Suppose a 250. mL flask is filled with 1.0 mol of CO, 1.5 mol of H,O and 0.10 mol of H,. This reaction becomes possible: 2' CO(g) + H,O(g) = CO,(g) + H,(g) Complete the table below, so that it lists the initial molarity of each compound, the change in molarity of each compound due to the reaction, and the equilibrium molarity of each compound after the reaction has come to equilibrium. Use x to stand for the unknown change in the molarity of H,. You can leave out the M symbol for molarity. H,0 co2 H2 CO initial change equilibrium O

Suppose a 250. mL flask is filled with 1.0 mol of CO, 1.5 mol of H,O and 0.10 mol of H,. This reaction becomes possible: 2' CO(g) + H,O(g) = CO,(g) + H,(g) Complete the table below, so that it lists the initial molarity of each compound, the change in molarity of each compound due to the reaction, and the equilibrium molarity of each compound after the reaction has come to equilibrium. Use x to stand for the unknown change in the molarity of H,. You can leave out the M symbol for molarity. H,0 co2 H2 CO initial change equilibrium O

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter3: Mass Relations In Chemistry; Stoichiometry

Section: Chapter Questions

Problem 22QAP: An experiment calls for a 0.4500 M solution of aluminum carbonate. The storeroom has only 32.00 g of...

See similar textbooks

Similar questions

On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
What is the difference between a solute and a solvent?
39. Standard solutions of calcium ion used to test for water hardness are prepared by dissolving pure calcium carbonate. CaCO3, in dilute hydrochloric acid. A 1.745-g sample of CaCO3 is placed in a 250.O-mL volumetric flask and dissolved in HCI. Then the solution is diluted to the calibration mark of the volumetric flask. Calculate the resulting molarity of calcium ion.
A student wants to prepare 1.00 L of a 1.00-M solution of NaOH (molar mass = 40.00 g/mol). If solid NaOH is available, how would the student prepare this solution? If 2.00 M NaOH is available, how would the student prepare the solution? To help ensure three significant figures in the NaOH molarity, to how many significant figures should the volumes and mass be determined?
Barium chloride solutions are used in chemical analysis for the quantitative precipitation of sulfate ion from solution. :math>Ba2+(aq)+SO42(aq)BaSO4(s) ppose a solution is known to contain on the order of 1 50 mg of sulfate ion. What mass of barium chloride should be added to guarantee precipitation of all the sulfate ion?
A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
What is the molarity of each ion present in aqueous solutions of the following compounds prepared by dissolving 20.00 g of each compound in water to make 4.50 L of solution? (a) cobalt(lll) chloride (b) nickel(lll) sulfate (c) sodium permanganate (d) iron(ll) bromide
3.62 What is the molarity of each ion present in aqueous solutions prepared by dissolving 20.00 g of the following compounds in water to make 4.50 L of solution? (a) cobalt(III) chloride, (b) nickel(III) sulfate, (c) sodium permanganate, (d) iron(II) bromide
When solutions of silver nitrate and sodium carbonate are mixed, solid silver carbonate is formed and sodium nitrate remains in solution. If a solution containing 12.43 g sodium carbonate is mixed with a solution containing 8.37 g silver nitrate, calculate the mass of each of the four substances present after the reaction is complete.
4.59 Aluminum dissolves in HCI according to the equation written below, whereas copper does not react with HCl. 2Al( s )+6HCl( aq ) 2AlCl 3 ( aq )+ 3H 2 ( g ) A 35.0-g sample of a copper—aluminum alloy is dropped into 750 mL of 3.00 M HCl, and the reaction above proceeds as far as possible. If the ahoy contains 77.1% Al by mass, what mass of hydrogen gas would be produced?
An experiment calls for a 0.4500 M solution of aluminum carbonate. The storeroom has only 32.00 g of the solid. (a) What is the maximum volume of solution that can be prepared? (b) The reaction in the experiment requires 0.1450 mol of carbonate ion. How many milliliters of this solution are required to provide 0.1450 mol?
The US Environmental Protection Agency (EPA) places limits on the quantities of toxic substances that may be discharged into the sewer system. Limits have been established for a variety of substances, including hexavalent chromium, which is limited to 0.50 mg/L. If an industry is discharging hexavalent chromium as potassium dichromate (K2Cr2O7), what is the maximum permissible molarity of that substance?