Consider the following list of indicators. Indicator pK, Methyl red Chlorophenol red Ethyl orange m-nitrophenol Bromphenol blue 5.00 6.25 4.34 8.28 3.20 Which one of these indicators would be best to use in a titration of a 0.100 M solution of acetic acid (K, - 1.8 x 105) witha 0.100 M solution of strong base. Bromphenol blue Methyl red m-nitrophenol Chlorophenol red Ethyl orange

Consider the following list of indicators. Indicator pK, Methyl red Chlorophenol red Ethyl orange m-nitrophenol Bromphenol blue 5.00 6.25 4.34 8.28 3.20 Which one of these indicators would be best to use in a titration of a 0.100 M solution of acetic acid (K, - 1.8 x 105) witha 0.100 M solution of strong base. Bromphenol blue Methyl red m-nitrophenol Chlorophenol red Ethyl orange

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter16: Reactions Between Acids And Bases

Section: Chapter Questions

Problem 16.54QE

See similar textbooks

Similar questions

Which of the following statements is advantageous? A). The main differences between potentiometric and conductometric titrations are that potentiometric titrations exemplify the analyte sample-by-sample while conductometric titrations show the potential of the analyte B). A conductivity is analyl from the people of the charge. C.) Conductivity increases rapidly as close as equivalence, as a strong acid and a strong base will decrease D). The conductor remains constant according to the viscosity of the pixel, the decomposer and its size, which consists of design modelling.
A suitable target for the titration is 30.0 cm3 of 0.025 moldm-3 Br2(aq) Justify why a much smaller target titre would not be appropriate Calculate the amount in moles of bromine in the target titer Justification? calculate a suitable massof alive oil to transfer to the volumetric flask using your answer to of above question and the structure of Y Assume that the olive oil contains 85/- of Y by mass (If you were unable to calculate the amount of bromine in the target titer,you should assume it is 6.25×10^-8 mol .this in not the correct amount)
b) In the development of a method for the determination of formic acid by neutralization volumetry, the pH was calculated as a function of the addition of NaOH for the titration of 25.00 mL of 0.1280 mol/L formic acid with NaOH standardized with concentration of 0.0670 mol/L. With reference to this titration curve, determine the pH of the solution after the addition of 5.00 mL of titrant and at the equivalence point. Data: Ka=1.70x10-4. Present the results with two places after the comma and show your calculations. c) Based on the table below, indicate which indicators could be used to determine the end point of this titration.
500 mL of 0.1019 M NaOH solution is preparedIt is immediately forgotten with the cap open and absorbs 0, 652 g of CO2. Calculate the relative carbonate error made in acetic acid titration with this solution with phenol-phthalate indicator.
It is desired to determine the concentration of chlorides in a powdered milk following the method of Volhard, for such case 1.5g of milk is weighed, it is heated in a muffle until obtaining ashes, which are treated with acid water with some drops of HNO3, the solution is filtered and the obtained filtrate is collected in an Erlenmeyer and 20 mL of AgNO3 0 is added. 1M excess silver is titrated with 0.05M potassium thiocyanate, if 8 mL of KSCN has been used up at the time of the indicator turn. Calculate the % of chloride in the milk powder.
Calculate the volume in milliliters of 0.368 M KOH necessary to titrate 0.0209 moles of acetic acid (HOAc, HC2H3O2) to a phenolphthalein end-point. Report the answer with a precision of two decimal places.
A 0.4071-g sample of CaCO3 (MM: 100.09 g/mole) is transferred to a 500-mL volumetric flask, dissolved using a minimum of 6 M HCl, and diluted to volume. A 50.00-mL aliqout of this solution was mixed with 5 mL of a pH 10 NH3-NH4Cl buffer that contains a small amount of Mg2+--EDTA to adjust the pH to 10. After adding calmagite as an indicator, the solution is titrated with the EDTA, requiring 42.63 mL to reach the end point. Report the molar concentration of EDTA in the titrant. 9.543 x 10-3 M 5.748 x 10-3 M 3.266 x 10-4 M 1.018 x 10-4 M
10. 50 cm3 of 0.05 M weak acid solution is titrated with 0.1 M NaOH solution. The measured pH valuesare 7.345 and 7.497 at the consumptions of 6.0 and 6.1 cm3, respectively. What value of the buffer capacity can be calculated in the solution at pH = 7.421?11. Based on the data given in question 10, what is the total concentration of the anion of the weak acid atthe given point?
How would you use an experimentally determined Ksp value to calculate that Ag2CrO4 should precipitate when 5ml of 0.0040 M AgNO3 are added to 5ml of 0.0024 M K2CrO4. You can come up with your own experimentally Ksp value. I just want to see steps in solving
A 25.00 ml of Ni2+ solution was diluted in HCl and treated with 25.00 ml of 0.05283 MNa2EDTA. The solution was neutralized with NaOH followed by addition of acetate buffer untilthe pH 5.5. The solution turns yellow after addition of few drops of xylenol orange indicator.Back titration using standard 0.022 MZn2+ at pH 5.5 requires 17.61 ml until end point, onwhich the solution will turn red. Calculate for the molarity of the unknown.
The Ka values for nitrous acid (HNO2) and hypochlorous (HClO) acid are 4.5 x10-4and 3.0 x10-8, respectively. Which one would be more suitable for use in asolution buffered at pH = 7.0? What other substances would be needed to makethe buffer?
which indicator is best used for the titration of aqueous ammonia and benzoic acid?