Calculate the Voltage and the Current in the Diode in the 2ND approximation given that the diode is SILICON. A6 1k Ohm The current in the Diode is 5k Ohm а. 1 mA b. 9.2 mA 220 Ohm c. 8.5 mA d. 10 mA The voltage in the diode is а. 1 V b. 0 V с. 0.7 V d. 8.3 V

Calculate the Voltage and the Current in the Diode in the 2ND approximation given that the diode is SILICON. A6 1k Ohm The current in the Diode is 5k Ohm а. 1 mA b. 9.2 mA 220 Ohm c. 8.5 mA d. 10 mA The voltage in the diode is а. 1 V b. 0 V с. 0.7 V d. 8.3 V

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: 15 In the circuit shown, determine the current flowing through the resistor R1. * R2 1K R1 5V D2 1K

A: The solution is given below

Q: Calculate the Voltage and the Current in the Diode in the 3rd approximation given that the diode is…

Q: Which of the following ratings (PIV- Peak Inverse Voltage and temperature) is true? A)Si diodes have…

A: Peak Inverse Voltage ratings of Silicon diodes are greater than Germanium diodes. And also Silicon…

Q: D. D. 10 V 48 Q ww D,

Q: Consider a palladium Schottky diode at T = 300 K formed on n-type germanium doped at Ng = 5X 1018 cm…

Q: Given the circuit below. Answer the following: A. Which diodes turned ON? The diodes are made…

Q: 2. For the given circuit solve the following: a. The current flowing through 200 and 5k0 resistors,…

A: Given: voltage of Ge diode = 0.3 V voltage of Si diode = 0.7 V

Q: Estimate the forward bias voltage of P-N diode, if a forward current of 9.75mA is flowing through…

Q: VD (V) Ip (mA) If the relationship between the voltage V₂ and the current ID as shown in the…

A: As per Bartleby policy we can answer only three subparts at a time, so I am solving first three for…

Q: (a) A diode used in the Figure Q2 (a), has a characteristic as shown by the I-V graph. Obtain the…

A: Applying KVL in the given circuit 25ID=2.5-VDID=2.525-VD2.5ID=-VD2.5+110 Compare it with equation of…

Q: 4670V = Vs R = 200kΩ C = 0.1μF Consider the circuit and parameters illustrated above. If a…

Q: Sketch i0 and v01 for the network below for the input shown (Both diodes are Si. Vd = 0.7 V)…

A: During the positive half cycle only diode D1 is forward biased and it will conduct and with the help…

Q: Solve the following problem in detail.

A: If W is the thickness of the depletion region or space charge region for a p-n junction diode and if…

Q: For the series diode configuration of Fig.a , employing the diode characteristics of Fig.b ,…

A: In this question, We need to calculate the diode current and voltage across the diode. Here diode…

Q: 42) Find the diode current of a diode operating at a temperature of 20°C if Iş = 40 nA, n= 2 (low…

A: The solution is given below

Q: A germanium diode is connected to a load resistance of 1.5 kQ and is supplied with 12-V such that…

Q: +. RL VL

A: In one time period the diode will be fully forward biased and all current will flow through it. In…

Q: (a) Calculate the current at t = 0+ in the circuit shown. (b) Calculate IF, IR, and the storage time…

A: Given data: The value of resistance is: 1 kΩ a) The expression for the current is given as, At t =…

Q: 36 D1 D2 V Find the current-voltage relationship of the assumed circuit shown assuming both diodes…

A: Ad D1 will be forward biased and D2 will be reverse biased, only D1 will be conducting. The forward…

Q: Calculate the reverse current of P-N diode, if a forward current of 10mA is flowing through it if…

Q: In the circuit shown, determine the current flowing through the resistor R1. * R2 2K D1 R1 9V 2K…

A: The solution is given below

Q: 1.42 (a) The reverse-saturation current of each diode in the circuit shown in Fig- ure PL.42 is Iy =…

Q: e) Draw a Diode Symbol and label the anode and the cathode. 2ka f) Find V, in the circuit shown in…

A: In e part we have to label the diode terminal In part f we have to find the Vo voltage

Q: 2. Sketch the output V and determine the DC level of the output signal for the given network below.…

Q: In the circuit shown, determine the circulating current. D1 R1 D2 1K 6V

Q: Consider a p+n Si diode with Na = 1018 cm−3 and Nd = 1016 cm−3. The hole diffusion coefficient in…

A: Step 1:Calculating the reverse saturation current…

Q: (b) In the bridge type circuit shown in Fig. QI, the diodes are assumed to be ideal. Assume primary…

Q: 7 In the circuit shown, determine the voltage across resistor R1. R2 2K D1 D2 R1 5V 2K

Q: In the circuit shown, determine the current flowing through the resistor R1. * R2 2K D1 D2 R1 9V 2K

Q: Given the circuit below, answer the following: A. Identify which diodes are turned ON. The diodes…

Q: V1 D1 머 D 8 V2 D2 Vo D 10 R1 1000

Q: In the circuit shown, determine the voltage across resistor R1. R2 2K D1 R1 9V 2K 1.5V

A: In this question, We need to determine the voltage across the R1 resistance using the second…

Q: A diode is doped with NA = 1018/cm3 on the p-type side and ND =1019/cm3 on the n-type side. (a)What…

