Consider atmospheric air at 25?C and a velocity of 25 m/s flowing over both surfaces of a 1-m-long flat plate that is maintained at 125?C. Determine the rate of heat transfer per unit width from the plate for values of the critical Reynolds number corresponding to 5×105

Consider atmospheric air at 25?C and a velocity of 25 m/s flowing over both surfaces of a 1-m-long flat plate that is maintained at 125?C. Determine the rate of heat transfer per unit width from the plate for values of the critical Reynolds number corresponding to 5×105

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.7P: 5.7 The average Reynolds number for air passing in turbulent flow over a 2-m-long, flat plate is ....

See similar textbooks

Related questions

Q: 1- Air at 288.8 k and 101.32 kPa with a free stream velocity of 3.05 m/s is flowing parallel to a…

A: Given:

Q: Air at 20oC and 1 atm flows over a flat plate at 35 m/s. The plate is 75 cm long and 100 cm depth…

A: Velocity boundary layer thickness The thickness of the velocity boundary layer is normally defined…

Q: A coated sheet is being dried with hot air blowing in cross flow on the sheet surface. The surface…

A: Given data as per question The surface temperature of sheet = 90°C Air velocity = 0.3 m/s Air…

Q: In the laminar flow of air (Pr = 0.7) over a heated plate. if ö and S denote, respectively, the…

Q: For laminar forced convection over a flat plate, if the free stream velocity increases by a factor…

Q: Q5) Air at -10°C flows over a flat surface at 10°C with a free stream velocity of 80 m/s. The length…

A: given data air temperature = -10°C air speed = 80 m/s surface temperature = 10 °C length of plate =…

Q: Engine oil at 80°C flows over a flat surface at 40°C for cooling purpose, the flow velocity being 2…

A: Given Velocity, v = 2 m/s Distance, x = 0.4 m Properties at 80 + 40 /2 = 60oC Kinematic…

Q: A metallic airfoil of elliptical cross section has a mass of 50 kg, surface area of 12 m2, and a…

Q: Hot methane exhaust gas at 1 atm is being cooled by flat plates. The gas at 150°C flows parallel…

Q: The upper surface of a metal plate is being cooled with parallel air flow while its lower surface is…

A: The properties of air at 15 degrees Celsius are: The Reynolds number of the flow is

Q: 10 Air at 10 atm and 25°C flows with free stream velocity of 6 m/s over a flat plate at 75°C.…

A: Given:T∞=25οCTplate=75οCReynold's number,Re=U∞xνwhere,U∞=6msv=Kinematic viscosity of water at…

Q: Air at 30 oC flowing over a flat plate 0.5 m long and 0.6 m wide, is to be maintained at 70 oC .…

A: This question is solved with the help of the convection heat transfer coefficient equation. As shown…

Q: It has a density of 5900 kg/m3 and a specific heat of 590J/kg.°C with a diameter of 15 cm. A…

Q: What is the ratio of total convective heat transfer rate to laminar convective heat transfer rate…

A: Convection improves heat transport over a fluid layer as compared to conduction through the same…

Q: For external forced convection with an isothermal surface, what is the Nu# correlation equation for…

A: Nusselt number (Nu) signifies the ratio of conductive resistance to the convective resistance…

Q: A 15 mm 3 15 mm silicon chip is mounted such that the edges are flush in a substrate. The chip…

A: Write the properties of air at 50°C. Write the expression of the characteristic length of the…

Q: Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220°C flow is…

Q: Air at 27 ⁰C and 1 atm flows over a flat plate at a velocity of 3m/s, assuming the plate is heated…

A: Given details in question: T1=27°cT2=60°cV=3m/secl=25 cm Reynolds number: Re=Vlν Average Nusselt…

Q: Example 2: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air…

Q: Airstream at 1 atm flows, with a velocity of 15 m/s, in parallel over a 3-m-long flat plate where…

A: Write the properties of air at 20°C. Write the expression of the characteristic length of the…

