A crane boom is 10 m long and has a mass of 2000 kg. The crane is holding a load of 8000 kg. The crane boom makes an angle of 50 degrees with the horizontal. Find the tension in the hoisting cable that makes and angle of 10 degrees witht the crane boom. The center of gravity of the crane is at its midpoint.

A crane boom is 10 m long and has a mass of 2000 kg. The crane is holding a load of 8000 kg. The crane boom makes an angle of 50 degrees with the horizontal. Find the tension in the hoisting cable that makes and angle of 10 degrees witht the crane boom. The center of gravity of the crane is at its midpoint.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 34P: In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the...

See similar textbooks

Similar questions

When tightening a bolt, you push perpendicularly on a wrench with a force of 165N at a distance of 0.140m from the center of the bolt. How much torque are you exerting relative to the center of the bolt?
Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
Check Your Understanding A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs 600.0 N. The strut is supported by a hinge at the wall and by a cable whose other end is tied to the wall at a point 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut.
Can compress stress be applied to a rubber band?
An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
If an odd number of forces act on an object, the object cannot be in equilibrium.
The figure shows three boards clamped together. The center board weighs 93.5 N, and the coefficient of static friction between the boards is 0.490. What is the minimum magnitude of the horizontal compression forces (in N) acting on either side of the center board so it does not slip?
How much compression acts on the hip during two-legged standing, given that the joint supports 250 N of body weight and the abduct muscles are producing 600 N of tension? What is the angle α of R?
Find the x and y-coordinates of the center of gravity of a 4.00-ft by 8.00-ft uniform sheet of plywood with the upper right quadrant removed as shown in the figure below. Hint: The mass of any segment of the plywood sheet is proportional to the area of that segment.
A 45 cm x 45 cm square plate ABCD of uniform thickness is supported by three vertical strings. The first string is located at B, the second is located 15 cm from A alongside AD and the third is at the point midway of side CD. What percent of the load is carried by the second support?
Consider two steel rods, A and B. B has three times the area and twice the length of A, so Young's modulus for B will be what factor times Young's modulus for A?