At temperature 0=25C and under a pressure p=1.01x105 Pa (constant conditions), a volume V1=10ml of a solution of FeCl3 of molar concentration C1=8x10-2mol.l- 1 is added to a volume V2=10ml of wastewater of a molar concentration C2=5x10-2mol.l-1 of phosphate (P043-). After mixing, a yellow precipitate is observed a. What is the initial state of the system? b. Can you determine using a table like shown in class what is the maximal advancement (xf) and the limiting reactant?

At temperature 0=25C and under a pressure p=1.01x105 Pa (constant conditions), a volume V1=10ml of a solution of FeCl3 of molar concentration C1=8x10-2mol.l- 1 is added to a volume V2=10ml of wastewater of a molar concentration C2=5x10-2mol.l-1 of phosphate (P043-). After mixing, a yellow precipitate is observed a. What is the initial state of the system? b. Can you determine using a table like shown in class what is the maximal advancement (xf) and the limiting reactant?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.19QAP

See similar textbooks

Similar questions

What volume (mL) of the prepared low alcoholic elixir is needed if the prescription requires 120 mL of an alcoholic elixir with 35% v/v alcoholic strength? Low alcoholic elixir alcoholic strength: 20% Low Alcoholic ElixirCompound Orange Spirit 10mLAlcohol 100mLGlycerin 200mLSucrose 320gPurified water, qs ad 1000mL High alcoholic elixir alcoholic strength: 79% High Alcoholic ElixirCompound Orange Spirit 4mLSaccharin 3gGlycerin 200mLAlcohol, qs ad 1000mL a 30.51 mL b 119.39 mL c 89.49 mL d 30.61 mL
A solution of potassium phosphate contains a mixture of 164 mg of monobasic potassium phosphate (MWt: 136) and 158 mg of dibasic potassium phosphate (MWt: 174) per milliliter. If a hyperalimentation fluid calls for the addition of 45 mEq of potassium, how many milliliters of the solution should be used to provide this level of potassium? How many millimoles of total phosphate will be represented in the calculated volume of potassium phosphate solution?
1. A 4.59 mL sample of HCl, specific gravity 1.3, required 50.5 mL of 0.9544N NaOH in a titration. Calculate the %w/w HCl. 2. A 10 mL sample of sulfuric acid solution required 16.85 mL of NaOH solution in a titration. Each mL of the NaOH solution was equivalent to 0.2477 g of potassium hydrogen phthalate. Calculate the sulfuric acid content in %w/v. MW of sulfuric acid, 98; MW of potassium hydrogen phtalate(KHC8H4O4 ) = 204.22
Q3 / The solubility of sodium chloride NaCl in water at 290 Kis 35.8 kg / 100 kg of water. Express the solubility as the following: 1. Mass fraction and the mass percent of Naci 2. Mole fraction and mole percent of NaCl 3. kmol of NaCl per 1000 kg of water Note: molecular weight of NaCl = 135.8, and water = 18.016
Prepare 50ml of approximately 1000ppm Mn stock solution from MnCl2*4H2)
1-3: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol) 1. Determine the initial volume of 70% v/v ethanol used in the preparation. 2. How much water was added to the stock solution to make 1L of the final concentration? 3. The molarity of 5.0 mL of 70% v/v ethanol was found to be __________. 4-6: A solution contains 45.0 g of methanol, CH3OH, dissolved in sufficient water to give a total mass of 210.6 g. 4. Compute for the number of moles of the solute present in the given solution. 5. What is the mass (in kg) of water used to dissolve the solute from the given problem? 6. Determine the molal concentration of the said solution.
Solid Na2S is slowly added to a solution of 1.0 x 10-3 M Cr3+ (with no change in volume). At what [S2-] will Cr2S3 start to ppt? For Cr2S3, Ksp = 1.0 x 10-20
A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol) Determine the initial volume of 70% v/v ethanol used in the preparation. How much water was added to the stock solution to make 1L of the final concentration? The molarity of 5.0 mL of 70% v/v ethanol was found to be __________.
Hexanoic acid was added to an immiscible biphasic solvent system, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D2) of hexanoic acid in water with respect to CCl4.
The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? A. Solution A: 0.123 Solution B: 0.463 B. Solution A: 0.463 Solution B: 0.234 C. Solution A: 0.123 Solution B: 0.234 D. Solution A: 0.234 Solution B: 0.463
Six 50.0 ml volumetric flask 1-6 are labeled. 10.00 ml of 2.00 x 101 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient 0.10 M nitric acid was then added to each flask to make them total volume of 50.00ml. 1.a)Calculate the final Fe(NO3)3 concentrations for each. 1.b)Also how would you find the initial concentration of SCN- for each flask? Please show calculations to solutions.Thanks
125.1 mg of streptomycin sulphate are dissolved in 10 ml of water. A GC headspace analysis is carried out in order to determine the methanol content of the drug. A peak for methanol is produced which has 73.2% of the area of a peak for a methanol standard containing 0.532 mg/100 ml of methanol in water analysed under exactly the same conditions, What is the methanol content of the streptomycin sulphate in ppm and %w/w? Answer: 311.3 ppm, 0.3113 % w/w.how??