cA Exactly 65.00 mL of a 0.3103 M solution of Naz SO3 were treated with 190.0 mL of 0.4075 M HC10, and boiled to remove the SÖ2 formed. a. What was the mass in grams of SO2 that was evolved? Mass = b. What was the concentration of the unreacted reagent (Naz SO3 or HC104) after the reaction was complete? Concentration = M The unreacted reagent is Drag and drop your selection from the following list to complete the answer: HCIO, NazSO3

cA Exactly 65.00 mL of a 0.3103 M solution of Naz SO3 were treated with 190.0 mL of 0.4075 M HC10, and boiled to remove the SÖ2 formed. a. What was the mass in grams of SO2 that was evolved? Mass = b. What was the concentration of the unreacted reagent (Naz SO3 or HC104) after the reaction was complete? Concentration = M The unreacted reagent is Drag and drop your selection from the following list to complete the answer: HCIO, NazSO3

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter4: Calculations Used In Analytical Chemistry

Section: Chapter Questions

Problem 4.37QAP

See similar textbooks

Similar questions

Ten mL of concentrated H3PO4 (91.7% by mass, d=1.69g/mL) was accidentally poured into a beaker containing 20.0 g of NaOH. Not all the NaOH was consumed. How many grams of NaOH were left unreacted? The equation for the reaction is H3PO4(aq)+3OH(aq)3H2O+PO43(aq)
A chemist prepared a compound that she thought had the formula FeI3. When the compound was analyzed, it contained 18.0% Fe and 82.0% I. Calculate the mass percentage composition expected for FeI3 and compare the result with that found in the analysis. Is this the correct formula of the compound?
Magnesium metal (a component of alloys used in aircraft and a reducing agent used in the production of uranium, titanium, and other active metals) is isolated from sea water by the following sequence of reactions: Mg2+(aq)+Ca(OH)2(aq)Mg(OH)2(s)+Ca2+(aq)Mg(OH)2(s)+2HCl(aq)MgCl2(s)+2H2O(l)MgCl2(l)electrolysisMg(s)+Cl2+Cl2(g) Sea water has a density of 1.026 g/cm3 and contains 1272 parts per million of magnesium a5 Mg2+(aq) by mass. What mass, in kilograms, of Ca(OH)2; is required to precipitate 99.9% of the magnesium in 1.00103 L of sea water?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
The reaction of methane and water is one way to prepare hydrogen for use as a fuel: CH4(g) + H2O(g) CO(g) + 3 H2(g) If this reaction has a 37% yield under certain conditions, what mass of CH4 is required to produce 15 g of H2?
Hydrogen peroxide is used as a cleaning agent in the treatment of cuts and abrasions for several reasons. It is an oxidizing agent that can directly kill many microorganisms: It decomposes upon contact with blood, releasing elemental oxygen gas (which inhibits the growth of anaerobic microorganisms); and it foams upon contact with blood, which provides a cleansing action. In the laboratory, small quantities of hydrogen peroxide can be prepared by the action of an acid on an alkaline earth metal peroxide, such as barium peroxide. BaO2(s)+2HCl(aq)H2O2(aq)+BaCl2(aq) What amount of hydrogen peroxide should result when 1.50 g of barium peroxide is treated with 25.0 mL of hydrochloric acid solution containing 0.0272 g of HCI per mL?
An experiment calls for a 0.4500 M solution of aluminum carbonate. The storeroom has only 32.00 g of the solid. (a) What is the maximum volume of solution that can be prepared? (b) The reaction in the experiment requires 0.1450 mol of carbonate ion. How many milliliters of this solution are required to provide 0.1450 mol?
The reaction of iron(III) oxide with aluminum to give molten iron is known as the thermite reaction (page 172). Fe2O3(s) + 2 Al(s) 2 Fe(l) + Al2O3(s) What amount of Al, in moles, is needed for complete reaction with 3.0 mol of Fe2O3? What mass of Fe, in grams, can be produced?
Consider reacting copper(II) sulfate with iron. Two possible reactions can occur, as represented by the following equations. copper(II)sulfate(aq)+iron(s)copper(s)+iron(II)sulfate(aq)copper(II)sulfate(aq)+iron(s)copper(s)+iron(III)sulfate(aq) You place 87.7 mL of a 0.500-M solution of copper(II) sulfate in a beaker. You then add 2.00 g of iron filings tu the copper(II) sulfate solution. After one of the above reactions occurs, you isolate 2.27 g of copper. Which equation above describes the reaction that occurred? Support your answer.
MTBE, Methyl tert -butyl ether, CH3OC(CH3)3, is used as an oxygen source in oxygenated gasolines. MTBE is manufactured by reacting 2-methy1propeue with methanol. (a) Using Lewis structures, write the Chemical equation representing the reaction. (b) What volume of methanol, density 0.7915 g/mL, is required to produce exactly 1000 kg of MTBE, assuming a 100% yield?