Quèstion 12All rigid bodies are.. elasticO partiallyO Fullynonnone of the above

Rigid body is actually when particles don't have any relative displacement between any two particles…

Answered: All rigid bodies are . elastic

Science

Physics

All rigid bodies are . elastic

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 54P: A copper wire of diameter 1.0cm stretches 1.0 when it is used to lift a load upward with an...

See similar textbooks

Related questions

Q: Assume a leg has 0.06 m shaft of bone with an average cross sectional area of 2.5 m2 , What is the…

A: Young's Modulus of a material is the measure of it's elasticity, and it is equal to the ratio of the…

Q: A strong spring is stretched 10 cm by a suspended block. If the block's weight is doubled, the…

A: Given: The spring is stretched to a distance (x) of 10 cm by a suspended block. Introduction: In…

Q: Forces could also cause changes in an object such as its length, and volume, this change is known as…

Q: 5.8 A reinforced concrete column is 12 feet long, and un- der load, it shortens inches". Determine…

A: Given data: Length of concrete column (L) = 12 feet Change in length (ΔL) = 1/8 inches Required: The…

Q: Is it tension or compression that strenghtens an arch that supports a load?

A: Compression is the force causes an object to shorten in the direction of force. While tension causes…

Q: A crane boom is 10 m long and has a mass of 2000 kg. The crane is holding a load of 8000 kg. The…

A: Consider the weight of the crane boom be w, its mass and length be m and l, respectively, the angle…

Q: A 5cm2cord has original length of 120cm is pulled by a 20N force. The change in length in the cord…

Q: A 5 N uniform wooden plank is supported by two posts that are 1.2 m apart. A 4 N load is hung 0.3 m…

Q: 4. A 5.0 inches cube chiffon cake on a table was exposed to a shearing force of 0.20 The upper…

A: Given-The shear modulus of the cake is G=0.05 lb/in2Slide of chiffon l=5 inchesShearing force…

Q: What is meant by a rigid body?

A: In physics, a rigid body (also known as rigid object) is a solid body in which deformation is zero…

Q: shaft of bone 1.2 m long. If the strain is 1.3x (10) ^(-4) when the leg supports his weight, by how…

A: The amount of length led shortened is =strain ×length =1.3×10^(-4)×(1.2m)=1.56×10^(-4) m

Q: Tensile stress is the same as force V applied force per cross-sectional area the strain per unit…

A: Tensile stress is force per unit area. tensile stress=applied forcecross sectional area stress has…

Q: What factors would affect the elasticity of an object?

A: Required : Factors that affect elasticity.

Q: Steel is more elastic than rubber. Explain.

A: Elasticity is the ability of a material to regain its shape once the deforming force is removed.

Q: Consider a very large wooden barrel for storing wine. Should the “flat” ends be concave (bending…

A: The wooden barrels are used for storing and aging of the alcoholic drinks. Wine can ferment in large…

Q: Write down the conditions that must be satisfied for an object or structure to be in equilibrium?

A: The two key conditions for a rigid-body equilibrium are to be stated.

Q: o is when a force pulls and object causing it to elongate * O Inertia O compressive stress, O…

A: Inertia : A property of the mass that allows it to maintain the state of constant motion or rest…

Q: Consider there are two iron rods with circular and square cross sectional areas. By applying the…

A: The shape of an object is the geometrical description of the part of the space occupied by the…

Q: Discuss about Young's modulus associated with elastici

A: Given:- Discuss about Young's modulus associated with elasticity.

Q: A thin square plate of mass, M, hangs from a rope tied to one of its corners. Hung from an adjacent…

Q: resaw is balanced when the weight of one box times its distance from the balance point is equal to…

A: As per policy i can answer only 1st. Please post the other question separately.

Q: Why must you bend forward when carrying a heavy load on your back?

A: The formula for the torque is: As a person carries a heavy load on his back and he doesn’t bend…

Q: If the size of the spheres was to increase, how would that affect the viscosity?

A: To answer the question we will use stoke's law of viscosity.

Q: The stress-strain curve during elastic deformation is non-linear. Is this true or false?

A: When a material is elastically deformed its stress-strain curve is linear in nature till the elastic…

Q: Why does the suspended spring stretch more at the top than at the bottom?

A: The top part of the spring supports all of the spring’s weight.

Q: when a bouncy ball strikes a surface, does the surface experience inelastic deformation, or does the…

A: Inelastic deformation is the change in shape due to inelastic collision.

