Calculate the maximum mass (in g) of AgCl lost in a chloride analysis as a result of washing the  of silver chloride with 130 mL of water at room temperature. (Note: Ksp for silver chloride is 0.000000000160. Pay attention to the sig.fig. in your calculation. Keep three sig.figs. in the answer.)

Q: Calculate the maximum mass (in g) of AgCl lost in a chloride analysis as a result of washing the  of…

A: Given, The volume of water = 143 ml  Ksp of AgCl = 0.000000000160. = 1.6 x 10-10

Q: Consider thé following statement: Statement I: Matrix is equal to blank plus the analyte. Statement…

A: Matrix:  Matrix refers to the components of a sample other than the analyte of interest.  Analyte: a…

Q: The thiourea in a 1.563 g sample of an organic material was extracted into a dilute H2SO4 solution…

A: Given,  Mass of thiourea = 1.563 g  Molarity of Hg2+ = 0.009284 M  Volume of Hg2+ = 36.43 mL  Given…

Q: Limiting Reagent Investigation Introduction: In this lab a precipitate will be formed by mixing…

A:

Q: A student conducts the experiment as outlined in the posted procedure, and records the following…

A: Answer

Q: Solubility Curve for KNO3 150

A: We will calculate mass of solute

Q: Part A. Preparation of Saturated Solutions of Cadmium Oxalate 1. You need to prepare three saturated…

A: A total of 50mL of 0.100 M cadmium nitrate is taken in the burette and a measured volume of cadmium…

Q: 250 mg of a sample of minium (Pb3O4) is solubilized and weighed as PbSO4 by going through the…

A: A solution consists of solute and solvent. A solute is defined as the component that is present in…

Q: Give equation and explanation for Sevcick analysis

A: Randles-Sevcik gave an equation to determine the rate of the peak current which is generally denoted…

Q: In the titration calculation, moles of KOH were calculated from the known molarity and measured…

A: Given : moles of succinic acid has been calculated in the procedure  To find : mass of Succinic acid…

Q: Potassium chromate is slowly added to a solution containing 0.10 MAGNO, and 0.10 M Ba(NO,), What is…

A: Given: Concentration of Ba(NO3)2 = 0.10 M And concentration of AgNO3 = 0.10 M

Q: A student conducts the experiment as outlined in the posted procedure, and records the following…

A:

Q: Assuming that the uncertainty in the readings does not change, why is it not acceptable to base…

A: Reducing uncertainty in titration is important to determine the desired concentration or the…

Q: How many moles of Cr2O3 will form when 0.35 moles of Cr is mixed with 0.25 moles of O2?

A: Since you have posted a  question with sub-parts , we are entitled to answer the first three…

Q: The concentration of a NaOH solution was determined in a single experiment by titrating a weighed…

A: Weight KHP + container (final) = 10.8364±0.0001 g Weight KHP + container (initial) = 11.6723 ±0.0001…

Q: Ca2+ in a drinking water sample was analyzed by the following reactions below: Ca2+(aq) +…

A: Hey, since there are multiple questions posted, we will answer first question. If you want any…

Q: Why is it all right to use a wet flask or to use water during the titration?

A: It has to be clean and dry so you have the right amount of solution taken out from you flask to be…

Q: ticides. Which pre-concentration method do you suggest to extract these compounds from the tomato…

A: Dispersive "liquid–liquid micro extraction" (DLLME) technique was used to extract the…

Q: analysis

A:

Q: Two flasks filled with NH3(g) and HBr(g) and both balloons were sealed with taps which were…

A:

Q: In a Gravimetric Analysis of Chloride experiment, why is it necessary that the samples are left in a…

A:

Q: The iron (55.847 g/mol) in a 700.0 mL sample of a natural water was determined by precipitation of…

A: Given: Volume of sample = 700mL Mass of Fe2O3 = 0.1168g

Q: a 523.1 mg sample of impure KBr is treated with excess AgNO3 and 814.5 mg AgBr is obtained. What is…

A: Percentage purity = (mass of the pure chemical / total mass of the sample) x 100%

Q: Summary of Level of Saturation in chemistry solutions

A: The substances which is present in lesser amount is termed as solute. On the other hand, substances…

Q: Can we store copper sulphate in (i)Zinc vessel (ii) Silver vessel? Givereasons.

