Calculation of the volume of 1.25 M NaOH (aq.) required to extract 1.0 gram of 2-naphthol. Use 20% mole excess of NaOH (i.e. use 1.2 mol of NaOH for every 1 mol of 2-naphthol).
Q: 1. What is the gravimetric factor of SO3 in BaSO4? NOTE: Present complete solution and also the…
A: Answer:- This question is answered by using the simple concept of calculation of gravimetric factor…
Q: A 25%w/w aqueous phosphoric acid solution has been prepared. Molecular weight of phosphoric acid is…
A: Given data 25 % w/w aqueous phosphoric acid solution. molar mass of phosphoric acid (solute) =…
Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 0.50 mol C6H14 (hexane) is mixed…
A: The mole fraction of hexane and heptane is calculated as shown below. The mole fraction of hexane is…
Q: The density of a 2.25 M resolution with ethanol C2H5OH is measured at 0.977 g/mL. Calculate mass…
A: Here we have to determine the mass percentage of ethanol in the given solution.
Q: You have an aqueous solution of pyridinium chloride (C6H5N'HCI) and you want to extract it with a…
A: Like dissolved like, polar compounds are soluble in polar solvent and nonpolar ones are soluble in…
Q: Water and 1-butanol are only partially miscible, so that when the two liquids are mixed, separate…
A:
Q: The partial molar volumes of two liquids A (M = 241.1 g mol1) and B (M = 198.2 g mol1) in a mixture…
A:
Q: At 298 K, the electrolytic conductivity of a 0.2 M KC1 solution is 2.50 X 10-2S cm-1. Calculate its…
A:
Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 1.00 mol C6H14 (hexane) is mixed…
A: The formula used to calculate the Gibbs free energy of mixing is: ∆Gmix = nRT×(XA × ln XA + XB × ln…
Q: Determine the mole fraction of ethanol in a 10% by volume aqueous ethanol solution. Given: Methanol…
A: A numerical problem based on mole fraction, which is to be accomplished.
Q: Table 3b.1. Observations on the metal paper clip or needle placed on the surface of distilled water…
A: when we put tissue paper metal paper clip on it into the distilled water we found that paper clip…
Q: The mean activity coefficients of KCl in three dilute aqueous solutions at 25 °C are 0.927 (at 5.00…
A:
Q: Describe the primary and secondary criteria for having achieved V ̇O2 max.
A: V̇O2 max (also maximal oxygen consumption, maximal oxygen uptake or maximal aerobic capacity) is…
Q: Nacl: NaCl dissolution: (aq) predicted AS value for NaCl dissolution: NaNO3: NANO3 dissolution:…
A: In the given question solid, liquid and gasesuos state find
Q: A 0.1 M solution of acid was used to titrate 10 ml of 0.1 M solution of alkali and the following…
A: Given data :- 0.1 M solution of acid was used to titrate 10 ml of 0.1 M solution of alkali Volumes…
Q: A reagent bottle contains 250 cm3 of 0,4 mol.dm–3 oxalic acid (C2O4H2) solution. Calculate the mass…
A: Initial concentration of oxalic acid = 0.4 mol/dm3
Q: The molar conductivities at infinite dilution of aqueous solutions of NH4Cl, NaCl, and NaOH are,…
A:
Q: Determine the mole fraction of acetone in a 1.00 m solution of acetone (CH3COCH3) dissolved in…
A: Given-> Molality = 1.00 m Density of acetone = 0.788 g/cm3 Density of ethanol = 0.789 g/cm3
Q: 1. What is the MW of the analyte? 2. What is the meq of the analyte? 3. What will be the weight (in…
A: Since you have asked a question with multiple subparts we will answer the first three for you. To…
Q: Sucrose (C12H22O11), which is commonly known as table sugar, reacts in dilute acid solutions to form…
A: Given reaction : C12H22O11 (aq) + H2O (l) → C6H12O6(aq) + C6H12O6 (aq)
Q: What is the molar concentration of NaOH in a 20% (w/v) NaOH…
A: Solution- The molecular weight of NaOH = 40.00 g/mol. We have to calculate the molar concentration…
Q: The distribution coefficient of an organic salt between hexane and water is 90. A quantity of 0.1…
A: Fraction of salt present in the aqueous phase after four 25 mL of aliquots of hexane can be given as…
Q: Carboxylic acids, including fatty acids and benzoic acids, are often present in both municipal and…
A: As a result of a thorough waste characterization program and preliminary evaluation of the costs…
Q: A- preparation of approximately (0.1N) HCL 1. Calculate the normality of the concentrated HCL. Sp.g…
A:
Q: Given the following data, prove that the distribution of benzoic acid in water and benzene follow…
