Answered: Considering table salt (inorganic) and…

Considering table salt (inorganic) and table sugar (organic), how do they differ in terms of melting point? Briefly justify your answer.

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter10: Liquids And Solids

Section: Chapter Questions

Problem 22E: The test tubes shown here contain equal amounts of the specified motor oils. Identical metal spheres...

See similar textbooks

Related questions

Q: Is it possible to freeze ammonia? What conditions would be necessary for frozen ammonia?

A: The phase diagram of the ammonia is given as,

Q: What state of matter is virtually incompressible and retains its own shape and volume?

A: Answer : Liquid A liquid is a nearly incompressible fluid that conforms to the shape of its…

Q: When measuring water or water-based liquids in a graduated cylinder or other liquid measuring…

A: This due to the surface tension, cohesive force and adhesive force. Surface tension is the tendency…

Q: Question attached

A: Introduction- Both NaCl and MgCl2 are bad conductors or they cannot conduct electricity in their…

Q: Mixtures of liquids whose boiling points are similar (separated by less than 70 °C) require…

A: Given that : We have to identify the distillation method used to separate the mixture of liquids…

Q: When a mixture of soluble liquids is heated all liquids are evaporated. The liquid with the…

A: Our surroundings are full of materials which are mixtures of two or more components, these…

Q: 9. Write a Claim/Evidence/Reasoning response to answer the question: What state of matter would you…

A: There are mainly three states of matter, such as solid , liquid and gases .

Q: What is the Simpliest form of substance

A: What is the Simpliest form of substance

Q: Liquid methane appears to be the only other substance found in quantity in a liquid state in the…

A: Given information, If our ocean were of liquid methane rather than liquid water

Q: Identify the possible intermolecular forces existing in the structures presented below and justify.…

A: A question based on intermolecular forces, which is to be accomplished.

Q: 22. Distillation is a process which consists in separating, by heat, the various elements…

A: The molecules given are,

Q: Define the term critical point?

A: The term critical point has to be defined below.

Q: Solubility of Liquids in Liquids Pour 5 mL of rubbing alcohol into an equal volume of water and…

A: Given liquids: Water: H2O Alcohol: R-OH In this activity, 1. 5 mL of alcohol is added to 5 mL…

Q: Some hypothetical metal has simple cubic crystal structure. If its atomic weight is 77.15 g/mol and…

A: A crystal lattice comprises of several init cells. The number of atoms in simple cubic unit cell is…

Q: What is the property of a material that makes it transparent? Why does mineral such as emerald…

Q: Briefly explain the difference between particle and crystal size

A: One of the four basic states of matter is solid. A solid's molecules are densely packed together and…

Q: Write the ions present in solution of Sn(NO2)4. Express your answers as chemical formulas separated…

A: Answer - According to the question - Given - the ions present in solution of Sn(NO2)4. Sn(NO2)4…

Q: is the study of fundamental principles of nanostructures between bulk and atomic properties.

A: Nanoscience: The study of fundamental principles of nanostructures between bulk and atomic…

Q: What is the surface tension of water (i.e. the air--water interface) at a temperature of 25°C? (No,…

A: We need to give the value of surface tension of water (air-water interface) at a temp of 250C, to…

Q: The test tubes shown here contain equal amounts of the specified motor oils. Identical metal spheres…

A: The test tubes are containing equal amounts of the specified motor oils filled up to equal volume…

Q: Explain the quantum nanostructures with schematic diagram?

A: CLASSIFICATION OF NANOSTRUCTURESQuantum structures are mainly classified according to the number of…

Q: A process in which liquid-liquid mixture can be separated into liquid using their difference in…

Q: Explain how the density of water varies from 0⁰C to 10⁰C and explain how this temperature density…

A: Water exhibits an abnormal property whereby it expands instead of contracting when the temperature…

Q: the mean type of alumina phase uesd as biomaterials is O Alpha phase O Beta phase O Camma phase O…

A: Moumita is very much useful in biomedical purposes .

Q: In no more than 5 sentences, give the relevance of determining the melting point of a substance.

A: Melting point of a substance can be defined as the temperature at which a solid start converting…

Q: Who among the substances sugar, salt, and peppers can appears to be made of crystal?

A: The constituents particles of the solid material that are arranged in highly ordered forms a crystal…

Q: A student filled an ice tray nearly full with water. When the tray was removed from the freezer, the…

A: Mass,volume,area and density are measurable quantities that describe the state of the…

Q: Give a short description of the process shown in the figure below and identify what type of…

A: Sugar dissolves in water is a physical change because in this change no new substance is formed and…

Q: Propose how the components of a mixture containing benzene, toluene, and water can be separated.…

Q: Calculate the quantity of heat (in calories) needed to change 50 g of 0 deg C ice into steam at 100…

A: It includes the scenario:- 50g ice at 0°C ----> 50 g water at 0°C ----> 50 g water at 100°C…

Q: Which answer best describes the redistribution of matter or energy when melting takes place? more…

A: The question can be answered by considering one of the important thermodynamic concept such as…

Q: States of matter = solids, liquids, and gases. But another state of matter - the plasma- exists.…

A: Five states of matter have been discovered. These are solid, liquid, gas, plasma and Bose-Einstein…

Q: Which of the following statements describe phosphorescence?