Q: An object is said to be at an equilibrium under what conditions?

A: An object is said to be in equilibrium when there is no resultant force acting on the object, the…

Q: The change in the relative configuration of point within a solid is called strain

A: In the given question we have to discuss about the strain.

Q: When you bend a meterstick, one side is under tension and the other is under compression. Which side…

A: Bending of the stick is represented below.

Q: A load of 100 lb is hung from the middle of a rope which is stretched between two rigid walls 30 ft…

Q: What is translating rigid body?

A: To determine,What is translating rigid body.

Q: "An Elastic Body is one, which changes its O shape O volume O length O All of the above Or upon the…

A: An Elastic body is define as a solid body for which the additional deformation produced by an…

Q: steel is placed on a steel incline table that has a µs o applied horizontally to the table in order…

A: Given values:- Mass of steel,(m)=2 kg ----(1) Coefficient of static friction,(μs)=0.23 ----(2)…

Q: the point that identifies the proportional limit of the material whosee graph of stress as a…

Q: A 5.0-m weightless strut, hinged to a wall, is used to support an 650-N block as shown. The vertical…

A: The weightless strut is hinged to wall and supporting the 650 N block. Where FH = F Sinθ…

Q: 37 F

Q: what is the compression in the boom?

A: Horizontal cable.... So T = 4500 N is along x axis F = 7500 N is along -y axis The resultant of…

Q: a cable has a diameter of 4mm and an original length of 2m.The cable is pulled by a force of…

Q: The unit of Young’s modulus of elasticity is:

Q: when the velocity of muscle lengthening increases the force the muscle can produce: 1.) will…

A: Above graph describes the relation between velocity of muscle lengthening and the the force the…

Q: This is a static of rigid bodies problem

A: Static equilibrium condition is given. We need to find the force applied by men.

Q: What is the modulus of elasticity? a) Ratio of elongation of

Q: All rigid bodies are .. elastic

A: A rigid body is a solid body in which changes by deforming forces are zero. Or it may change but in…

Q: Bone has a Young's modulus of about 18 x 10° Pa. Under compression, it can withstand a stress of…

Q: The boom of tge wall crane 4m long is held at right angle to the wall by a wire that is attached to…

Concept explainers

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).

Question

Quèstion 12
All rigid bodies are.. elastic
O partially
O Fully
non
none of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When visiting some countries, you may see a person balancing a load on the head. Explain why the center of mass of the load needs to be directly above the person's neck vertebrae.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A vertebrae is subjected to a shearing force of 500.0N . Find the shear deformation, taking the vertebrae to be a cylinder 3.00cm high and 4.00cm in diameter. How does your result compare with the result obtained in the preceding problem? Are spinal problems more comman in disks than in vertebrae?
Note: Unless stated othen.ise the weights of the wires, rods, and other elements are assumed to be negligible. Elastic moduli of selected materials are given In Table 12.1 22.What is meant when a fishing line is designated as “a 10-lb test?”
Show that, as explained in the text, a force F exerted on a flexible medium at its center and perpendicular to its length (such as on the tightrope wire in Figure 5.26) gives rise to a tension of magnitude T=F/2sin() .
Note: Unless stated otherwise, the weights of the wires, rods, and other elements are assumed to be negligible. Elastic moduli of selected materials are given In Table 12.1 13.Why can a squirrel jump from a tree branch to the ground and run away undamaged, while a human could break a bone In such a fall?
A copper wire of diameter 1.0cm stretches 1.0 when it is used to lift a load upward with an acceleration of 2.0m/s2 . What is the weight of the load?
THIS SUBJECT IS DYNAMICS OF RIGID BODIESSHOW COMPLETE AND CLEAR SOLUTIO0N
What are characterstic of rigid body?
Subject: Dynamics of rigid bodies, need asap, auto like.
A 500-kg load is suspended from the end of a horizontal boom, as in the figure. The angle between the boomand the cable supporting its end is 450Assuming that the boom’s mass can be neglected compared with thatof the load, find (a) the tension in the cable and, (b) the inward force the boom exerts on the wall.
A 20.0-m tall hollow aluminum flagpole is equivalent in stiffness to a solid cylinder 4.00 cm in diameter. A strong wind bends the pole much as a horizontal force of 900 N exerted at the top would. How far to the side does the top of the pole flex?