressure. I am not sure how to solve this problem. I am assuming i use pv=nrt?
A gas mixture contains 10.0 mole% H 2O(v) and 90.0 mole% N 2. The gas temperature and absolute pressure at the start of each of the three parts of this problem are 50°C and 500 mm Hg. Ideal-gas behavior may be assumed in every part of this problem.(a) If some of the gas mixture is put in a cylinder and slowly cooled at constant pressure, at what temperature would the first drop of liquid form?(b) If a 30.0-liter flask is filled with some of the gas mixture and sealed and 70% of the water vapor in the flask is condensed, what volume (cm 3 ) would be occupied by the liquid water? What would be the system temperature?(c) If the gas mixture is stored in a rigid-walled cylinder and a low-pressure weather front moves in and the barometric (atmospheric) pressure drops, which of the following would change: (i) the gas density, (ii) the absolute pressure of the gas, (iii) the partial pressure of water in the gas, (iv)the gauge pressure of the gas, (v) the mole fraction of water in the gas, (vi)…
Consider the following situation: You have a 50 L tank of compressed air at 15 atm and 100 ºC. You then pass the compressed air through a "titanium getter" which contains fragments of hot titanium metal. The purpose of the "getter" is to remove oxygen gas from the sample as Ti reacts with oxygen to form solid TiO2 (known as titania). Once the purified air is passed through the getter is it cooled back down to 100 ºC and fills another 50 L storage tank. If air typically contains about 20% oxygen, what could the pressure in the storage tank be? Question 2 options: A) 12 atm B) 15 atm C) 18 atm D) 24 atm
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. e beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.