Assume that your ultra-low-cost processor doesn't have the hardware budget for aninteger multiplier implemented in HW, and you don't need 64-bit multiplicationresults, but you do need 32-bit multiplication results to do some addresscomputations (i.e. you only need a multiplier that returns a 32-bit result, even giventwo 32-bit inputs)In the SW emulation of multiplication $a0, $a1 below, :mstart:xor $v®, $v0, $v®mloop: andi $t®, $a1, 1$t0, $Ø, $tØand $t1, $a®, $t®add $v®, $v0, $t1sll $a1, $a1, 1srl $a®, $a0, 1bne $a1, $0, mloopwhat instruction, when put in the blue box, would correctly implement unsignedmultiplication $vO = $aO * $a1?%3Dsubmuladdbeqo ooo

The instruction written here is the multiplication of two numbers but not using mul op code.

Answered: Assume that your ultra-low-cost…

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Suppose that the execution time of a given program on a single processor is 9.5 ms. If you run this program on a system having 18 independent processors, you observe an overall speedup of 1.1. Using Amdahl’s Law, what must have been the fraction of the program that could be executed in parallel? (Express the answer in decimal form, i.e., if 50% of the program can be enhanced, enter 0.5. Round to three decimal places)
This question is on Computer Architecture. Translate the following arithmetic and logical expressions written in C programming language intoinstructions sequences written in MIPS Assembly language. You may assume that the values (orbase addresses) of the variables a, b, c, and d are in the general-purpose registers $s0, $s1,$s2, and $s3. 1. d[3] = a - b + c[7];2. c[5] = (a << 3) & (b >> 2);Here, <<, >>, and & indicate the bitwise left-shift, right-shift, and AND operations respectively.
In the given question in the picture replace XX as per your comfort, which results in a valid addres of 8085 microprocessor.
Unlike a byte that is always 8 bits, word size can vary from machine to machine. Let's say we have a 16-bit system (word size is 2 bytes) and a memory unit that has 10 address lines. Because there are 10 address bits, we can have 210 unique addresses, hence 1024 addresses. If we are working with something word-addressable, that means each word has a unique address, and we canstore 1024 words. The memory size is 1 kiloword, or equivalently, 2kilobytes because each word is 2 bytes long. The address of the first word is 0, the second word is 1, the third word is 2, and the last word is 1023.Now, with 4 address lines and a word size of 4 bits, what is the address of the last word?
In 32-bit mode, aside from the stack pointer(ESP), what other register points to variables on the stack? Name at least four CPU status flags. Which flag is set when the result of an unsigned arithmetic operation is too large to fit into the destination? Which flag is set when the result of a signed arithmetic operation is either too large or too small to fit into the destination? (True/False): When a register operand size is 32 bits and the REX prefix is used, the R8D register is available for programs to use. Which flag is set when an arithmetic or logical operation generates a negative result? Which part of the CPU performs floating-point arithmetic? On a 32-bit processor, how many bits are contained in each floating-point data register? (True/False):The x86-64 instruction set is backward-compatible with the x86 instruction set. (True/False): In current 64-bit chip implementations, all 64 bits are used for addressing. (True/False):The Itanium…
QUESTION 2 Discuss with examples the main difference between system programming and application programming and explain in your own words how each of these can be carried out in the computer system. With your knowledge in memory addressing modes and using the given opcodes LDA = 00 0000 0000 (00) 0 (x) What will be the content of the address loaded into the accumulator? b. With your knowledge in memory addressing mods and using the given opcodes STCH = OX54 Buffer = 1000 0101 0100 (00) 1 (x) 000 1000 0000 0000 () 011 0000 0000 0000 () What will be target address? Briefly explain the usage of the JSUB and RSUB instruction sets in an SIC architecture coding
I have this problem from my textbook that I do not understand, despite re-reading the section on segmentation and paging. "The IBM system/370 architecture uses a two-level memory structure and refers to the two levels as segments and pages, although the segmentation approach lacks many of the features described in Chapter 8. For the basic 370 architecture, the page size may be either 2 KB or 4 KB, and the segment size is fixed at either 64 KB or 1 MB. For the 370/XA and 370/ESA architectures, the page size is 4 KB and the segment size is 1 MB. What advantages of segmentation does this scheme lack? What is the benefit of segmentation for the 370?"Can you help me undertand what they are looking for in this explanation?
There is an application that requires the following hardware: an Intel 8031, a Program ROM of 8Kx8, a Data ROM of 4Kx8 for look-up tables and a Data RAMs of 8Kx8. The memory map of the design: Program ROM should start at address 0000H. Then, the Data ROM should come above the Program ROM. Finally the Data RAM must go to the top of the memory map. There should be no gaps between the memory addresses of the external ROMs. Show the design’s address space on a memory map, starting with 0000H at the bottom and FFFFH at the top.
There is an application that requires the following hardware: an Intel 8031, a Program ROM of 8Kx8, a Data ROM of 4Kx8 for look-up tables and a Data RAMs of 8Kx8. The memory map of the design: Program ROM should start at address 0000H. Then, the Data ROM should come above the Program ROM. Finally the Data RAM must go to the top of the memory map. There should be no gaps between the memory addresses of the external ROMs. Calculate the address space of the ROMs and RAMs of your design.
Assume you now have 1kB of memory, i.e. the memory address space runs from 0 to 1023. The starting address of the first word is 0, the second word is 4, the third word is 8, and so on. The last word comprising 4 bytes resides in addresses 1020, 1021, 1022, 1023. Thus, the last word starts at 1020, which is a multiple of 4. Now assume the same 1kB of memory but now, word size is 64 bits. The starting address of the first word is 0, the second, third, and last word starts at? my answer: (correct) the second is equal to = 8 the third is equal to = 16 help me find the last word
Assume you now have 1kB of memory, i.e. the memory address space runs from 0 to 1023. The starting address of the first word is 0, the second word is 4, the third word is 8, and so on. The last word comprising 4 bytes resides in addresses 1020, 1021, 1022, 1023. Thus, the last word starts at 1020, which is a multiple of 4. Now assume the same 1kB of memory but now, word size is 64 bits. The starting address of the first word is 0, the second, third, and last word starts at?
SCREENSHOT THE CODE AND RESULT code a masm x86 assembly program to implement the following code sum = 0i = 0j = 12var1 = 3var2 = 3var3 = 0for(i=0; i<j; i++){ if (var1 > var3){ var1 =var1 – i;} else { var3 = var3+ i;} sum = var1 + var2+ var3; j = j-1} If you code it correctly, at the end sum contains 15 (decimal).- Assume that variables are 32-bit signed integers variables- You are not allowed to make any logical reduction to the code. You need to implement it the way it is provided