A: The total number of moles/mass of benzoic acid is not given to calculate the extracted number of…
Q: Briefly explain the principles involved in the separation of the components of a mixture by solvent…
A: Extraction is a method used for the separation of organic compound from a mixture of compound. This…
Q: Estimate the vapour pressure of sea water at 20 °C given that the vapour pressure of pure water is…
A:
Q: By how much does the chemical potential of carbon dioxide at 310 K and 2.0 bar differ from its…
A:
Q: Explain the concept of partial molar volume, and justify the remark that for a binary solution, the…
A: We need to explain the concept of partial molar volume, and justify the remark that for a binary…
Q: Commercial perchloric acid (100.46 g/mol) 71% (w/w) with specific gravity of was diluted by taking…
A: Molar concentration : It is define the mole of substance in one Liter volume of solution.…
Q: Temperature - distillate volume plot for fractional distillation of benzene (b. pt. 80°C) and…
A: Boiling point of benzene = 80◦ c Boiling point of toluene = 110◦ c
Q: Define binary mixture 2. Define density 3. Give an abstract of determination of excess molar volume…
A: 1.Binary mixture :-A binary mixture consists of two types of molecules, A and B, x is the fraction…
Q: How do I estimate the mean ionic activity coefficient of a 0.00125 mol/kg CuBr2 at 25°C and how do I…
A: Welcome to bartleby ! Introduction : We have to calculate mean ionic activity coefficient .
Q: The distribution coefficient, KD (C ether/C water), between ether and water for aspirin at room…
A: Distribution coefficient is the ratio of concentration of solute in organic phase to the…
Q: At a temperature of 302.8 K, mixtures of phenol and water exist as two separate phases with mole…
A: In a phase diagram, the liver rule determines the mole fraction of each compound present in each…
Q: Briefly describe the principles for separating the components of a mixture by solvent extraction.
A: Extraction is the process of separation of substances from its aqueous solution by shaking with a…
Q: Oceanic uptake of carbon dioxide is thus described: CO2 (g) + H2O ⇔ H2CO3, K = [H2CO3]/PCO2 = 3 x…
A: In order to find the pH of ocean water hydrogen ion concentration should be known, pH value is…
Q: Red cabbage anthocyanin extraction 1. Weight of red cabbage is 1438 g. What is the volume of…
A: Since you have asked second questions, we will solve the second question only. If you want any…
Q: In fractional distillation, the greater the length of a fractionating column: * the lower its…
A:
Q: 2. Describe the underlying principles behind the complexometric determination of water hardness.…
A: Water is pure when nothing is added to it, but it becomes hard when the calcium and magnesium ions…
Q: The solubility of suberic acid C6H12(COOH)2 is 0.14 g/100 ml H2O and 0.56g/100 ml ethyl ether at 15…
A:
Q: Carboxylic acids, including fatty acids and benzoic acids, are often present in both municipal and…
A:
Q: A student determines the molar mass of a liquid unknown by the method used in this experiment. She…
A: General information: Freezing point depression (∆Tf) = Change in freezing point (∆Tf) = Kf × m…
Q: Temperature - distillate volume plot for fractional distillation of benzene (b. pt. 80°C) and…
A: When temperature becomes above than that of the boiling point, then that particular liquid start…
Q: There are two separate phases, one with a composition of 12% phenol and the other with a composition…
A: Given : Total mass of mixture = 210 g Composition of phenol in mixture = 35 % Composition of phenol…
Q: Calculate the mass fraction and weight percent of each in the following mixture. 25.0 g CCl4 and…
A: The answer to both the questions can be calculated as follows -
Q: 1) 1500 kg mixture contains 15% acetone, 75% water and 10% Acetic acid by weight. a) Calculate the…
A:
Q: Describe the preparation of 400 mL of 6 F H;PO4 from the commercial solution which is 85% (w/w)…
A: Since you have asked multiple question, we will solve the first question for you.If you want any…
Calculation of the volume of 1.25 M NaOH (aq.) required to extract 1.0 gram of 2-naphthol. Use 20% mole excess of NaOH (i.e. use 1.2 mol of NaOH for every 1 mol of 2-naphthol).
