Ans: Cx = -267 lbs The neighbor's child wants you to build a sand castle in their backyard. You go overboard and rent a digger to create the moat. If the weight of the bucket filled with dirt is 300 lbs (applied at G), what are the reactions at D, C, and F. E 1517

Ans: Cx = -267 lbs The neighbor's child wants you to build a sand castle in their backyard. You go overboard and rent a digger to create the moat. If the weight of the bucket filled with dirt is 300 lbs (applied at G), what are the reactions at D, C, and F. E 1517

Name: do fast. Problem 2The neighbor's child wants you to build a sand castl
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: do fast. Problem 2The neighbor's child wants you to build a sand castle in their backyard. You go overboard and rent adigger to create the moat. If the weight of the bucket filledwith dirt is 300 lbs (applied at G), what are the reactions atD, C, and

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.16P: Figure (a) shows the cross-sectional dimensions for the structural steel section known as C1020...

See similar textbooks

Similar questions

A cylindrical brick chimney of height H weighs w = 825 lb/ft of height (see figure). The inner and outer diameters are d1= 3 ft and d2= 4 ft, respectively. The wind pressure against the side of the chimney is p = 10 lb/ft2 of projected area. Determine the maximum height H if there is to be no tension in the brickwork.
Gate AB in Fig. is 5 ft wide into the paper, hinged atA , and restrained by a stop at B . The water is at 20 ° C.Compute ( a ) the force on stop B and ( b ) the reactions at Aif the water depth h = 9.5 ft.
Gate AB in the Figure is 6 ft wide into the paper, hinged at A, and restrained by a stop at B. Compute the force on stop B, if the water depth h = 11 ft.
Your answer is partially correct. A homogeneous, 4-ft-wide, 9.8 -ft-long rectangular gate weighing800lbis held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate, which is hinged at point A. Friction in the hinge is negligible, Determine the tension in the cable. AssumeL1=9.8ft,L2=7.2ft, andθ=57∘. Please type answer note write by hend.
The strength per meter of the longitudinal joint in the figure is 480 kN, whereas or the girth joint is 200 kN. Determine the maximum diameter of the cylindrical tank if the internal pressure is 1.5 MPa.
Gate AB in the figure below is a 5-ft wide, vertical, rectangular gate, hinged at A and restrained by a stop at B. The water depth, h = 9.5 ft. Determine: a) the hydrostatic force acting on the gate and the location of the center of pressure b) The vertical and horizontal reactions at the hinge at A.
The gate in the figure supported a maximum moment of 180kN-m at the support at a. Determine the maximum height h of water that it supported. The width is 2.0m. The mass of the gate is 1000 kg.
2. A 3,000 gallon tanker is carrying industrial alcohol (donaity-48 23 D. /h) finteBurton to the Selene Building. Find the weight (N) of the industrial alcohol if the tanker is67% full. (Round to nearest whole number)
A rectangular gate 5 m × 3 m is hinged at its base A and inclined at 60 degree to the horizontal as shown in the figure. To keep the gate in a stable position a counter weight (W) of 5000 kg is attached at the upper end of the gate. Find the depth of water at which the gate begins to fall. The weight of the gate is 2000 kg. Neglect the friction at the hinge and pulley
A caisson for closing the entrance to a dry dock is of trapezoidal from 16 m wide at the top and 12 m wide at the bottom and 8 m deep. Find the total force in MN on the caisson if the water on the outside is 1 m below the top level of the caisson and the dock is empty. enclude your free body diagram. a.117.72 b.80.93 c.3.164 d.37.77
The cross section of a rectangular AB of width 2.5 m hinged along A is shown in the figurebelow. The weight of the gate is 55 kg, and it is used to retain the water at depth 3.3m.Calculate the minimum force R at B to hold the gate.
In the figure shown, stop B will break in the force on it reaches 40 kN. Find the critical water depth (h-bar) the length of the gate perpendicular to the sketch is 1.5m. Ans (5.77m)