Assume we have a direct-mapped cache with 64 blocks and each block consists of 16 bytes, the cache is initially empty. Consider the following MIPS code: addi $t1, $zero, 1200 #1200 = 0100 1011 0000 addi $t2, $zero, 2400 #2400 = 1001 0110 0000 addi $t0, $zero, 10 loop: beq $t0, $zero, exit lw $t3, 0($t1) lw $t4, 4($t1) lw $t5, 0($t2) addi $t0, $t0, -1 j loop exit: What is the miss rate for the cache when executing the given code? Explain your answer.

Assume we have a direct-mapped cache with 64 blocks and each block consists of 16 bytes, the cache is initially empty. Consider the following MIPS code: addi $t1, $zero, 1200 #1200 = 0100 1011 0000 addi $t2, $zero, 2400 #2400 = 1001 0110 0000 addi $t0, $zero, 10 loop: beq $t0, $zero, exit lw $t3, 0($t1) lw $t4, 4($t1) lw $t5, 0($t2) addi $t0, $t0, -1 j loop exit: What is the miss rate for the cache when executing the given code? Explain your answer.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider a cache with the following parameters: N (associativity) = 2, b (block size) = 2 words, W (word size) = 32 bits,C (cache size) = 32 K words, A (address size) = 32 bits. You need consider only word addresses.(a) Show the tag, set, block offset, and byte offset bits of the address. State how many bits are needed for each field.(b) What is the size of all the cache tags in bits?(c) Suppose each cache block also has a valid bit (V) and a dirty bit (D). What is the size of each cache set, including data, tag, and status bits?(d) Design the cache using the building blocks in Figure 8.28 and a small number of two-input logic gates. The cache design must include tag storage, data storage, address comparison, data output selection, and any other parts you feel are relevant. Note that the multiplexer and comparator blocks may be any size (n or p bits wide, respectively), but the SRAM blocks must be 16K × 4 bits. Be sure to include a neatly labeled block diagram. You need only design the…
There is a cache with 8 blocks, find the number of misses for each cache organization (Direct-mapped, 2-way associative, 4-way associative) given the following sequence of block addresses: 10110, 11110, 10111, 10110, 11110, 10111 11110,10110,00011,10000,10010,10000
Q2) Given a physical memory of 8 k and a cache memory of 512 bytes with block size 64 bytes. The system uses set associative mapping with set size 2 lines per set A- How many sets we will have in the cache memory b-B- How the address will be split to indicate tag, set no, and offset c-Calculate the cache address (set, line no, and offset) that physical address 140 will be mapped.
We have a fully associative cache memory with 216entries). Each entry is hosting 32 data. How manybits are necessary for the TAG for a 28 bits address?5 A12 B23 C None of previous answers D , also is there a difference if it was fully associative mapping cache memory or no? solve this question in great detail explaining every single bit of info as i'm a complete beginner and i need to understand how to solve questions of this type. also provide small examples of how the solution would differ if the question was slightly altered.
Computer Science Using snoopy MSI cache coherence protocol and given a table of three processes with time, how can I display each cache line and figure out what state it is in on every cycle if three professor are executing code that is interleaved? In the table there are just processes with LW and SW. Example: LW R8, 3(R1) Given: 128kbytes cache line block size. 8KB Direct mapped Cache
A Direct mapped cache has a capacity of 16-word cache and a block size of 4 words. Consider the following repeating sequence of lw addresses (given in hexadecimal): 74 A0 78 38C AC 84 88 8C 7C 34 38 13C 388 18C Determine the effective miss rate if the sequence is input to the following caches, ignoring startup effects.
Which one is not one of the advantages of direct mapped cache against to 4-way set associative cache? A) Needs less harware to impelement B) Hit time of direct mapped would be shorter as there is only one block to which a data of physical adress can be matched C) Two squential read to 2 different addresses matching the same cache block will result in that there won't be a cache hit so the performance will drop D) It is less expensive and simplier than 4-way associative mapping E) Using direct mapped will take more advantage of spatial locality
Using snoopy MSI cache coherence protocol and given a table of three processes with time, how can I display each cache line and figure out what state it is in on every cycle if three professor are executing code that is interleaved? In the table there are just processes with LW and SW. Example: LW R8, 3(R1) Given: 128kbytes cache line block size. 8KB Direct mapped Cache
6. If a cache access requires one clock cycle and dealing with cache misses requires an additional five clock cycles, which of the following cache hit rates results in an effective access time of 2 clock cycles? Assume that the cache is using the sequential access. Group of answer choices 0.85 0.8 0.7 0.9
We have a full associative mapping cache memorywith globally 65536 = 2^16 lines. Each line is hosting32 data. How many bits are necessary for the TAG fora 24 bits address bus?3 A19 B21 CNone of previous answers solve this question in great detail explaining every single bit of info as i'm a complete beginner and i need to understand how to solve questions of this type. also provide small examples of how the solution would differ if the question was slightly altered. THANK YOU!
Consider a word-based, four-way set associative cache with 64 bits. Each line has eight words, and the total number of sets is forty-nine thousand. What is the cache's size? a) 1 megabyte b) 10 megabytes c) 4 megabytes d) 512 kilobytesBefore a network can be called effective and efficient, three requirements must be met. Please write a short description in your own words of the one you've chosen.
A computer using direct mapping cache has 256Mbytes of byte addressable main memory and cache size of 32k lines and each cache block contain 8 bytes. How many blocks of main memory are there?What are the size of the tag, line number and words?To which cache block will the memory address 13ADEF9H map?To which line number will the memory address 17FEAD8H map?