There are two separate phases, one with a composition of 12% phenol and the other with a composition of 60% phenol, from a 210 gram phenol-water mixture at 60 °C with a composition of 35% phenol. Calculate the masses of these phases.

There are two separate phases, one with a composition of 12% phenol and the other with a composition of 60% phenol, from a 210 gram phenol-water mixture at 60 °C with a composition of 35% phenol. Calculate the masses of these phases.

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter12: Solutions

Section: Chapter Questions

Problem 12.84QE

See similar textbooks

Related questions

Q: (b) Surface sanitizers were prepared using ethyl alcohol/water and isopropyl alcohol/water…

A: According to Raoult's law, we have the following relation regarding vapour pressure : P=xP0 .. (1)…

Q: A mixture of phenol and water, under certain conditions of temperature and composition, forms two…

Q: The vapour pressure of 2-propanol, C3 H8 O, is 50.00 kPa at 338.8°C, but it fell to 49.62 kPa when…

A: Given: Vapour pressure of 2-propanol = 50.00 kPa Vapour pressure of solution = 49.62 kPa Mass of…

Q: Mark the following points on a ternary phase diagram for the system NaCl/Na2SO4⋅10H2O/H2O: (i) 33…

Q: Consider the following solutions at 20 °C: I: 0.5 moles trifluoroacetic acid in 1.0 mole of…

A: Introduction: Partial pressure: The partial pressure may be defined as the pressure exerted by the…

Q: does the boiling point of liquid solution independent of its composition (yes or no?)

A: To explain: does the boiling point of a liquid solution independent of its composition.

Q: Prove that a straight line from the apex A of a ternary phase diagram to the opposite edge BC…

A: The vertices of a ternary phase diagram to the opposite edge represent the components of the…

Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 1.00 mol C6H14 (hexane) is mixed…

A: The formula used to calculate the Gibbs free energy of mixing is: ∆Gmix = nRT×(XA × ln XA + XB × ln…

Q: A solution is prepared by dissolving 2.33 g of C60 (buckminsterfullerene)in 100.0 g of toluene…

Q: 1 At a temperature of 302.8 K, mixtures of phenol andwater exist as two separate phases with mole…

A: The relative amounts of two phases for a mixture is calculated as, naAnBb=xA-xbAxaA-xA

Q: The vapour pressure of dichloromethane at 24.1 °C is 53.3 kPa and its enthalpy of vaporization is…

Q: Phenol and water form non-ideal liquid mixtures. When 7.32 g of phenol and 7.95 g of water are mixed…

A: When phenol is dissolved in water, the mixture is not completely immiscible. Part of the phenol gets…

Q: Figure 1 shows the phase diagram for two partially miscible liquids , which can be taken to be that…

A: Consider point b3. At b3, there are two partially miscible liquids at equilibrium with compositions…

Q: The vapor pressure of pure dichloromethane at 298 K is 57.3 kPa. What is its vapor pressure above…

A: Raoult's law states that the vapor pressure of a component at a given temperature is the product of…

Q: A container is divided into two equal compartments. One contains 3.0 mol H2(g) at 25°C; the other…

Q: Phenol and water form non-ideal liquid mixtures. When 7.32 g of phenol and 7.95 g of water are mixed…

A: (i)

Q: Taking.inte.assount the following temperatures and enthalpies of fusion: benzene, 5.5Cº, 30.4 cal,…

A: In a two-component system, the eutectic composition is the temperature at which the mixture attains…

Q: At 100 degrees celcius the vapour pressures of hexane and octane are 1836 and 354 torr,…

A: Given : Vapour pressure of solution = Posol = 0.88 atm = 0.88 X 760 = 668.8 torr…

Q: There are two separate phases, one of which is 12% phenol and the other is 60% phenol, from a 210…

A: Given : Total mass of mixture = 210 g Composition of phenol in mixture = 35 % Composition of phenol…

Q: At 373 K, the vapor pressures of heptane and methylbenzene are 106.0 and 73.7 kPa, respectively.…

A: Use raoult formula in water phase

Q: A mixture of hexane and heptane forms an Ideal solution. Given that their structural vapour…

A: Ideal solution: A solution which obeys Raoult's law. The component of the solution have same…

Q: calculating ΔHmix for regular solutions, please derive 1) the mole fraction for the minimum of ΔHmix…

Q: (b) At 80 °C, ethylene dibromide and propylene dibromide mixture forms an ideal solution. Given that…

Q: Use the data and formula below to test the validity of the equation (7) for the two binary systems…

A: Viscosity is defined as the liquid’s resistance to flow. It is another type of bulk property.

Q: Consider the following temperature vs composition phase diagram for a hypothetical mixture of…

A: Consider the following temperature vs composition phase diagram for a hypothetical mixture of…

Q: At 300 K, the vapour pressures of dilute solutions of HCI in liquid GeCI4 are as follows: x(HCI)…

A: The mole fraction or the concentration values are 0.005, 0.012, and 0.019. The partial pressure…

Q: Determine the (i) Gibbs energy, (ii) entropy, and (iii) enthalpy of mixing when 2.5 mol toluene is…

A: Ideal mixing of solution is defined as, when solute- solute and solvent-solvent interaction has the…

Q: At 10.4 °C solutions of tetrahydrofuran (THF) and diethyl ether are described as being ideal over…

A: To predict whether the given solution of tetrahydrofuran and diethyl ether is ideal or not.

