D.1-. Which of the following names is commonly used for armored cable on commercial and industrial job sites? A. Romex B. BX C. ECG D. MC D.2. Which of the following is the most common type of conductor termination used in commercial and industrial wiring applications? A. A pressure connection B. A wire nut C. A wire splice D. A crimped connection D.3. Which of the following terms correctly describes a ventilated metal enclosure that supports power distribution conductors of up to 8000 A and 69 kV, and that allows for proper phase arrangement of the conductors? A. A trolley bus B. A channel raceway C. A cablebus

Q: In terminating the coaxial cable, if the present procedure is to cut part of the braided shield and…

A: In this question we need to find what is the next procedure is to

Q: Hi. What kind of connector used by the Plenum cable? What is the example of Plenum cable. Thanks…

A:

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic…

A:

Q: 6.A. How many grounded neutral conductors are in a 208Y/120 volt, 3-phase, 4-wire system? A. Three…

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: Service-lateral conductors are required to be insulated except for the grounded neutral conductor…

A: According to NEC 230.30 (A), underground service conductors are insulated for the applied voltage.

Q: The figure below shows a ring distributor with interconnector BD. The supply is given at point A.…

A:

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: In terminating the coaxial cable, if the present procedure is to cut part of the braided shield and…

A: Procedure for terminating coaxial cable Step 1: The tools you will need: Compression tool Cable…

Q: 11. Which of the following statements about the use of structural steel as an equipment grounding…

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: Airframe Electrical System Question: In general, what factors areconsidered when selecting the…

A: While manufacturing, the sizes of the wire are selected according to a known standard called as…

Q: 4. What is the effect of laid cables in proximity to each other?

A: The effect of laid cables in proximity also called as proximity effect which means the interaction…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: The solution can be achieved as follows.

Q: What is the mean of wiring

A: Wiring is the term used for the supply system design, connection, and protection schemes employed…

Q: 1. Identify and describe the step-by-step process used to pull cable and also describe the…

A: The step-by-step process used to pull cable STEP 1: Check the Cable Width and Pipeline to make sure…

Q: What should be the CPC cable size for a line conductor of sizes up to 16mm² Same size 35 mm2 Half…

A: CPC cable size for the given line conductor of different sizes is given in accordance with table…

Q: Where nonmetallic-sheathed cable is run at angles with joists in unfinished basements, it shall be…

A: According to article 334 nonmetallic -sheathed cable . Where nonmetallic-sheathed cable is run at…

Q: 14. If the center conductor of a coaxial cable is made to have smaller diameter, all other things…

A:

Q: What is RG rating of coaxial cable? Give detailed answer please

A:

Q: Airframe Electrical System  Question: Name two acceptable conductor types used in aircraft wiring?…

A: All aircrafts require lightweight body parts. So, the wiring material required in aircraft must be…

Q: Duct banks for medium- and high-voltage feeders are identified with _______ on top before final…

A: In this case, the identification of the duct banks with medium and high voltage feeders needs to be…

Q: Give detailed information about the Fiber optics and Ethernet cables. Compare these two types of…

A:

Q: 14.a. Section 250.94 requires that an IBT be accessible for inspection and termination and have the…

A: 14.a. IBT stands for Intersystem Bonding Terminal. According to NEC Section 250.94 (B) An IBT be…

Q: What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's…

A: Given, Three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter.

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: Which materials is not used as in the Insulation Layer of the Underground Cable? O A. PVC O B. XLPE…

A: Choose the correct option Which material is not used as in the insulation layer of the underground…

Q: What is the super tension cable and application,rating

A: In this question we are discussing about super tension cable and application,rating. This is…

Q: 3.a. An equipotential bonding grid at a farm location is to be connected to the ground terminal bus…

A: Ans. 3(a) Equipotential Bonding Grid is a Conductive Pool Shell. An equipotential bonding grid at a…

Q: What do you call device/tool used for measuring the galvanization or coating of grounding and tower…

A: These instruments square measure referred to as coating thickness gauge or gaussmeter. they're of…

Q: find the following parameters for the arcust below

A:

Q: 4.Justify: why electrical isolation and theft prevention are the advantages of non-conductive cable?

A: According to the given question, it is required to determine the reason why non-conductive cables…

Q: Identify and describe the step-by-step procedure that is used to draw cable, as well as the…

A: It is asked to describe the step-by-step procedure that is used to draw cable and to install cable…

Q: What is RG rating of coaxial cable? Give detailed answer please

A:

Q: In terminating the coaxial cable, If the present procedure is to loosen up the braided shield and…

A: in terminating the coaxial cable, the previous procedure is  firstly we need to cut part of the…

Q: Airframe Electrical System What is minimum number of conductor strands required in aircraft quality…

A: Carbon steel or corrosion resistant steel wire are generally used in manufacturing of the aircraft…

Q: Draw the diagram of Twisted Pair Cable?

A: Twisted pair cable consists of two insulated copper wires which are twisted. This combination gains…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: Solution          Given data,                       R1 = ρLA, Where A=1…

Q: Explain the working of LVDT with neat diagram.

A: LVDT :  LVDT is divice which translates linear motion into electrical signal

Q: separable

A: Given that  Which of the following conductors in a typical separable connection plug and receptacle…

Q: 3. Which of the following statements about the use of structural steel as an equipment grounding…

A: We need to choose the correct option for the given question.

Q: What Cable Color-Coding is typically used for the Earth Wire in the Sultanate of Oman? A. GREEN AND…

A: Sultanate of Oman the following colour coding is used

Q: In terminating the coaxial cable, if the present procedure is to insert the BNC connector, length…

A: Important tools for making a coaxial cable: Compression tool Cable Stripper Compression Connectors…

Q: 16. Flexible metal conduit will be installed between a raceway and a transformer in a system. If…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: a)How do voids in the insulation cause breakdown of the cable? b)How do the various devices protect…

A: High voltage cables are used for the transmission and distribution purpose for electric power. In…

Q: Describe the various methods of laying underground cables. What are the relative advantages and…

A: Proper laying and attachment of fittings decide the reliability of underground cables. The fittings…

Q: 4.a. An intersystem bonding termination will typically be used as a ground junction for a/an A.…

A: Answer 4.(a) According to 214 NEC, Intersystem bonding method is only one bonding method permitted…

Q: 1. A wire used for wiring electric ranges, hot water heaters, stoves and hairdryers where both heat…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…