eylinder vessel of carbon monaxide (3.0 kg ) at -30°C with length 1.5 m and inner diameter 0.3 m , find pressure in bar used 1- the van der Waals equation, 2- ideal gas equation B/ Air enters convergent nozzle with a stagnation tempecature 310k and stagnation pressure 900kpa the exit area of nozzle is 300mm? determine mass flow rate if back pressure is 530 kpa

Q: 10. Gaseous propane at 20 °C is burned with 70% excess air that enters the combustion chamber at a…

A: Given data: Air = 70 %  Rate= 1.3 kg/min Temperature = 9° C Pressure = 1 atm   Combustion of propane…

Q: A cylinder 1.00 m tall with inside diameter 0.120 m is used to hold propane gas (molar mass 44.1…

A:

Q: A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is…

A:

Q: In a U tube manometer, one end is open to the atmosphere, the other end attached to a pressurized…

A: a. Given, Difference in pressure, ∆P = 40kPa = 40000 Pa  Height difference, ∆h = h2 - h1 = 60-30 =…

Q: Absorption of sulphur dioxide is carried out in a packed tower. Gas containing 14.8% sulphur dioxide…

A:

Q: 4. Methylamine, stored in a 2000-gallon tank is to be transferred in drums. Each drum is to be…

A:

Q: Stripping Tower. A liquid mixture containing 10 mo! % n-heptane and 90 mol % n-octane is fed at its…

A:

Q: #3 acid via the oxidation of ammonia is: The first step in the reaction sequence for the production…

A: Balanced chemical equation, 4 NH3 +5 O2 ⇔4 NO + 6H2O

Q: Calculate the total mass of precipitable water (the answer in tons) in the saturated air column 9.5…

A:

Q: A solution containing 100 lbm KNO 3/100 lbm H 2O at 80°C is fed to a cooling crystallizer operated…

A:

Q: 4. The following data are given for a family single stage biogas digester shown in Figure Q 4…

A: (i)Given: temperature for fermentation =30 degree  Dry matter (cow dung) = 4kg volume of methane =…

Q: 4. A flash chamber operating at 50 °C and 200 kPa is separating 1,000 kg moles/hr of a feed that is…

A: Solution

Q: L-lysine is produced by Corynebacterium glutamicum in a bioreactor using glucose as the carbon…

A: The bioreactor is defined as the cylindrical vessel or instrument in which biological processes are…

Q: A liquid mixture containing 40.0% benzene (B) and 60% toluene (T) by mass to the distillation…

A: Given Liquid feed contains 60% of toluence and 40% benzene by mass. Feed volumetric flow = 2500L /…

Q: A mixture of methane and air is capable of being ignited only if the mole percent of methane is…

A: Given: Mole percentage of methane= between 5% and 15% Number of mole of methane= 9.0 mole Flowing…

Q: A liquid stream flowing at 100 g/min contains 0.3 mole fraction benzene (Mw=78) and the balance 0.7…

A: Given data  mass flow rate of stream = 100 g/min mole fraction of benzene in stream  Xb = 0.3 mole…

Q: Q4-A vertical cylinder tank with diameter of 12m and depth of 4m is filled to the top with water at…

A: Given thatDiameter of vertical cylinder=12 mDepth of vertical cylinder=4mInitial…

Q: The properties of a system, during a reversible constant pressure non-flow process at P-1.6 bar,…

A: In thermodynamics, the amount of heat transfer during a particular work-done is given by: q=mC∆T…

Q: EXAmple 2: tookultha of amrsture Contalning l0,20,30 and Homl of Propanezn-butanesn-Pentanesand…

A:

Q: 2. True/False (If your T/F look similar, write the full word! 1. Using generalized correlations for…

A:

Q: A wet gas is produced through a two-stage separator system. Separator conditions are 580 psia and…

A:

Q: 23 ft^3 of air was drawn from a ventilation duct and measured by means of a dry gas meter. the…

A: As per the combined gas equation, P1V1T1=P2V2T2

Q: J kg/hr of a mixture of benzene (B), Toluene (T) and Water (W) was fed to a distillation column as…

