Physical Sciences P1September 2019 Common TNSCQUESTION 1111.1In the circuit below, the battery has an EMF of 12 V. The battery and theconnecting wires have negligible resistance.B.Az1,5 AV2Ammeter A2 reads 1,5 A11.1Calculate the total resistance in the circuit.(3)11.2Determine the reading on ammeter A1.(2)11.3Calculate the reading on voltmeter V1.(e)Calculate the resistance of resistor B.(s)11.5 Determine the energy transferred to resistor B in 10 minutes.11.6 How does the reading on Vi compare to that on V2?Choose from GREATER THAN, LESS THAN or EQUAL TO.TOTAL: 150

We have been given a circuit and it is required to find the equivalent resistance, ammeter reading…

Answered: At 1,5 A V2 Ammeter A2 reads 1,5 A 11.1…

At 1,5 A V2 Ammeter A2 reads 1,5 A 11.1 Calculate the total resistance in the circuit. 11.2 Determine the reading on ammeter A1. 11.3 Calculate the reading on voltmeter V1.

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Direct-current Circuits

Section27.2: Resistors In Series And Parallel

Problem 27.2QQ: With the switch in the circuit of Figure 27.4a closed, there is no current in R2 because the current...

See similar textbooks

Similar questions

. A clamp-on ammeter is placed around a conductor and the meter indicates that there is 10A of current flowing through the conductor. If the wire were wrapped into 10 loops and the clamp-on ammeter were clamped around the 10 loops, what value of current would the clamp-on ammeter indicate? A. 10A B. 1A C. 0A D. 100A I NEED TYPED ANS NOT HANDWRITTEN ANS IN DETAIL
You company is designing a battery-based backup power source, and your job is to assess its safety. You know that under damp or sweaty conditions, the resistance between two points of un-broken skin on the human body can be as low as 500 Ω. Your product uses a 72-V battery whose internal resistance is 100 Ω. Is it capable of passing a fatal 100 mA (Table 24.3) through a damp human body?
Can all of die currents going into the junction shown below be positive? Explain.
With the switch in the circuit of Figure 27.6a open, there is no current in R2. There is current in R1, however, and it is measured with the ammeter at the right side of the circuit. If the switch is closed (Fig. 27.6b), there is current in R2. What happens to the reading on the ammeter when the switch is closed? (a) The reading increases. (b) The reading decreases. (c) The reading does not change. Figure 27.6 (Quick Quiz 27.3) What happens when the switch is closed?
Good day, sir/ma'am. The following question which I require assistance with is this: (Thank you for the help) Question: A piece of 14-gauge copper wire 163cm in diameter is 1 4.0m long. (a) What is its resistance? (b) If a potential difference (V) of 1 .00 V is applied across the wire, what current flows in it? (c) What is the electric field in the wire?
1. What happened to the voltage across the resistance box as the current through it was increased? What is the relationship between voltage and current when resistance is fixed? 2.What is the current in a 10 ohms resistor due to a potential difference of 40 V? Explain.
1. Why is an electromotive force not a “force”? Justify your answer. 2. Are electromotive force and voltage the same? Justify your answer. 3. A battery contains an emf of 20.0 V. Determine the current flowing the circuit once it is connected to a 30.50 Ω load if the internal resistance of the emf is equal to 0.234 Ω. 4. A battery has an emf of 12V. When a load resistance of 4 Ω is connected to the battery terminals; a current of 2 amperes flows through it. Calculate the internal resistance of this battery. NOTE: Derive the formula of emf to get the internal resistance.
22.3 Objectives1. To understand the use and operation of the Ammeter and Voltmeter in a simple direct current (DC) and alternating current (AC) circuits.2. To verifyOhm’s Law in DC circuits 2.4 MaterialsAmmeterVoltmeterVariable resistor (2k-10k ohms)Variable dc power supply (0-30V)Project boardwires2.5Pre-labOn a separate sheet of paper, answer the following questions in a neat and organized manner. 1. What do you use a voltmeter for? 2. What do you use an ammeter for? 3. What do you use an ohmmeter for?4. If you double the resistance in a circuit while keeping the current unchanged, what happens to the voltage? 5. Ifinstead, you keep the voltage unchanged, what happens to the current? 6. StateOhm’s law and sketch the relationship between voltage and current implied by Ohm’s Law.What is the slope of your curve and its SI unit
With the switch in the circuit of Figure 27.4a closed, there is no current in R2 because the current has an alternate zero-resistance path through the switch. There is current in R1, and this current is measured with the ammeter (a device for measuring current) at the bottom of the circuit. If the switch is opened (Fig. 27.4b), there is current in R2. What happens to the reading on the ammeter when the switch is opened? (a) The reading goes up. (b) The reading goes down. (c) The reading does not change. Figure 27.4 (Quick Quiz 27.2) What happens when the switch is opened?
Hello, I just wanted to confirm the answer to part (c): https://www.bartleby.com/questions-and-answers/25.-a-resistor-and-capacitor-are-connected-in-series-acrss-an-ac-generator.-the-emf-of-the-generator/074c0424-e08e-4377-9087-7659a7880939 as it does not match the answer in the back of the book (attached).
Hi, Here's my question. 26.8: Three resistors having resistances of 1.60 W, 2.40 W, and 4.80 W are connected in parallel to a 28.0 V battery with no internal resistance. Find (a) the equivalent resistance of the combination, (b) the current in each resistor, (c) the total current throughout the battery, (d) the voltage across each resistor, (e) the power dissipated in each resistor, and (f) the resistor that dissipates the most power- the one with the greatest resistance or the least resistance and why?
I NEED HELP ASAP 1. Two negatively charged particles are located 2 meters apart. Each produces an electric force on the other of 3 Newtons (as determined by Coulomb’s Law). What force would they exert on each other if their distance decreased to 1 meter? (The strength of the charges, in Coulombs, stays the same.) 2. Two 50 Ω resistors are connected in series to a 300 V battery. What current flows through the circuit?