An ideal gas has pressure P and Volume V, is heated. The warming process includes 4 steps. During step 2 to 3.. O a. both the volume and the pressure of the gas are constant O b. The internal energy of the gas is constant C. The pressure of the gas is constant O d. The volume of the gas is constant

An ideal gas has pressure P and Volume V, is heated. The warming process includes 4 steps. During step 2 to 3.. O a. both the volume and the pressure of the gas are constant O b. The internal energy of the gas is constant C. The pressure of the gas is constant O d. The volume of the gas is constant

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Heat Engines, Entropy, And The Second Law Of Thermodynamics

Section: Chapter Questions

Problem 38AP: A system consisting of n moles of an ideal gas with molar specific heat at constant pressure Cr...

See similar textbooks

Similar questions

In a cylinder of an automobile engine, immediately after combustion the gas is confined to a volume of 50.0 cm3 and has an initial pressure of 3.00 106 Pa. The piston moves outward to a final volume of 300 cm3, and the gas expands without energy transfer by heat, (a) What is the final pressure of the gas? (b) How much work is done by the gas in expanding?
(a) In reaching equilibrium, how much heat transfer occurs from 1.00 kg of water at 40.0C when it is placed in contact with 1.00 kg of 20.0C water in reaching equilibrium? (b) What is the change in entropy due to this heat transfer? (c) How much work is made unavailable, taking the lowest temperature to be 20.0C ? Explicitly show how you follow the steps in the Problem-Solving Strategies for Entropy.
Unreasonable Results Calculate the cold reservoir temperature of a steam engine that uses hot steam at 450°C and has a Carnot efficiency of 0.700. (b) What is unreasonable about the temperature? (c) Which premise is unreasonable?
A power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 20.0C (surface water temperature) and 5.00C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? (b) If the useful power output of the plant is 75.0 MW, how much energy is absorbed per hour? (c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?
A power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 20.0C (surface water temperature) and 5.00C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? (b) If the useful power output of the plant is 75.0 MW, how much energy is absorbed per hour? (c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?
(a) On a winter day, a certain house loses 5.00108J of heat to the outside (about 500,000 Btu). What is the total change in entropy due to this heat transfer alone, assuming an average indoor temperature of 21.0C and an average outdoor temperature of 5.00C ? (b) This large change in entropy implies a large amount of energy has become unavailable to do work. Where do we find more energy when such energy is lost to us?
(a) Prepare a table like Table 18.1 for the following occurrence. You toss four coins into the air simultaneously and then record the results of your tosses in terms of the numbers of heads (H) and tails (T) that result. For example, HHTH and HTHH are two possible ways in which three heads and one tail can be achieved. (b) On the basis of your table, what is the most probable result recorded for a toss? In terms of entropy, (c) what is the most ordered macrostate, and (d) what is the most disordered?
A system consisting of n moles of an ideal gas with molar specific heat at constant pressure Cr undergoes two reversible processes. It starts with pressure Pi and volume Vi, expands isothermally, and then contracts adiabatically to reach a final state with pressure Pi and volume 3Vi. (a) Find its change in entropy in the isothermal process. (The entropy does not change in the adiabatic process.) (b) What If? Explain why the answer to part (a) must be the same as the answer to Problem 46. (You do not need to solve Problem 46 to answer this question.)
Practical steam engines utilize 450C steam, which is later exhausted at 270C. (a) What is the maximum eficiency that such a heat engine can have? (b) Since 270C steam is still quite hot, at second steam engine is sometimes operated using the exhaust of the first. What is the maximum eficiency of the second engine if its exhaust has a temperature of 150C ? (c) What is the overall eficiency of the two engines? (d) Show that this is the same eficiency as a single Carnot engine operating between 450C and 150C. Explicitly show how you follow the steps in the Problem-Solving Strategies for Thermodynamics.
(a) How much heat transfer occurs to the environment by an electrical power station that uses 1.251014J of heat transfer into the engine with an efficiency of 42.0%? (b) What is the ratio of heat transfer to the environment to work output? (c) How much work is done?