An electric current contains a battery that produces a voltage of 60 voltsV , a resistor with a resistance of 13 ohms, and inductor with an inductance of 5 henrys H  . Using calculus, it can be shown that I I t    (in amperes, A), when t seconds after the switch is closed is 13 5 60 1 13 t I e          1.4.1 Use this equation to express the time t as function of the currentI 

An electric current contains a battery that produces a voltage of 60 voltsV , a resistor with a resistance of 13 ohms, and inductor with an inductance of 5 henrys H  . Using calculus, it can be shown that I I t    (in amperes, A), when t seconds after the switch is closed is 13 5 60 1 13 t I e          1.4.1 Use this equation to express the time t as function of the currentI 

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter13: Continuous Systems; Waves

Section: Chapter Questions

Problem 13.14P

See similar textbooks

Similar questions

What inductance must be connected to a 17 pF capacitor in an oscillator capable of generating 550 nm (i.e., visible) electromagnetic waves? Comment on your answer.
For the circuit above, R1 = 12 kΩ, R2 = 18 kΩ, L = 13.3 mH, and ξ = 9.5 V. How long after the switch, S, is closed does the current in the inductor reach 63.2% of its final value (that is, what is the characteristic time constant of this circuit)?
A sinusoidal voltage Δv = 45.0 sin(100t), where Δv is in volts and t is in seconds, is applied to a series RLC circuit with L = 170 mH, C = 99.0 µF, and R = 60.0 Ω. e) What If? For what value of the inductance (in H) in the circuit would the current lag the voltage by the same angle ? as that found in part (d)? f) What would be the maximum current (in A) in the circuit in this case?
The indutor in a radio receiver carries a current of amplitude 200mA when a voltage of amplitude 2.40V is across it at a frequency of 1400kHz. Calculate the value of the inductance.
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
In the LC circuit in Figure 33.11, the inductance is L = 19.8 mH and the capacitance is C = 19.6 mF. At some moment, UB = UE= 17.5 mJ. a. What is the maximum charge stored by the capacitor? b. What is the maximum current in the circuit? c. At t = 0, the capacitor is fully charged. Write an expression for the charge stored by the capacitor as a function of lime. d. Write an expression for the current as a function of time.
The self-inductance and capacitance of an LC circuit e 0.20 mH and 5.0 pF. What is the angular frequency at which the circuit oscillates?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
A coaxial cable has an inner conductor of radius a, and outer thin cylindrical shell of radius b. A current I flows in the inner conductor and returns in the outer conductor. The self-inductance of the structure will depend on bow the current in the inner cylinder tends to be distributed. Investigate the following two extreme cases. (a) Let current in the inner conductor be distributed only on the surface and find the self-inductance. (b) Let current in the inner cylinder be distributed uniformly over its cross-section and find the self-inductance. Compare with your results in (a).
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.