An open loop transfer function of a closed loop control system with a unitary K negative feedback is given by G(s) where K is the gain of the (s+3)(s+5)(s+7) system. Showing all calculation steps, 2.1. Construct, manually (the use of Matlab is not allowed), the root locus of the system 2.2. With the use of a table, indicate segments (intervals) of the real axis that are part or not part of the root locus 2.3. Justify the stability or non-stability of this control system

An open loop transfer function of a closed loop control system with a unitary K negative feedback is given by G(s) where K is the gain of the (s+3)(s+5)(s+7) system. Showing all calculation steps, 2.1. Construct, manually (the use of Matlab is not allowed), the root locus of the system 2.2. With the use of a table, indicate segments (intervals) of the real axis that are part or not part of the root locus 2.3. Justify the stability or non-stability of this control system

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Similar questions

The open loop transfer function of unity feedback system is ??(??) = ??????????(??+??)(??+????).1- Assess the stability of the system.2- If the gain ?? is connected in series with G(s) as shown in figure Q1, Determine the range of ?? for stable system.
3- Consider the unity feedback system shown below. a)Find the range of k for which the closed-loop system is table. b)What is the steady-state error for unit ramp and step inputs.
For the open-loop system G(s) = 3/s^2 + 2s - 3 assume there is a feedback with a proportional gain, K. And sketch a locus of closed-loop rootsverse K. What is the minimum value of K to achievea stable system?
Consider a unity negative feedback system with loop transfer function shown in Figure where L(s)=GcG(s)=K(s2+6s+1)(s2+5s+1)L(s)=GcG(s)=K(s2+6s+1)(s2+5s+1) Determine the value of K for which the closed-loop system is stable.
For the unity feedback system given below, the damping ratio of the closed looppoles is given by a) 1.5 b) 1 c) 0.5 d) 0.25
Feedback Control 2. Consider the unit-step response of unity-feedback control system whose open-loop transfer function is ?
An open-loop system is described by the differential equation (see picture). A) Is this system stable. Why? This system is now connected with unity feedback. B) Write the loop transfer function, G(s)H(s); C) Determine the gain and phase margins of the closed loop system and comment on stability.
Comment on the stability of the closed-loop response in relation to the closed-loop pole locations. Also, comment on the location of the poles and zeros as a function of the control gain k. (The poles move, but do the zeros?)
A unity feedback system with open-loop transfer function given as:?(?) = ??. ?(? + ?)(? + ?)(? + ??)without affecting its operating point (−1.54 ∓ ??2.66) appreciably a- Design a suitable compensator to drive the step response error to zero.b- Design a suitable compensator to reduce step error by factor of 5.
Control Systems, expand on configurations of feedback compensation and give detailed solutions.
The block diagram of feedback control system shown in fig. below find the transfer function C(s)/R(s).
In the unity feedback system, what is the system type and find the appropriate steady-state error and error constant associated with system type for step, ramp, and parabolic inputs