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- Calculate the resulting concentration of a solution prepared by diluting 20.00 mL of concentrated hydrochloric acid to 500.0 mL. The specifications of the concentrated hydrochloric acid are 37.2%(w/w) HCl and specific gravity =1.19. (MM= 36.46g/mol)A sample containing chlorophenol, C6H4ClOH, was analysed by gravimetric analysis. A 0.783-g of this sample goes through a chemical process allowing the chlorine in the chlorophenol to precipitate as silver chloride, weighing 0.271 g. Calculate the % (wt/wt) of the chlorophenol in the sample, assuming that chlorophenol is the only source of chlorine in the sample. Provide your answer to two decimal places and without units. Avoid using scientific notation.What is the molar concentration of NaOH in a 20% (w/v) NaOH solution (Mr(NaOH) = 40.00). At what place value is your limit of precision?
- The distribution coefficient of an organic salt between hexane and water is 90. A quantity of 0.1 mol of the salt dissolved in 100ml of water. Predict how many moles of the salt will remain within the aqueous phase following extraction by using four 25ml of aliquots of hexane to extract the salt from the aqueous solutionDescribe in words and by means of complete chemical equations, how a mixture of 1.25 g of benzoic acid tertbutylbenzene can be separated by applying the separation of 2 components by liquid-liquid extraction.If one mixes 50cm³ of EtOH and 50cm³ of H2O at room temperature; will the total volume of the solution be 100.0 cm³? Justify answer with appropriate calculations and explanations
- In the laboratory, a student was tasked to prepare a stock solution of HCl for titration. The available analytical grade HCl solution in the stock room was labelled 35% w/v HCl. The student proceeded to prepare the stock solution by mixing 10mL of the HCl solution with 490mL of analytical grade water. Then, the solution was further diluted by adding 5mL, since the total volume of the solution did not reach the 500mL etched mark on the volumetric flask. To prepare the titrant, the student mixed 10mL of the stock solution, then added 40mL of analytical grade water. The titrant was subsequently used to determine the concentration of two titrand. *Use the table as a reference 1. What is the normality of the available HCl reagent in the stock room?* 5.08 N 10.15 N 20.3 N 11.0 N None of the choices 2. What is the normality of the stock solution of HCl?* 0.09N 0.10N 0.11N 0.12N None of the choices 3. What is the normality of the titrant?*…The partial molar volumes of propanone and trichloromethane in a mixture in which the mole fraction of CHCI3 is 0.4693 are 74.166 cm3 mol-1, and 80.235 cm3 mol-1, respectively. What is the volume of a solution of total mass 1.000 kg?KMnO4 and Na2C2O4 solutions were used in the reactions that took place in a back titration to determine the amount of H2O2 in a sample. Calculate the concentration of H2O2 in the sample (w / v) as% by making appropriate assumptions for the volumes and normality of all these solutions.
- 2 what is the purpose of BSC Level 1 & 2, proper layout, performance, and its application in biosafety assessmentDerive a general expression that shows pH dependence of the distributioncoefficient defined in (2-20) for a weak acid between a fermentation broth and an organic solvent.The osmotic pressure at the base of a houseplant kept at 27ºC is 1.6 × 104 N/m2. Calculate the molar concentration of the dissolved molecules in the plant’s veins if there are no dissolved molecules in the soil water.