A: Given The intrinsic carrier concentration at room temperature ni=1010/cm3 The acceptor-type impurity…

Q: The non-ideal characteristics of the diode is given in Fig.1. Find the power consumed (absorbed) by…

Q: Assuming the practical model, what PIV rating is required for the diode? The transformer is…

Q: 1. Determine the dynamic (ac) resistance of the diode at a forward current of 10 milliAmpere using…

A: 1) To find the dynamic resistance of the diode Given, forward current through the diode = 10 mA

Q: Given the circuit below, answer the following: A. Identify which diodes are turned ON. The diodes…

A: Circuit diagram is given as,

Q: 14 In the circuit shown, determine the current flowing through the resistor R1. * D1 R1 6V 1K D2 Kt

Q: A certain zener diode has a maximum power rating of 300 mW at 40 deg Cand a derating factor of…

A: Formula for calculating the change in zener voltage due to change in temperature is given by ∆Vz…

Q: In the circuit shown, determine the current flowing through the resistor R1. * R2 2K D1 D2 R1 5V 2K

A: In this question, We need to determine the current flowing through the resistor R1. Use 2nd…

Q: A two-zone DC chopper with a DC input voltage of 200 V and a switching frequency of 20 kHz The…

A: Given data: Vin=200 Vfs=20 kHzL=2 mHIL=100 Aλ=0.4 Note: As per our policy, I have attempted the…

Q: Question 10 Using the following data for a Si p-n junction diode maintained at T = 300 K. 1016 em 3…

Q: In the circuit shown below, the ideality factor n of the diode is unity and the voltage drop across…

A: Given values are - Ideality factorη=1Diode voltage dropVD=0.7VoltRoom Temperature. Given circuit is…

Q: The current flowing in a PN junction diode at room temperature is 15mA, when the forward bias…

A: According to guidelines we need to solve only first question. According to the question we have to…

Q: a ) A PN diode has forward voltage drop VD= 0.3 V at 20 ° C . Assume the emission coefficient n = 1…

Q: From the diode circuit shown below, If E=30 V and RL=802, determine the current supplied from the…

Q: Question:1 A diode whose internal resistance (forward biased) is 20 Q is to supply power to a 1000 2…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Calculate the total current of a circuit with a 9.5 V voltage source connected in series with a…

A: In this question we will find current...

Q: 18 If the voltage at the cathode of a diode is -1 V, and the anode is connected to the ground, then…

Q: Which of the following ratings (PIV- Peak Inverse Voltage and temperature) is true? O Si diodes have…

A: Need to find the correct option

Question

Complete Solution. Calculate the voltage and the current of the diode in the 2nd approximation when the diode is SILICON

Calculate the Voltage and the
Current in the Diode in the 2ND
approximation given that the
diode is SILICON.
-9 V
5k Ohm
1k Ohm
The current in the Diode is
а. 1 mA
b. 9.2 mA
220 Ohm
c. 8.5 mA
d. 10 mA
The voltage in the diode is
а. 1 V
b. 0 V
c. 0.7 V
d. 8.3 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is CEMF?
How is a solid-state diode tested? Explain.
A silicon diode is in connected to a DC voltage source with Forward biased, the net currentflowing through the diode is (25mA) where the applied voltage across the terminals of thediode is (820mV). Determine diode temperature, if Is "dark saturation current", the diodeleakage current density in the absence of light is 3.4 × 10−10 A
A 1N4738A zener diode has a ZZ of 4.5 Ω. Taking the data from the datasheet we have VZ = 8.2 V with a test current, IZ, of 31 mA. What is the voltage across the zener terminals when the current is 15 mA? When the current is 55 mA? Make the representation of the values by means of their curve characteristic.
The output of a diode used as a solar cell is given by IC =1−10−15[exp(40VC)−1] amperes What operating point corresponds to Pmax? What is Pmax? What are the values of ISC and VOC?
Since , C= 47 micro farad, RL= 1Kohm, Vs= 90cos2000t V What is the diode current in the one-time fill time range of the capacity?
The diode current in a p-n junction is modeled exponentially (given below.) When the p-n junction is polarized with 0.7V and 0.75V, the currents flowing through the diode are again measured on the basis of 1.36 mA and 7.20 mA. Accordingly, what is the ideality factor? (Note: Take the thermal voltage as mV)
A diode has a doping of ND = 1015/cm3 on the n-type side and NA = 1017/cm3 on the p-type side. What are the values of wdo and φj? What is the value of wd at a reverse bias of 10 V? At 100 V?
Make a sketch of the I–V characteristic curve for a diode with Is = 0.02 pA for VD values from zero to 0.7 V. Use the approximation ID = Is e^(Vd/VT) What is the slope of a line tangent to the curve at ID = 2 mA?
A diode with n =1.6 conducts 45 mA at 0.75V at room temperature. Find the saturation current Is at room temperature (using the exponential model).
A diode is tested at the presence of dc+ac source, where the diode's average current level (dc level) is 0.2 mA. Find the temperature (both in Kelvin and Celsius) if the dynamic resistance is approximately 200 ohms
A 1N4733 zener diode has a Zz of 7 ohms. Considering the data of the manufacturer's hona, the Vz = 5.1 V with a test current, Iz, of 49 mA. What is the voltage across the zener terminals when the current is 65 mA? When the current is 25 mA? Include the graph where these values are shown.