Answered: If the size of the spheres was to…

Science

Physics

If the size of the spheres was to increase, how would that affect the viscosity?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter12: Fluid Dynamics And Its Biological And Medical Applications

Section: Chapter Questions

Problem 31CQ: If you took two marbles of different sizes, what would you expect to observe about the relative...

See similar textbooks

Related questions

Q: A farmer making grape juice fills a glass bottle to the brim and caps it tightly. The juice expands…

Q: Is it tension or compression that strenghtens an arch that supports a load?

A: Compression is the force causes an object to shorten in the direction of force. While tension causes…

Q: What is absolutely viscosity?

Q: You take a young child to the park to play on the teeter totter. You weight 175 lb and the child…

Q: Line of gravity passing through the following structures EXCEPT a.Centre of ankle joint b.Centre of…

Q: Why are vertical columns not needed to support the middle of domed stadiums, such as the Houston…

A: Because tension along every part of the dome surface is parallel to the surface.

Q: What is meant by a rigid body?

A: In physics, a rigid body (also known as rigid object) is a solid body in which deformation is zero…

Q: A body is considered two of its points is negligible for the purpose at hand. when the change in…

Q: Suppose the humerus is reduced uniformly in size by a factor of two. This means that both the length…

A: Here, the amount of the stretch is inferred as the amount of the stress developed in the humerus for…

Q: The center of gravity, CG (X,Y) of the composite material below is at 4 ст __ - - 4 cm 4 ст 8 ст

A: Consider the rectangle as section 1 and the triangle as section 2. Write the area and centroid of…

Q: held close to the suspended table-tennis ball shown in Fig. 9.1. The table-tennis ball with metal…

A: The charge developed in the metal paint on the ball is negative , when rod is held closed to it .

Q: As an oil well is drilled, each new section of drill pipe supports its own weight and that of the…

Q: Discuss about Young's modulus associated with elastici

A: Given:- Discuss about Young's modulus associated with elasticity.

Q: Is surface tension due to cohesive or adhesive forces, or both?

A: Given: Surface tension

Q: Q NO. 02 One end of thread which is wound on reel is fixed and the reel falls in vertical line. Its…

Q: Only with great difficulty can you crush an egg when squeezing it along its long axis, but it breaks…

A: The ends of an egg form arches. Therefore, pressing them together along the long axis will only…

Q: What is the tension force in the wire shown below if it stretches 0.35 cm wher tightened if young's…

Q: Why does the suspended spring stretch more at the top than at the bottom?

A: The top part of the spring supports all of the spring’s weight.

Q: A force of 10 N is applied to one end of a 10 inches diameter circular rod. Calculate the stress.

A: We need to calculate the stress in the rod.

Q: when a bouncy ball strikes a surface, does the surface experience inelastic deformation, or does the…

A: Inelastic deformation is the change in shape due to inelastic collision.

Q: Relationship between slip and torque?

A: The relationship between slip and torque is direct relation as Torque(T) is directly proportional…

Q: When you bend a meterstick, one side is under tension and the other is under compression. Which side…

A: Bending of the stick is represented below.

Q: A load of 100 lb is hung from the middle of a rope which is stretched between two rigid walls 30 ft…

Q: What is kinematic viscosity?

A: Kinematic viscosity is defined as a measure of flow of a fluid’s internal resistance under…

Q: A steel string of a racket is ender tension of 280 N. If its diameter is 1.00mm, by how much is it…

A: Young's modulus for steel is, 210 GPa The elongation is ,…

Q: A moonshiner makes the error of filling a glass jar to the brim and capping it tightly. The…

A: Given data The increment of the volume is: ∆vv∘=4 × 10-3 The magnitude of the bulk modulus is given…

Q: How is force distributed across a spherical object, like a knee cap?

