At 1 atmosphere, saturated water and vapor coexist at 373.12 K per the NIST Fluids Database. If the molar volume of the liquid phase is 0.018798 L/mol and the vapor phase is 30.143 L/mol, for a mixture composed with an average molar volume of 24.184 L/mol, what mole fraction of liquid water is present (0.00 - 1.00)?

At 1 atmosphere, saturated water and vapor coexist at 373.12 K per the NIST Fluids Database. If the molar volume of the liquid phase is 0.018798 L/mol and the vapor phase is 30.143 L/mol, for a mixture composed with an average molar volume of 24.184 L/mol, what mole fraction of liquid water is present (0.00 - 1.00)?

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter16: Spontaneity, Entropy, And Free Energy

Section: Chapter Questions

Problem 114CP: Carbon tetrachloride (CCl4) and benzene (C6H6) form ideal solutions. Consider an equimolar solution...

See similar textbooks

Similar questions

Calculate the total pressure in a binary system where the mole fraction of A in the vaporphase is 0.200, the vapor pressure of pure A is 100. mmHg and the vapor pressure ofpure B is 300. mmHg.
Osmotic pressures are often reported in units of atmospheres or mm Hg. The latter impliesthat the height of a column of liquid can be used as a measure of pressure. This is, in fact, thebasis of the torricellian barometer from which the units of “torr” come. The pressure, P, isrelated to the height of the column by:P = ρghwhere ρ is the density of the liquid, g is the acceleration due to gravity and h is the height. Whatwill be the height (in mm) of a column of aqueous solution with a density of 0.9987 g/mL, if theosmotic pressure of the solution at 25 °C is 1.4 mm Hg? The density of mercury at thistemperature is 13.8 g/mL
If 124.4 mL of water is shaken with oxygen gas at 0.81atm, it will dissolve 0.0036 g O2. Estimate the Henry's law constant for the oxygen gas in water in units of g mL ^-1atm^-1.
The vapor pressures of two volatile organic compounds, compound 1 and compound 2, at 20 °C are 79.2 torr and 194.7 torr, respectively. What is the gas phase mole fraction of compound 2 above a solution containing an equimolar mixture of the two compounds?Please enter your response in standard notation to three significant figures.
Some water dissolves in liquid methane at -161°C to givea solution in which the mole fraction of water is 6.0 × 10-5. Determine the mass of water dissolved in 1.00 L ofthis solution if the density of the solution is 0.78 g cm-3.
The maximum solid solubility of carbon in ferrite occurs at 0.022 wt% C and 727 ° C, the eutectoid composition is 0.76 wt% C, the maximum solid solubility of carbon in austenite occurs at 2.14 wt% C and 1147 ° C, and the cementite composition is 6.7 wt% C. For 2122 g of a 3.2134 wt% C steel at 726 ° C, what will be the mass of carbon present as part of a compound?(a) 67.9 g(b) 74.2 g(c) 58.7 g(d) 83.5 g
Estimate whether theentropy of the system increases or decreases during eachprocess: (a) photodissociation of O2(g), (b) formation ofozone from oxygen molecules and oxygen atoms, (c) diffusionof CFCs into the stratosphere, (d) desalination ofwater by reverse osmosis.
(a) One particular pungent gas is the toxic hydrogen sulphide (H2S). Hydrogen sulphide develops an odour of rotten eggs at a partial pressure of 0.13 ppm or 0.0132 Pa. If the aqueous concentration of hydrogen sulphide in the stream is 2.5 x 10–6 M, determine through calculations if the hydrogen sulphide in the water may be responsible for the odour detected near the vicinity of the stream. KH (H2S) = 0.087 M/atm) (b) In the leachate pond the conditions are more acidic causing NH3 to exist as NH4+. NH4+ can react with nitrites in the pond to form the less hazardous N2 and H2O as seen below: NH4+ + NO2– → N2 + 2H2O You want to investigate methods of speeding up this reaction but you first conducted an initial rates test to determine the rate law equation for the reaction. Using the data in the table below determine the rate law equation for the reaction above. Experiment Number Initial NH4+ M Initial NO2– Initial Rate (M/s) 1 0.0100 0.200 5.4 x 10 –7…
Consider Palmitic acid C16H32O2, a common fatty acid used in the manufacture of soap. A solution of palmitic acid is prepared by mixing 112 g palmitic acid with 725 mL of benzene C6H6. The density of the resulting solution is 0.902 g/mL. Palmitic acid (molar mass = 256 g/mol and density = 0.852 g/mL); Benzene (molar mass = 78 g/mol and density = 0.879 g/mL) 1.) What is the mole fraction of the solvent? 2.) What is the %m/m of the solution? 3.) What is the molarity of the solution? 4.) Based from the Molarity of the palmitic acid solution that you were able to solve earlier, how will you prepare 250 mL of the said molar concentration, if you have an available 2M stock solution of Palmitic acid? How many mL of the 2M palmitic acid stock solution will you need? 5.) How many mL of solvent do you need to add to the amount gotten from the 2M Palmitic acid stock solution in order to prepare 250 mL total volume of your desired solution?
The partial molar volumes of two liquids A and B in a mixture in which the mole fraction of A is 0.3713 are 188.2 cm3 /mol and 176.14 cm3 /mol, respectively. The molar masses of A and B are 241.1 g/mol and 198.2 g /mol . What is the volume of a solution of mass 1.000 kg?
On a molecular level that is the order in which the two liquids analyzed elutes the gc. Two liquids: cyclohexane and toluene
Refer to Fig. 5.8 and identify the number of phases present for mixtures of compositions (i) (0.4, 0.1, 0.5), (ii) (0.8, 0.1, 0.1), (iii) (0, 0.3,0.7), (iv) (0.33, 0.33, 0.34). The numbers are mole fractions of the three components in the order (NH4Cl, (NH4)2SO4, H2O).