A: No, we cannot store copper sulphate in zinc vessel.  Because zinc is more reactive than copper and…

Q: A student conducts the experiment as outlined in the posted procedure, and records the following…

A:

Q: Analyze the table of some common inorganic precipitating agents and answer the following questions:…

A:

Q: For Questions 20-24 consider the following scenario: A 0.8390 g of an unknown sample containing…

A: Given data,

Q: Why is an Erlenmeyer flask preferred over a beaker when performing a titration?

A: Erlenmeyer flask has tapered sides thus it makes more accurate titration than that is from breaker .…

Q: In the reaction of calcium sulfate aqueous with barium nitrate aqueous produced barium sulfate as…

A:

Q: 1. A student dissolves 2.006 g of FeSO4-7 H₂O in 40 mL of sulfuric acid and then dilutes it to…

A:

Q: When 38.0 mL of 0.1250 M H,SO, is added to 100. mL of a solution of PbI,, a precipitate of PbSO,…

A: Given: Concentration of H2SO4 = 0.1250 M Volume of H2SO4 solution = 38.0 mL = 0.038 L…

Q: Upon completion of an experiment involving a reaction between copper wire, Cu(s), and aqueous silver…

A: We have to tell the role of AgNO3(aq)

Q: B. Decantation Setting aside one of the tubes in A in a test tube rack, you allow the solid…

A:

Q: 15.8 g of a mixture of inert solid and barium chloride (FW = 208.23g/mol). After being dissolved in…

A: The barium chloride present in the mixture reacts with silver nitrate to form the precipitate of…

Q: A 0.5152 g solid sample containing a mixture of LaCl, (molar mass = 245.26 g/mol) and Ce(NO,),…

A:

Q: When a 8.000 g of mineral ore sample containing Sn(CO3)2 (238.7 g/mol) and other inert material was…

A: Given that,  8.000 g of a sample containing Sn(CO3)2 and other inert material was is treated with…

Q: In Part A of this experiment, you prepare 5 solutions of FeSCN2* [one of them is just a blank…

A: No of moles = Molarity * Volume (L)

Q: Shana, a student in the Analytical Chemistry class, performed a Redox Titration to determine the…

A: First of all calculate the moles of KIO3 prepared- n: moles of KIO3. m: given mass of KIO3. M:…

Q: If the same mass of Na2SO4 (MW: 142 g/mol) and K2SO4 (MW: 174 g/mol) were weighed and used for the…

A: The balanced equation for the formation of the precipitate, BaSO4(s) is: Ba2+(aq) + SO42-(aq)…

Q: Off and Gun were assigned to subject five hydrocarbons to solubility tests, bromination, and…

A: Here we have to fill up the above chart about solubility and reactivity of compounds-

Q: A sample of magnetite (impure Fe3O4) weighing 0.5000 g is fused with oxidizing flux and the ferric…

A: Magnetite is an ore of Fe with the formula Fe3O4.

Q: An ore is treated with concentrated nitric acid and potassium chlorate to convert all S (32.06…

A:

Q: 12.1 g of goztic acid was dissolved in water weighing 87.9 G. The mass fraction (%) of acid in the…

A: Mass fraction and mass percentage can be calculated as follows:

Q: Several alloys that contained only silver and copper were analyzed by dissolving weighed quantities…

A: Using mole concept to solve.

Q: a. An 18-mg strip of magnesium metal reacts in 5.0 mL of 3.0 M HCI over a given time period.…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An analyst was assigned to work a sample with minerals. This iron-containing sample was analyzed by…

A: First , we calculate moles of ferric oxide by dividing mass with molar mass. based on reaction…