I need the answer quickly comPonentweight fractionea650.150.10.n-C40.06n-C50.04Assuming real gas behavior, Calculate : -7 Gasdensity at 2000 Psi and 150°F27 SPecific Volum e at 2000 Psi and 150F31 Gas deviation factor47Gas formation Volume factor in scf I ft3

“Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

ComPonent weight fraction e.65 0.15 0.10. n-C4 0.06 0.04 Assuming real gas behavier, Calculate - 7 Gasdensity at 2000 Psi and 150°F 27 SPecific Volume at 2000 Psi and 150F 31 Gas deviation factor calculate:

ComPonent weight fraction e.65 0.15 0.10. n-C4 0.06 0.04 Assuming real gas behavier, Calculate - 7 Gasdensity at 2000 Psi and 150°F 27 SPecific Volume at 2000 Psi and 150F 31 Gas deviation factor calculate:

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

What is the Molecular weight of a certain volatile liquid which is placed in 225 g flask which has total capacity volume of 252.17 mL. After the liquid was heated to 96.7 oC the gass volatilized and the weight of the flask measure 227.33g. What is the could be the MW of the volatile sample?
A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is 86.1 kPa, and the temperature is 290 K. Assume octane behaves ideally, what is the total volume of this mixture. Show unit analysis and conversion on solution. Round off to four decimal places.
QU/A/ eylinder vessel of carbon monaxide (3.0 kg ) at -30°C with length 1.5 m and inner diameter 0.3 m , find pressure in bar used 1- the van der Waals equation, 2- ideal gas equation B/ Air enters convergent nozzle with a stagnation tempecature 310k and stagnation pressure 900kpa the exit area of nozzle is 300mm? determine mass flow rate if back pressure is 530 kpa
stack gas analysis: 83.08% N2, 7.5% CO2, 2.3% CO, 1.12% H2, 6% O2 with a saturation temperature of 54°C at 400°C and 760mmHg. a) %excess of air (1000 m^3 of air is supplied, produced 3100 m^3 of stack gas) b) chemical formula of the fuel burned c) analysis of the fuel mixture
Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to atmosphere. The following properties of benzene are given: 1) Boiling temperature is 353K at 1 atm. 2) MW of benzene is 78.108 kg/kmol. 3) hfg is 393 kJ/kg at 353K. 4) Density is 879 kg/m^3 5) Diffusivity rate (D) is 0.88x10^-5 m^2/s at 298K. Determine the following: A) The mass evaporation rate of benzene knowing that Psat is 0.145 atm and Yf at infinity is zero B) How long does it take to evaporate 0.5 cm^3 of benzene
An oil-fired power plant has a 2.5 m diameter chimney with an exit velocity of 15 m/s. The SO2 concentration in the flue gas is 1,250 ppmv. The total pressure is 1 atm, and the temperature of the gases is 150°C. Estimate the mass emissions of SO2 [kg/s].
The combustion gases from an industrial furnace using a hydrocarbon fuel and dry air enter the stack gas at normal barometric pressure and 3750F and have the following Orsat analysis: 12.2% CO2, 3.1% O2, 1.2% CO, and 83.5% N2. Determine the following: (a) The percent excess air (b) The volume of gases entering the stack, expressed as cubic feet per pound of carbon burnt in the furnace (c) The dew point of the stack gas (d) The atomic ratio of hydrogen to carbon in the fuel (e) The mol of stack gas per atom of carbon burnt
a cylinder was connected to an open ended U-tube (1 atm) containing some mercury, Hg (density=13.6gcm^-3), and the Hg was displaced 100mm towards the container. What is the pressure of the gas inside the container?
A gas mixture at 300K and 1 bar analyzing by volume 20% N2 and 80% CH4 is subjected to liquefaction at the rate of 1500 kg/hr. It is found that only 30% (weight) of the entering gas is liquefied and the concentration of N2 in the liquid is 60% by weight. The unliquefied gas leaves the unit at 273K and 1 bar. Determine (a) the volume of the unliquefied gas, m3/hr (b) the composition of the gas leaving expressed as volume %.
Table 1 below shows the data for the filtration of fruit juice to produce clarified fruit juice at 298.2 K. Table 1: Total volume of filtrate collected at certain time V * 103 (m3) t (s) 0.5 17.3 1.0 41.3 1.5 72.0 2.0 108.3 2.5 152.0 3.0 201.7 The filtration process was conducted at a constant pressure of 46.2 kN/m2. The area of the plate-and-frame the press was 0.0439 m2, and the pulp concentration was 23.47 kg solid/m3 filtrate. a) Convert the data in Table 1 into a graph. You can either use Excel or graph paper. Your graph should be self-explanatory. b) Using the graph in (a), estimate the specific cake resistance and the resistance of the filter medium to filtrate flow.
One mol of a gas is contained in a piston-cylinder device at 100 kPa. The piston rests at 10cm from the base of cylinder. Force is applied to the piston causing the pressure in the cylinder increases at 200kPA. What should be the restong position of the piston from the base of the cylinder? Assume the following temperature is held constant at 300K, throughout the experiment, gas is ideal, piston has negligble mass, is frictionless and airtight. a.5cm b.8cm c.20cm d.1cm How many grams of water vapor can be stored in a 71.9-mL rigid vessel held at a pressure of 10.4 atm and temperature of 465C? a. 0.421 b. 0.222 c. 0.129 d. 22.4 e. 0.183
At 90 °F and 30.0 psi absolute, the specific weight of a certain gas was 0.0877 lb/ft³. Determine the gas constant.