A: Distillation process   Feed flowrate F = 1000kg/h   Top flowrate V   Bottom flowrate P   Apply…

Q: A mixture of methane and air is capable of being ignited only if the mole percent of methane is…

A: Given: air flow rate = 1300 kg/hr mole percent of methane = 6.00 mole % moles of methane in mixture…

Q: Q2) Sulfur dioxide (A) diffuses through a stagnant layer of air (B) of 2 cm thickness at 45°C and…

A: Hi  аnd  thаnks  fоr  the  questiоn.  Sinсe  yоu  hаve  роsted  а  questiоn  with  multiрle…

Q: 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to…

A:

Q: (a) Water in vadose zone contains chlorobenzene of concentration 40 mg/L. What is the equilibrium…

A: “Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: Your 155 Ib client needs to work at 55% of their VO2max. You determine their VO2max to be 33.78…

A:

Q: 6- Helium is to be compressed from 110 kPa and 300 K to 520 kPa and 440K. A heat loss of 16 kJ/kg…

A: Given: Heat loss = 16 kJ/kg Mass flow rate = 2.5 kg/sec  or  150 kg/min P1=110 kPaP2=520 kPaT1=300…

Q: J kg/hr of a mixture of benzene (B), Toluene (T) and Water (W) was fed to a distillation column as…

A: Distillation process   Feed flowrate F = 1000kg/h   Top flowrate V   Bottom flowrate P   Apply…

Q: A gas mixture analyzing 6% pentane, 10% butane, 15% propane, 10% ethane, 55% methane and 4% nitrogen…

A:

Q: a.) A 12 kmol liquid mixture with XSi = 0.8, xca = 0.2 at 1500oC was cooled to 1030oC. Determine the…

A: A question based on phase diagram, which is to be accomplished.

Q: A gas consist of 70% propane and 30% butane by volume. Find the stoichiometric air-to-fuel ratio.…

A: The stoichiometric air-to-fuel ratio will be C --> 23:1

Q: Two tanks are connected by a series of pipes as shown below. Tank 1 initially contains 150 grams of…

A:

Q: A gas mixture analyzing 6% pentane, 10% butane, 15% propane, 10% ethane, 55% methane and 4% nitrogen…

A:

Q: Stack gas analysis: 83.08% N2, 7.5% CO2, 2.3% CO, 1.12% H2, 6% O2  with a saturation temperature of…

A:

Q: Chemistry What is the mole fraction of the ethanol in the overhead stream, OH-1, of the single unit…

A: Given -> Mole of methanol = n1 = 0.40 mole Mole of ethanol =n2 = 0.60 mole

Q: 3. Methane enters the furnace at a rate of 100 mol/min and is burned with air in a furnace. Dry…

A:

Q: Solve the problem systematically. All assumptions and references(s) for the values obtained should…

A: Solution -

Q: Determine the specific volume of nitrogen gas at 10 MPa and 150 K based on e ideal-gas equation and…

A: solution- Pressure of nitrogen gas = 10 MPa T = 150 K (a) The ideal gas equation -  V= RTP = (0.2968…

Q: 6. A 30-m vertical column of fluid (p = 1878 kg/m³) is located where g = 9.65 m/s². Find the…

A:

Q: Q1/ Determine the heating area required for the production of 1000 lb/hr of 50% from 10% NaOH feed…

A: given data  production rate F=10000 lb / hr = 4535.92 kg/hr concentration of feed xf=10% NaOH…

Q: (a), estimate the specific cake resistance and the resistance of the filter medium to filtrate flow.

A: Solution Filtration, the method within which solid particles in a very liquid or gassy fluid square…

Q: 4. A feed stream containing C8 and C10 hydrocarbons is split into 3 product streams: an overhead…

A: The flow diagram given is,

Q: In Deacon process, gas phase reaction was carried out in isothermal batch reactor to form chlorine…

A:

Q: 16 liters. The drug is excreted (removed) through the kidneys at rate ke , proportional to the…

A: Solution -

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.