capacitor with square plates, each with an area of cm² and plate separation 48 mm, is being charged by a 255-mA current. (a) What is the change in the electric flux between the plates as a function of time? (Use the following as necessary: t. Do not use other variables, substitute not include units in your answer. Enter the magnitude.) ODE dt (h) What is the magnitude of the displacement current between the capacitor's plates?

capacitor with square plates, each with an area of cm² and plate separation 48 mm, is being charged by a 255-mA current. (a) What is the change in the electric flux between the plates as a function of time? (Use the following as necessary: t. Do not use other variables, substitute not include units in your answer. Enter the magnitude.) ODE dt (h) What is the magnitude of the displacement current between the capacitor's plates?

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 12Q

See similar textbooks

Similar questions

A wire of circular cross-section carries a current density that is not uniform but varies with distance from the center asj(r)=Ar/Rfor radius rin the range 0<r<R. Here, Ais a constant with units of amperes per square meter, and the radius of the wire is R=3.9mm. (a) If the total current is 4.5A , what is the constant A , in amperes per square meter? (b) What is the maximum value of the enclosed current, in amperes? (c) What is the maximum value of the magnetic field, in units of teslas?
A capacitor with square plates, each with an area of 37.0 cm2 and plate separation d = 2.44 mm, is being charged by a 555-mA current. (a) What is the change in the electric flux between the plates as a function of time? (Use the following as necessary: t. Do not use other variables, substitute numeric values. Assume that dΦE/dt is in V · m/s and t is in seconds. Do not include units in your answer. Enter the magnitude.)
The prefix “mega” (M) and “kilo” (k), when referring to amounts of computer data, refer to factors of 1024 or 210 rather than 1000 for the prefix kilo, and 10242 = 220 rather than 1,000,000 for the prefix Mega (M). If a wireless (WiFi) router transfers 150 Mbps of data, how many bits per second is that in decimal arithmetic?
By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s? values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 25 s
In a 2 ns interval, 10^8 electrons are discharged from a capacitor. What is the average current flow, in mA, due to this discharge?
How much currenta) flows in a wire 4.80m long if the maximum force on it is 0.725N when placed in a uniform 0.0800T field? b) flows through a device with a resistance of 9.7ohms when connected to a 112V supply? How much charge passes through the device in an hour?
By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=1μF. What is the current at t=2.5 s? f values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 5.7 s
What do you think will happen to a load that was rated at 1.8v, 35mA if it was connected on a 5v power supply? Is the current setup provides optimal operation? or is there better construction for the circuit? Considering that you are only going to use the given power supply and the load?
The radiation resistance of a small dipole current element of length l at a frequency of 3 GHzis 3 ohms. If the length is changed by 1%, then the percentage change in the radiationresistance, rounded off to two decimal places, is______________%.
What percentage of Stanley Milgram's participants shocked all the way to 450 volts?
At room temperature, What is the strength of the electric field in a 12-gauge copper wire with a diameter of 2.05mm that is needed to cause a 2.75A current to flow? What field would be needed if the wire were made of silver instead?
how does current flows in p type and n type semi-conductors?