Q: Consider atmospheric air at 25°C and a velocity of 25 m/s flowing over both surfaces of a 1-m- flat…

Q: Engine oil at 83°C flows over the upper surface of a 5-m-long flat plate whose temperature is 18°C…

Q: A 0.4-W cylindrical electronic component with diameter 0.3 cm and length 1.8 cm and mounted on a…

A: Given data Diameter of component = 0.3cm = 0.003m Length of the component = 1.8 cm = 0.018m Velocity…

Q: Consider the following fluids at a film temperature of 300 K in parallel flow over a flat plate with…

A: Given: The temperature of fluid, T = 300 K The speed of fluid, v = 1 m/s The distance from leading…

Q: Water at 45.0oC flows over a large plate at a velocity of 30.0 cm/s. The plate is 1.0 m long (in the…

Q: Air at 20°C flows over a flat plate having a uniform heat flux of 800 W/m². The flow velocity is…

A: given data temperature of air = 20°C speed or air = 4 m/s heat flux = 800w/m^2 length of plate =…

Q: In the effort to increase the removal of heat from a hot surface at 120°C, a cylindrical pin fin (kf…

A: The properties of air at a temperature of 70 oC are given as, The characteristic length of the…

Q: A metallic airfoil of elliptical cross section has a mass of 50 kg, surface area of 12 m2, and a…

Q: Atmospheric air is in parallel flow (1 10 m/s, T 15°C) over a flat heater surface that is to be…

Q: Air with a pressure of 1 atm and a temperature of 285 K flows in a duct rectangular shape with a…

A: Given, Pressure, P=1atmTemperature, T=285KMass flow rate, m=0.1kg/sDuct size=75mm×150mmLength of…

Q: A 15 cm x 15 cm circuit board dissipating 15 W of power uniformly is cooled by air, which approaches…

A: The properties of air at 300 K are: (a) The value of Nusselt number at the leading is The film…

Q: Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220oC flows in…

Q: A1.8-m-diameter spherical tank of negligible thickness contains iced water at 0°C. Air at 25°C flows…

Q: 1) Engine oil at 80°C flows over a 6-m-long flat plate whose temperature is 30°C with a velocity of…

Q: Consider the following fluids at a film temperature of 300 K in parallel flow over a flat plate with…

A: Given dataFilm temperature = 300 KFlow velocity = u = 1 m/sWe have to find the velocity and thermal…

Q: Consider laminar flow over a flat plate. How does the local friction coefficient change with…

A: In the boundary layer flow of a fluid over any surface, the local friction coefficient represents a…

Q: Air (1 atm) entered into a 5-mm-diameter circular tube at an average velocity of 5 m/s. The tube…

A: Given data, The length of the tube, L = 10 cm The diameter of the tube, d = 5 mm The velocity of…

Q: Consider steady, laminar, two-dimensional flow over a hot plate. Does the convective heat transfer…

A: Given: Consider steady, laminar, two-dimensional flow over a hot plate The wall shear stress is…

Q: Water at 25°C and 1 atm is flowing over a long flat plate with a velocity of 8 m/s. Determine the…

A: Given data T=25°cV=8 m/sRecr=5×105

Q: Consider the following fluids at a film temperature of 300 K in parallel flow over a flat plate with…

A: Given data: Film Temperature = Tf = 300 K Fluid velocity = u = 1 m/s Fluids are : Air, Water, Engine…

Q: Consider the following fluids at a film temperature of 300 K in parallel flow over a flat plate with…

A: Given data: Film Temperature = Tf = 300 K Velocity of flow = u = 1 m/s x = distance from leading…

Q: Consider a flow over a surface with the velocity and temperature profiles given as u(v) = C1 (y + y²…

A: Given Data

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this…

A: (a) The average temperature is written as, The properties of air at this temperature are given as,…

Q: Air stream at 1 atm flows with a velocity of 2 m/s, in parallel over a 3 m long square flat plate,…

