An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.

An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
Construct a graph to represent the recurring nature of partial discharge pulse sequences under sinosoidal alternating voltage (applied voltage) using internal discharges as a typical example. The graph should consist the voltage accross the dielectric, voltage across the void and current impulses.
Plz provide answers for drill problem 2.10 asap
A 100 Hz ac circuit has a 300 ohm resistor, a 900 milli-henry inductor, and a capacitor all in series. The Capacitive Reactance is 165.49 ohms. The current from the source is 200 amps. Keep final answers to 2 decimal places. Use Pi = 3.14159 for all calculations. What is the value of the capacitor (in Scientific Notation)? What is the impedance of the circuit? What is the Inductive Reactance?
A 70-Vac source has the following waveform. Determine:a. equation of the waveform (in time domain)b. the instantaneous voltage when t = 120 msc. the angle (1st occurrence) after t = 0 when the voltage is +80 Vd. the time (2nd occurrence) after t = 0 when the voltage is –10 V
Two coils, A and B having 1200 and 800 turns respectively are placed near to each other.60 % of flux of each coil linked with the other coil. A current of 5A in coil A produces a flux of 0.25 mWb while the same current in coil B produces a flux of 0.15 mWb. Determine (a) mutual inductance and (ii) coupling coefficient.
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Do the required calculations and select a core material for the coil from the table below. Your answer will be given over the following series of questions. A. H = 0.12566 oersted B. H = 12.56637 oersted C. H = 1.25664 The relative permeability of the manufactured solenoid from the previous question is: A. μr = 15.916 B. μr = 15915.964 C. μr = 1.2665e10 D. None of the mentioned/ Geen van die genoemde
A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Do the required calculations and select a core material for the coil from the table below. Your answer will be given over the following series of questions. A. H = 0.12566 oersted B. H = 12.56637 oersted C. H = 1.25664