An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel to each other. The parallel connection of the said practical batteries is connected across the ideal battery. The two practical batteries have the following specifications: 10 volts, 0.2 ohm; 8 volts, 0.5 ohm. Determine the total power dissipated by the internal resistances of the practical batteries. 1112 watts 1320 watts 406 watts none of the choices

An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel to each other. The parallel connection of the said practical batteries is connected across the ideal battery. The two practical batteries have the following specifications: 10 volts, 0.2 ohm; 8 volts, 0.5 ohm. Determine the total power dissipated by the internal resistances of the practical batteries. 1112 watts 1320 watts 406 watts none of the choices

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter29: Service-entrance Calculations

Section: Chapter Questions

Problem 6R: What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____

See similar textbooks

Similar questions

Solve the following Numerical problems a. What is the Output Voltage of a battery that expends 7.2J of energy in moving 1C of charge? b. A 50-ohm load dissipates 200W of power. How much is the voltage and current across the load? c. If one branch of a 120-V power line is protected by a fuse of 20-A. Will the fuse carry 10-Ohm load? d. If total resistance of a series circuit is 280-Ohm. If one of the resistance is 160-Ohm. What is the sum of other two resistances?
A battery with a terminal voltage of Vab = 9 V is connected to a circuit having three 10-ohm and one 5-ohm resistors all in series. Assuming that the battery has negligible internal resistance, determine the total power dissipated by the resistors and the power supplied by the battery.
A hot plate is fitted with low, medium, and high settings. The element consists of; two sections connected in parallel for high, two same sections connected in series for low; and only one section used for medium. If the high setting gives 4 KW of heat at 440V, find the wattage output in low and medium settings
Heat energy is often measured in calories and 1 calorie = 4.184 Joule. It is desired to design a heating element to boil a certain amount of water in 2 min requiring 40-kcal heat energy. If the heater is to operate at 110-V, calculate its current and power ratings.
22: Which one of the following uses difference in temperature between the surface ocean water and the deep sea water to produce electricity? a. OTCE b. OTEC c. OTTE d. OTET 23: A PV cell uses pn junction for producing electricity. Select one: True False
Power Quality: Ensuring that the voltage and frequency of the power supplied to customers is of good quality and within the acceptable limits. Describe how this problem will affect the world in 100 years
low voltage systems An AG 1 heater has 230 V and 10 kW on its label. So which of the following shows the 230 V value? a) Effective Voltage b) Maximum Voltage c)Peak Voltage d) Average Voltage
4. The heating element in an oven has a resistance of R =32 ohms. One of thewires connecting the oven to the 220 volt power source is loose, contributingan additional r = 5 ohms to the closed-loop circuit. What is the power Povenradiated in the oven, and what is the rate Pcontact at which heat is dissipatedat the loose contact? The looser is the connection, the greater is the resistance r: What value of r is most likely to cause a fire. Also agraph showing Pcontact versus r
An electric heater having power rated 1000W connected to a 240V supply for 10minutes. a) Determine the heat energy produced of the electric heater. b) Calculate current taken from the supply. c) Find the resistance value of the heater element. d) Calculate the conductance of the heater element. e) Find the nett charge flowing in the heater element. f) Calculate the no. of free electron that represent for that amount charge obtained.
A static electrical device has 2000 turns uses 4000 mA from the supply connected to a laptop whichhas a power of 20 V, 1000 W. How can you find the amount of current used by the laptop? Identify suchstatic electrical device used and evaluate supply voltage taken by it. Which category does it belong basedon its ability to change voltage? Practical efficiency of such electrical device is less than 100 %. Justifywith reasons. What are possible ways to improve its efficiency?
A electrical company provides power to a house at 220V AC and can supply up to 600A, for a maximum power of 132kW. The wiring in the house is sized so that the total resistance of wiring is 0.02 Ohms. What is the worst case power loss in the house due to voltage drops in the wiring?
Based on the given picture below, answer the following questions. a. What is the maximum voltage where you should connect its socket? b. How much voltage is produced by this charger in a laptop battery? c. How much resistance is offered by the charger itself? d. What is the power of the charger in kW? e. If you will use the charger for 3 hours, how much energy is consumed in Joules?