A: Given: The air stream pressure, P = 1 atm The velocity of air stream, v = 2 m/s The length of plate,…

Q: QUESTION 3 a) During a cold winter day, wind at 55 km/h is blowing parallel to a 4-m-high and…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: Q2/Engine oil at 80°C flows over a 6-m-long flat plate whose temperature is 30°C with a velocity of…

Q: 6- Air at a pressure of 200 kPa and free-stream temperature of 27 C flows over a square flat plate…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the rate of heat loss from the wall of a building resulting from a 16 km/h wind blowing parallel to its surface. The wall is 24 m long and 6 m high, its surface temperature is 27C, and the temperature of the ambient air is 4C.
An electrical transmission line of 1.2-cm diameter carries a current of 200 amps and has a resistance of 310-4 ohm per meter of length. If the air around this line is at v, determine the surface temperature on a windy day, assuming a wind blows across the line at 33 km/h.
Air at 60°F flows over a 10-ft-long flat plate at 7 ft/s. Determine the local friction and heat transfer coefficients at intervals of 1 ft, and plot the results against the distance from the leading edge.
Please help with this questionHot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. Thegas at 220°C flow is parallel over the upper and lower surfaces of a 3-m-longflat plate at a velocity of 3 m/s. If the flat plate surface temperature ismaintained at 80°C.Determine the local convection heat transfer coefficient at 1 m fromthe leading edge and calculate the average convection heat transfer coefficient over theentire plate.
The airflow at 1 atm has a free stream velocity and temperature of 5 cm/s and 25°C, respectively. Determine the heat flux on the plate surface and the convection heat transfer coefficient of the airflow.
A 0.4-W cylindrical electronic component with diameter 0.3 cm and length 1.8 cm and mounted on a circuit board is cooled by air flowing across it at a velocity of 240 m/min. If the air temperature is 35°C, determine the surface temperature of the component. For air properties evaluations assume a film temperature of 50°C. Is this a good assumption?
Air (1 atm) entered into a 5-mm-diameter circular tube at an average velocity of 5 m/s. The tube wall is maintained at a constant surface temperature. Determine the convection heat transfer coefficient for (a) a 10-cm-long tube and (b) a 50-cm-long tube. Evaluate the air properties at 50°C.
Calculate the heat transfer from a 60 cm x 60 cm plate on which air flows at 40 C and. The plate temperature is 100 C while the air speed is 5 m/s.
Liquid mercury at 250°C is flowing with a velocity of 0.3 m/s in parallel over a 0.1-m-long flat plate where there is an unheated starting length of 5 cm. The heated section of the flat plate is maintained at a constant temperature of 50°C. Determine (a) the local convection heat transfer coefficient at the trailing edge, (b) the average convection heat transfer coefficient for the heated section, and (c) the rate of heat transfer per unit width for the heated section.
Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220°C flows in parallel over the upper and lower surfaces of a 1.5-m-long flat plate at a velocity of 3 m/s. If the flat plate surface temperature is maintained at 80°C, determine (a) the local convection heat transfer coefficient at 1 m from the leading edge, (b) the average convection heat transfer coefficient over the entire plate, and (c) the total heat flux transfer to the plate.
Airstream at 1 atm flows, with a velocity of 15 m/s, in parallel over a 3-m-long flat plate where there is an unheated starting length of 1 m. The airstream has a temperature of 20°C and the heated section of the flat plate is maintained at a constant temperature of 80°C. Determine (a) the local convection heat transfer coefficient at the trailing edge and (b) the average convection heat transfer coefficient for the heated section.
A thin, flat plate that is 0.2 m × 0.2 m on a side is oriented parallel to anatmospheric airstream having a velocity of 40 m/s. The air is at a temperatureof T∞ = 20°C, while the plate is maintained at Ts = 120°C. The air flows overthe top and bottom surfaces of the plate, and measurement of the drag forcereveals a value of 0.075 N. What is the rate of heat transfer from both sides ofthe plate to the air?