A: we know that force either will be contact force or field force. for contact force we consider the…

Q: Steel nails are rigid and unbending. Steel wool is soft and squishy. How would you account for this…

A: In case of steel nail, the composition of the material is rigid and uniform, because the density of…

Q: A wire of radius 1.4 mm and length 1.0 m is stretched between two poles 1.0 m apart. When a 8.0 kg…

Q: A guitar string is fixed at both ends. If you tighten it to increase its tension

Q: A ball reached 120 m horizontally in 4 seconds after being kicked. Calculate the modulus and slope…

Q: when the velocity of muscle lengthening increases the force the muscle can produce: 1.) will…

A: Above graph describes the relation between velocity of muscle lengthening and the the force the…

Q: A moonshiner makes the error of filling a glass jar to the brim and capping it tightly. The…

A: Given: ΔV/V0 = 5 ✕ 10-3 Bulk modulus = 1.9 × 109 N/m2 Find The force exerted by the moonshine per…

Q: Show that the unit of the permeability ( μ ) can be given as (T . m . s / C)?

Q: A steel wire of diameter 1 mm can support a tension of 0.2 kN. A steel cable to support a tension of…

Q: It is difficult to drive a nail into wooden block without supporting it. why?

A: When we hit the nail with a hammer, the nail and unsupported block together move forward as an…

Q: An object weighs 100.0 N on the surface of the earth, the radius of which is R. If the object is…

A: According to question, W=GMmR2100=GMmR2 Where, G=Gravitational constant M=Mass of earth m=Mass of…

Q: What is the force acting normally per unit area on the surface of the body?

A: The force acting per unit area on the surface of a body is called pressure.

Concept explainers

Debye Theory of Solids

In solid-state physics, debye theory is used to estimate the phonons contributing to the specific heat capacity in a solid. It explains that the specific heat is a consequence of the vibrations of the atomic lattice of the solid, which is in contrast to the Einstein model. In the Einstein model, solids are treated as independent, non-interacting quantum harmonic oscillators. This model clearly explains the low-temperature dependence of the heat capacity, which is proportional to T3. This is known as Debye T3 law.

Question

If the size of the spheres was to increase, how would that affect the viscosity?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A copper wire of diameter 1.0cm stretches 1.0 when it is used to lift a load upward with an acceleration of 2.0m/s2 . What is the weight of the load?
By how much does a 65.0kg mountain climber stretch her 0.800cm diameter nylon rope when she hangs 35.0m below a rock outcropping? (For nylon, Y=1.35109Pa. )
Check Your understanding Repeat ExampIe12.4 assuming that the forearm is object of uniform density that weighs 8.896 N.
Discuss how you might measure the bulk modulus of a liquid.
How is pressure related to the sharpness of a knife and its ability to cut?
As an oil well is drilled, each new section of drill pipe supports its own weight and that of the pipe and drill bit beneath it. Calculate the stretch in a new 6.00 m length of steel pipe that supports 3.00 km of pipe having a mass of 20.0 kg/m and a 100-kg drill bit. The pipe is equivalent in stiffness to a solid cylinder 5.00 cm in diameter.
The “lead” in pencils is a graphite composition with a Young’s modulus of approximately 1.0109N/m2 . Calculate the change in length of the lead in an automatic pencil if you tap it straight into the pencil with a force of 4.0N . The lead is 0.50mm in diameter and 60mm long.
What can you say about the velocity of a moving body that is in dynamic equilibrium?
During a walk on a rope, a tightrope walker creates a tension of 3.94103N in a wire that are 15.0m apart. The wire has a diameter of 0.50cm when it is not stretched. When the walker is on the wire in the middle between the poles the wire makes an angle of 5.0 below the horizontal. How much does this tension stretch the steel wire when the walker is this position?
Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod stretches by 0.15mm under some stress, how much does the steel rod stretch under the same stress?
A 90-kg mountain climber bangs from a nylon rope and stretches it by 25.0 cm. If the rope was originally 30.0 m bog and its diameter is 1.0 cm, is Young’s modulus for the nylon?
Can compress stress be applied to a rubber band?