Q: The vapour pressure of pure liquid A at 293 K is 68.8 kPa and that of pure liquid B is 82.1 kPa.…

A: It is given that the vapour pressure of liquid A at a temperature of 293 K is 68.8 kPa and of the…

Q: ESA.8(b) At 310 K, the partial vapour pressures of a substance B dissolved in a liquid A are as…

A: Based on Henry Law, the partial pressure of gas that is present in the vapor phase is directly…

Q: Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A…

A: The lever rule can be defined as a rule which is used for the determination of the mole fraction of…

Q: Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A…

A: The lever rule can be defined as a rule which is used for the determination of the mole fraction of…

Q: Calculate the Gibbs energy, entropy and enthalpy of mixing when 0.5 mol of hexane is mixed with 2.0…

Q: At a temperature of 302.8 K, mixtures of phenol and water exist as two separate phases with mole…

A: In a phase diagram, the liver rule determines the mole fraction of each compound present in each…

Q: At 10.4 °C solutions of tetrahydrofuran (THF) and diethyl ether are described as being ideal over…

A: To calculate the mole fraction of THF in vapor phase.

Q: Define eutectic point. For a binary ( two.component ) mixture of solid organic compounds

A: Using phase diagram of mixture of two solids.

Q: The phase diagram for the nearly ideal mixture of benzene and toluene is shown below. Consider a…

A: Given that , The mole fraction of toluene=0.6 The phase diagram of Benzene and Toluene mixture is…

Q: How many phases and component are present in (a) homogeneous system (b) an aqueous solution of salt…

A: A question based on phase diagram that is to be accomplished.

Q: 3. The second Virial coefficient of an equimolar binary vapor mixture of methane and n-hexane is…

A: Here the answer is -16743Cm3/ml Using the equation, answer given below

Q: We discussed the temperature-composition phase diagram for a binary system given below. Mole…

A: The number of phases that exists in equlibrium in a system depends on the variables temperature,…

Q: A mixture of hexane and heptane forms an Ideal solution. Given that their structural vapour…

Q: The total vapour pressure of an ideal-dilute liquid mixture of acetone and chloroform with a mole…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: The vapour pressure of pure liquid A at 300 K is 76.7 kPa and that of pure liquid B is 52.0 kPa.…

Q: There are two separate phases, one with a composition of 12% phenol and the other with a composition…

A: Given : Total mass of mixture = 210 g Composition of phenol in mixture = 35 % Composition of phenol…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

There are two separate phases, one of which is 12% phenol and the other is 60% phenol, from a 210 gram phenol-water mixture at a temperature of 60°C with a composition of 35% phenol. Calculate the masses of these phases.
At a temperature of 302.8 K, mixtures of phenol and water exist as two separate phases with mole fractions of phenol of 0.30 and 0.93. Use the lever rule to determine the relative amounts of the two phases for a mixture with an overall mole fraction of phenol of 0.45.
A vapour solution with a mole percentage of 10% benzene is cooled gradually. At what temperature does liquid first appear?
Phenol and water form non-ideal liquid mixtures. When 7.32 g of phenol and 7.95 g of water are mixed together at 60 °C they form two immiscible liquid phases with mole fractions of phenol of 0.042 and 0.161. (i) Calculate the overall mole fraction of phenol in the mixture. (ii) Use the lever rule to determine the relative amounts of the two phases.
In this table you can find the composition and total vapour pressure of a benzene-toluene solution at 120 ºC:
Phenol and water form non-ideal liquid mixtures. When 7.32 g of phenol and 7.95 g of water are mixed together at 60 °C they form two immiscible liquid phases with mole fractions of phenol of 0. 0 42 and 0 .161 . (a) Calculate the overall mole fraction of phenol in the mixture. (b) Use the lever rule to determine the relative amounts of the two phases .
There are two separate phases, one with a composition of 12% phenol and the other with a composition of 60% phenol, from a 210 gram phenol-water mixture with 35% phenol at 60oC. Calculate the masses of these phases.
Aniline, C6H5NH2, and hexane, C6H14, form partially miscible liquid–liquid mixtures at temperatures below 69.1 °C. When 42.8 g of aniline and 75.2 g of hexane are mixed together at a temperature of 67.5 °C, two separate liquid phases are formed, with mole fractions of aniline of 0.308 and 0.618. (i) Determine the overall mole fraction of aniline in the mixture. (ii) Use the lever rule to determine the relative amounts of the two phases.
Calculate the Gibbs energy, entropy, and enthalpy of mixing when 0.50 mol C6H14 (hexane) is mixed with 2.00 mol C7H16 (heptane) at 298 K. Treat the solution as ideal.
Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A equal to 0.40 it was found that the compositions of the two phases in equilibrium corresponded to the mole fractions xA,α = 0.60 and xA,β = 0.20. What is the ratio of amounts of the two phases?
Aniline, C6H5NH2, and hexane, C6H14 , form partially miscible liquid - liquid mixtures at temperatures below 69. 1 °C. When 42.8 g of aniline and 75 .2 g of hexane are mixed together at a temperature of 67.5 °C, two separate liquid phases are formed, with mole fractions of aniline of 0.308 and 0.618.(a) Determine the overall mole fraction of aniline in the mixture. (b) Use the lever rule to determine the relative amounts of the two phases.
How many phases and component are present in (a) homogeneous system (b) an aqueous solution of salt (c) toluene in equilibrium with its vapour