SEE MORE QUESTIONS

Recommended textbooks for you

Database System Concepts

Computer Science

ISBN:

9780078022159

Author:

Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:

McGraw-Hill Education

Starting Out with Python (4th Edition)

Computer Science

ISBN:

9780134444321

Author:

Tony Gaddis

Publisher:

PEARSON

Digital Fundamentals (11th Edition)

Computer Science

ISBN:

9780132737968

Author:

Thomas L. Floyd

Publisher:

PEARSON

Database System Concepts

Computer Science

ISBN:

9780078022159

Author:

Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:

McGraw-Hill Education

Starting Out with Python (4th Edition)

Computer Science

ISBN:

9780134444321

Author:

Tony Gaddis

Publisher:

PEARSON

Digital Fundamentals (11th Edition)

Computer Science

ISBN:

9780132737968

Author:

Thomas L. Floyd

Publisher:

PEARSON

C How to Program (8th Edition)

Computer Science

ISBN:

9780133976892

Author:

Paul J. Deitel, Harvey Deitel

Publisher:

PEARSON

Database Systems: Design, Implementation, & Manag…

Computer Science

ISBN:

9781337627900

Author:

Carlos Coronel, Steven Morris

Publisher:

Cengage Learning

Programmable Logic Controllers

Computer Science

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

SEE MORE TEXTBOOKS