A: We know that Phosphorescence is a non- radiative transition from triplet state to ground state (T1…

Q: The plasma state consists of positively and negatively charged particles. Plasma behaves most like…

A: A matter or a substance exists in one of the three common states that are solids, liquids and gases.…

Q: The graduated cylinders shown here contain equal amounts of the different plant oils. Identical…

A: Viscosity:- Viscosity of fluid is measured of its resistance to flow. Formula F = μA .u/y Where F…

Q: All molecules attract each other to some extent, and the attraction decreases as the distance…

A: All molecules pull each other to some degree, and the affinity reduces as the distance between the…

Q: placed in separate containers labeled Sample A and Sample B. Both containers were left open until…

A: Solution: We know homogeneous solution is a mixture of two or more substances. As homogeneous…

Q: After performing an experiment to know if the ice cubes will sink or float in two separate jars…

A: An experiment was performed to know wheather the ice cubes will sink or float in two separate jars…

Q: You have two objects that are made of materials that have the same chemical composition, but…

A: As each and every material is made up of small particles. The internal ordered arrangement of these…

Q: 4. A young chemist has synthesized what he believed to be acetaminophen. He measured the melting…

A: Acetaminophen should have melting point exactly between the range of 169-170.5 oC as per literature…

Q: Based from the given data about the penetration coefficient of beets in different concentration of…

A: Penetration coefficient depends on the tendency to penetrate or pass through a particular components…

Q: Given the same amount of water and ethanol, which do you think will boil first? Justify your answer.

Q: Are the melting temperature and freezing temperature the same for a pure substance? Why is that?

A: Melting point is the temperature at which solid substance start to convert into liquid. Example:…

Q: Write the ions present in solution of Sn(NO2)4. Express your answers as chemical formulas separated…

A: Write the ions present in solution of Sn(NO2)4. Write the ions present in solution of NaHCO3. Write…

Q: Express your answer as a balanced chemical equation. Identify all of the phases in your answer.

Q: Capillary action is the process of water moving up plants, against gravity. Two different properties…

Q: How much water will a 115.8 kg block of gold displace? use the accepted value for the density of…

A: Given that, Amount of Gold block MAu = 115.8 Kg Density of Gold dAu = 19.3 g/mL at 25°C Density…

Question

Considering table salt (inorganic) and table sugar (organic), how do they differ in terms of melting point? Briefly justify your answer.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Basic

VIEW

Answer

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Based from the given data about the penetration coefficient of beets in different concentration of alcohol, what can we conclude about it.
say the interaction in the box between two substance
A representation of liquid water is shown below. Which of the three representations that follow best describes the water after it has boiled into steam?
The test tubes shown here contain equal amounts of the specified motor oils. Identical metal spheres were dropped at the same time into each of the tubes, and a brief moment later, the spheres had fallen to the heights indicated in the illustration. Rank the motor oils in order of increasing viscosity, and explain your reasoning:
After performing an experiment to know if the ice cubes will sink or float in two separate jars containing 150ml of cooking oil and 150ml of water, why did the ice behave that way in water? Why did it float in the water as compared to the cooking oil?
How do solids and liquids behave differently? how does the equilibrium exist between the phases of a substance? Explain why water is in liquid form and when in room temperature despite of the fact that is composed of hydrogen and oxygen which are both gases. Explain the difference between phases underground by carbon dioxide as compound water.
The graduated cylinders shown here contain equal amounts of the different plant oils. Identical metal spheres were dropped at the same time into each of the tubes, and a brief moment later, the spheres had fallen to the heights indicated in the illustration. Rank the plant oils in order of increasing viscosity (lowest to highest), and explain your reasoning.
Why do meltiing, freezing and boiling point varies and depends on a kind of matter? Not less than 6 sentences.
Given the same amount of water and ethanol, which do you think will boil first? Justify your answer.
Briefly explain the difference between particle and crystal size
Miscible liquids from homogeneous mixture when added together. is Toluene miscible with water?, or With ethyl alcohol?
Which of the following mixtures can be best separated by filtration? a. ethanol in waterb. mixture of solid naphthalene and waterc. mixture of liquid hexane and waterd. iodine in hexane mixtureWhich of the following mixtures can be best separated by evaporation?a. ethanol in waterb. mixture of solid naphthalene and waterc. mixture of liquid hexane and waterd. iodine in hexane mixture